Skip site navigation (1)Skip section navigation (2)
Date:      Fri, 6 Apr 2001 14:13:16 -0700
From:      "R.P. Aditya" <aditya@grot.org>
To:        unsafe at any speed <erich@ucsd.edu>
Cc:        freebsd-mobile@FreeBSD.ORG
Subject:   Re: APM and NEC Versa 5060X
Message-ID:  <20010406141316.A57824@mighty.grot.org>
In-Reply-To: <3ACE2AE5.2030206@ucsd.edu>; from erich@ucsd.edu on Fri, Apr 06, 2001 at 01:45:25PM -0700
References:  <20010406133818.A57696@mighty.grot.org> <3ACE2AE5.2030206@ucsd.edu>

next in thread | previous in thread | raw e-mail | index | archive | help
On Fri, Apr 06, 2001 at 01:45:25PM -0700, unsafe at any speed wrote:
> Do you have apm_enable="YES" and apmd_enable="YES" in /etc/rc.conf?

yup. with no apmd_flags...

> What does it say about apm at boot time? (See `dmesg`.)

nothing...which is the problem (grin) (NETPUNK is a GENERIC derived kernel
which I built to reduce possible device conflicts with the same lines:

device apm
device pmtimer

) but I still get the same "non-recognition" as GENERIC. I also get other
annoying errors which might or may not be related.:

Copyright (c) 1992-2001 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #3: Thu Apr  5 15:45:07 PDT 2001
    root@:/usr/src/sys/compile/NETPUNK
Timecounter "i8254"  frequency 1193182 Hz
Timecounter "TSC"  frequency 166655877 Hz
CPU: Pentium/P55C (166.66-MHz 586-class CPU)
  Origin = "GenuineIntel"  Id = 0x543  Stepping = 3
  Features=0x8001bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,MMX>
real memory  = 67108864 (65536K bytes)
avail memory = 61030400 (59600K bytes)
Preloaded elf kernel "kernel" at 0xc0431000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc043109c.
Intel Pentium detected, installing workaround for F00F bug
Using $PIR table, 4 entries at 0xc00f5bf0
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <OPTi 82C700 host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
isab0: <PCI-ISA bridge> at device 1.0 on pci0
isa0: <ISA bus> on isab0
pci0: <display, VGA> at 2.0 (no driver attached)
pcic-pci0: <TI PCI-1131 PCI-CardBus Bridge> irq 9 at device 3.0 on pci0
pcic-pci0: TI113X PCI Config Reg: [speaker enable][CSC serial isa irq]
pcic-pci1: <TI PCI-1131 PCI-CardBus Bridge> irq 9 at device 3.1 on pci0
pcic-pci1: TI113X PCI Config Reg: [speaker enable][CSC serial isa irq]
ohci0: <OPTi 82C861 (FireLink) USB controller> at device 4.0 on pci0
ohci0: Could not map memory
device_probe_and_attach: ohci0 attach returned 6
atapci0: <Generic PCI ATA controller> port 0xfcf0-0xfcff at device 20.0 on pci0
atapci0: Busmastering DMA not supported
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model GlidePoint, device ID 0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
pcic0: <VLSI 82C146> at port 0x3e0 iomem 0xd0000 on isa0
pcic0: Polling mode
pccard0: <PC Card bus -- kludge version> on pcic0
pccard1: <PC Card bus -- kludge version> on pcic0
pmtimer0 on isa0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (ECP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/8 bytes threshold
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
unknown: <PNP0501> can't assign resources
unknown: <NEC90a1> can't assign resources
unknown: <PNP0401> can't assign resources
unknown: <PNP0700> can't assign resources
unknown: <> can't assign resources
sbc0: <ESS ES1869> at port 0x220-0x22f,0x388-0x38b,0x330-0x331 irq 5 drq 1,3 on isa0
pcm1: <ESS 18xx DSP> on sbc0
unknown: <PNP0303> can't assign resources
IP Filter: v3.4.16 initialized.  Default = pass all, Logging = enabled
ad0: 3909MB <IBM-DTCA-24090> [7944/16/63] at ata0-master BIOSPIO
Mounting root from ufs:/dev/ad0s1a
pccard: card inserted, slot 0
lp0: IPv6 not supported
wi0 at port 0x240-0x27f irq 10 slot 0 on pccard0
wi0: Ethernet address: 00:02:2d:20:38:70

Adi

> 
> R.P. Aditya wrote:
> 
> > I have 5.0 current from around March 23rd running on an NEC Versa 5060X laptop
> 
> > that has a Phoenix BIOS (NEC version "39") and pruported support for APM. The
> 
> > GENERIC kernel has "device apm" and booting with that, it doesn't seem that
> 
> > FreeBSD recognizes that the BIOS supports APM....
> 
> > 
> 
> > hints?
> 
> > 
> 
> > Thanks,
> 
> > Adi
> 
> > 
> 
> > To Unsubscribe: send mail to majordomo@FreeBSD.org
> 
> > with "unsubscribe freebsd-mobile" in the body of the message
> 

To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010406141316.A57824>