Date: Thu, 11 Apr 2002 18:11:15 -0700 From: "Marcus Beaman" <marcus.beaman@state.or.us> To: <freebsd-smp@freebsd.org> Subject: Another Motherboard Success Message-ID: <MMEPLEIAKBGICDPPJENCGECECBAA.marcus.beaman@state.or.us>
next in thread | raw e-mail | index | archive | help
I've successfully run SMP FreeBSD on an ASUS A7M266-D motherboard with a GENERIC.MP and custom(NETFLOW.MP) kernel. One important note, I had to set the motherboard to jumperfree mode (motherboard FSB is preset to operate at 133MHZ in regular jumper mode, and jumperfree mode allows processor setting via BIOS setup). If I did not have it in jumperfree mode, P0 processor would randomly hang with an unkillable process rendering it useless but the P1 processor continued to work and no syslog messages were generated. uname -a: FreeBSD xxx.xxx.xxx 4.5-RELEASE FreeBSD 4.5-RELEASE #0: Tue Mar 12 13:35:32 PST 2002 root@xxx.xxx.xxx:/usr/src/sys/compile/NETFLOW.MP i386 dmesg: Copyright (c) 1992-2002 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 4.5-RELEASE #0: Tue Mar 12 13:35:32 PST 2002 root@xxx.xxx.xxx:/usr/src/sys/compile/NETFLOW.MP Timecounter "i8254" frequency 1193182 Hz CPU: AMD Athlon(TM) XP 1900+ (1202.74-MHz 686-class CPU) Origin = "AuthenticAMD" Id = 0x662 Stepping = 2 Features=0x383fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV ,PAT,PSE36,MMX,FXSR,SSE> AMD Features=0xc0480000<<b19>,AMIE,DSP,3DNow!> real memory = 2147401728 (2097072K bytes) avail memory = 2088636416 (2039684K bytes) Programming 24 pins in IOAPIC #0 IOAPIC #0 intpin 2 -> irq 0 FreeBSD/SMP: Multiprocessor motherboard cpu0 (BSP): apic id: 0, version: 0x00040010, at 0xfee00000 cpu1 (AP): apic id: 1, version: 0x00040010, at 0xfee00000 io0 (APIC): apic id: 2, version: 0x00170011, at 0xfec00000 Preloaded elf kernel "kernel" at 0xc02fc000. Preloaded userconfig_script "/boot/kernel.conf" at 0xc02fc09c. Pentium Pro MTRR support enabled md0: Malloc disk Using $PIR table, 9 entries at 0xc00f1370 npx0: <math processor> on motherboard npx0: INT 16 interface pcib0: <Host to PCI bridge> on motherboard IOAPIC #0 intpin 16 -> irq 2 pci0: <PCI bus> on pcib0 pcib1: <PCI to PCI bridge (vendor=1022 device=700d)> at device 1.0 on pci0 pci1: <PCI bus> on pcib1 pci1: <Matrox MGA G550 AGP graphics accelerator> at 5.0 irq 2 isab0: <PCI to ISA bridge (vendor=1022 device=7440)> at device 7.0 on pci0 isa0: <ISA bus> on isab0 atapci0: <Generic PCI ATA controller> port 0xd800-0xd80f at device 7.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 chip1: <PCI to Other bridge (vendor=1022 device=7443)> at device 7.3 on pci0 ahc0: <Adaptec 29160 Ultra160 SCSI adapter> port 0xd400-0xd4ff mem 0xf6000000-0xf6000fff irq 2 at device 8.0 on pci0 aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/255 SCBs pcib2: <PCI to PCI bridge (vendor=1022 device=7448)> at device 16.0 on pci0 IOAPIC #0 intpin 18 -> irq 4 pci2: <PCI bus> on pcib2 pci2: <unknown card> (vendor=0x13f6, dev=0x0111) at 4.0 fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0xc400-0xc43f mem 0xf4800000-0xf481ffff,0xf5000000-0xf5000fff irq 4 at device 5.0 on pci2 fxp0: Ethernet address 00:02:b3:9e:f1:0c inphy0: <i82555 10/100 media interface> on miibus0 inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto orm0: <Option ROMs> at iomem 0xc0000-0xc8fff,0xd4000-0xd57ff on isa0 fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 fdc0: FIFO enabled, 8 bytes threshold fd0: <1440-KB 3.5" drive> on fdc0 drive 0 atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 sc0: <System console> at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> APIC_IO: Testing 8254 interrupt delivery APIC_IO: routing 8254 via IOAPIC #0 intpin 2 IP Filter: v3.4.20 initialized. Default = block all, Logging = enabled SMP: AP CPU #1 Launched! acd0: CDROM <TOSHIBA CD-ROM XM-5702B> at ata0-master using PIO3 Waiting 15 seconds for SCSI devices to settle Mounting root from ufs:/dev/da0s1a da0 at ahc0 bus 0 target 6 lun 0 da0: <IBM IC35L036UWD210-0 S5BS> Fixed Direct Access SCSI-3 device da0: 160.000MB/s transfers (80.000MHz, offset 63, 16bit), Tagged Queueing Enabled da0: 35003MB (71687340 512 byte sectors: 255H 63S/T 4462C) da1 at ahc0 bus 0 target 10 lun 0 da1: <IBM IC35L036UWD210-0 S5BS> Fixed Direct Access SCSI-3 device da1: 160.000MB/s transfers (80.000MHz, offset 63, 16bit), Tagged Queueing Enabled da1: 35003MB (71687340 512 byte sectors: 255H 63S/T 4462C) arplookup 210.115.233.67 failed: host is not on local network arplookup 210.115.233.67 failed: host is not on local network arplookup 210.115.233.67 failed: host is not on local network arplookup 210.115.233.67 failed: host is not on local network arplookup 210.115.233.67 failed: host is not on local network arplookup 210.115.233.67 failed: host is not on local network arplookup 66.3.24.131 failed: host is not on local network arplookup 66.3.24.131 failed: host is not on local network arplookup 66.3.24.131 failed: host is not on local network arplookup 66.3.24.131 failed: host is not on local network arplookup 65.42.42.82 failed: host is not on local network arplookup 65.42.42.82 failed: host is not on local network arplookup 65.42.42.82 failed: host is not on local network arplookup 65.42.42.82 failed: host is not on local network -Marcus ---------------------------------------------- Marcus Beaman DAS/IRMD/DVS Network Operations Analyst (503) 378-3627 hotline (503) 378-6408 work (503) 373-2871 pager -------------------------------------------- To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-smp" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?MMEPLEIAKBGICDPPJENCGECECBAA.marcus.beaman>