From owner-freebsd-scsi Tue Aug 21 20:49:52 2001 Delivered-To: freebsd-scsi@freebsd.org Received: from aslan.scsiguy.com (aslan.scsiguy.com [63.229.232.106]) by hub.freebsd.org (Postfix) with ESMTP id 79FA237B406 for ; Tue, 21 Aug 2001 20:49:49 -0700 (PDT) (envelope-from gibbs@scsiguy.com) Received: from scsiguy.com (localhost [127.0.0.1]) by aslan.scsiguy.com (8.11.5/8.11.5) with ESMTP id f7M3nkY06271; Tue, 21 Aug 2001 21:49:47 -0600 (MDT) (envelope-from gibbs@scsiguy.com) Message-Id: <200108220349.f7M3nkY06271@aslan.scsiguy.com> To: wguynes@mav.net Cc: freebsd-scsi@FreeBSD.ORG Subject: Re: sysinstall won't read drive, even though scsi controller is detected In-Reply-To: Your message of "Tue, 21 Aug 2001 20:25:56 CDT." <6a26otk39br425aoqeofiv9gt592hbet3h@smtp.prodigy.net> Date: Tue, 21 Aug 2001 21:49:46 -0600 From: "Justin T. Gibbs" Sender: owner-freebsd-scsi@FreeBSD.ORG Precedence: bulk List-ID: List-Archive: (Web Archive) List-Help: (List Instructions) List-Subscribe: List-Unsubscribe: X-Loop: FreeBSD.org >> 0xdf800000-0xdf800ff irq 10 at device 10.0 on pci0 >>aic7880: Wide Channel A, SCSI Id=15, 16/255 SCBs > >Please note that no "sa" device appears in boot output that I can >see. The aic7880 worries me a bit, but only because I'm not sure if >it should be there with ahc0. The aic7880 printf is correct. >After boot sequence. sysinstall begins. At this point, can you hit "Scoll Lock" and PgUP to see if there are any additional messages output by the ahc driver? You might also try one of the 4.4-RC floppies to see if a newer kernel probes your devices better. Full firmware information for the Baracudda would be good to know too. BTW, what aic7xxx driver version are you using under Mandrake? -- Justin To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-scsi" in the body of the message