Date: Sat, 16 Feb 2002 02:46:08 +0100 From: "Alain Fabry" <alainfabry@hotmail.com> To: <cjclark@alum.mit.edu> Cc: <freebsd-questions@FreeBSD.ORG> Subject: Re: Beginner's question - Network problem Message-ID: <LAW2-OE57QopWUhSYSF000133cb@hotmail.com> References: <LAW2-OE32vAauNjVuMh00012e48@hotmail.com> <20020214161803.G36782@blossom.cjclark.org> <LAW2-OE27HbLUnR2A2g0001349c@hotmail.com> <20020215153141.X36782@blossom.cjclark.org>
next in thread | previous in thread | raw e-mail | index | archive | help
It's a Intel EtherExpress Pro 10+ ISA card
dmesg
Copyright (c) 1992-2001 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.4-RELEASE #0: Tue Sep 18 11:57:08 PDT 2001
murray@builder.FreeBSD.org:/usr/src/sys/compile/GENERIC
Timecounter "i8254" frequency 1193182 Hz
CPU: AMD-K6(tm) 3D processor (451.03-MHz 586-class CPU)
Origin = "AuthenticAMD" Id = 0x58c Stepping = 12
Features=0x8021bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,PGE,MMX>
AMD Features=0x80000800<SYSCALL,3DNow!>
real memory = 125763584 (122816K bytes)
avail memory = 117825536 (115064K bytes)
Preloaded elf kernel "kernel" at 0xc0480000.
K6-family MTRR support enabled (2 registers)
md0: Malloc disk
Using $PIR table, 5 entries at 0xc00f76e0
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
atapci0: <SiS 5591 ATA33 controller> port
0xffa0-0xffaf,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 irq 0 at
device 0.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
isab0: <SiS 85c503 PCI-ISA bridge> at device 1.0 on pci0
isa0: <ISA bus> on isab0
pci0: <unknown card> (vendor=0x1039, dev=0x0009) at 1.1
ohci0: <SiS 5571 USB controller> mem 0xeffff000-0xefffffff irq 9 at device
1.2 on pci0
usb0: OHCI version 1.0, legacy support
usb0: SMM does not respond, resetting
usb0: <SiS 5571 USB controller> on ohci0
usb0: USB revision 1.0
uhub0: SiS OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
pcib2: <PCI to PCI bridge (vendor=1039 device=0001)> at device 2.0 on pci0
pci1: <PCI bus> on pcib2
pci1: <SiS 530/620 SVGA controller> at 0.0
pci0: <unknown card> (vendor=0x13f6, dev=0x0100) at 12.0 irq 10
pcib1: <SiS 5591 host to AGP bridge> on motherboard
pci2: <PCI bus> on pcib1
orm0: <Option ROMs> at iomem 0xc0000-0xc7fff,0xc8000-0xcbfff,0xec000-0xeffff
on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 8250
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
ex: WARNING: board's EEPROM is configured for IRQ 0, using 5
ex0: <Intel PRO/10+ or compatible adapter> at port 0x200-0x20f iomem
0xcc000-0xcffff irq 5 on isa0
ex0: PnP config, 16-bit bus, board id 0xfff, stepping 0xf
ex0: Ethernet address ff:ff:ff:ff:ff:ff
ad0: 9787MB <QUANTUM FIREBALL CX10.2A> [19885/16/63] at ata0-master UDMA33
ad1: 8207MB <ST38641A> [16676/16/63] at ata0-slave UDMA33
acd0: CDROM <ATAPI 40X CDROM> at ata1-master using PIO4
Mounting root from ufs:/dev/ad0s1a
fd0c: hard error reading fsbn 0 of 0-3 (No status)
----- Original Message -----
From: "Crist J. Clark" <crist.clark@attbi.com>
To: "Alain Fabry" <alainfabry@hotmail.com>
Cc: <freebsd-questions@FreeBSD.ORG>
Sent: Saturday, February 16, 2002 12:31 AM
Subject: Re: Beginner's question - Network problem
> On Fri, Feb 15, 2002 at 08:49:22PM +0100, Alain Fabry wrote:
> [snip]
>
> > ex0: flags=843<UP,BROADCAST,RUNNING,SIMPLEX> mtu 1500
> > inet 10.0.0.1 netmask 0xffffff00 broadcast 10.0.0.255
> > ether ff:ff:ff:ff:ff:ff
> ^^^^^^^^^^^^^^^^^
> > media: Ethernet 10baseT/UTP
>
> Something is clearly broken here. What kind of card is this and what
> does your dmes(8) look like?
> --
> Crist J. Clark | cjclark@alum.mit.edu
> | cjclark@jhu.edu
> http://people.freebsd.org/~cjc/ | cjc@freebsd.org
>
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?LAW2-OE57QopWUhSYSF000133cb>