Skip site navigation (1)Skip section navigation (2)
Date:      Tue, 20 Jun 2006 12:47:54 -0500
From:      Jim Bryant <enderw@chattingaway.com>
To:        freebsd-hackers@freebsd.org
Cc:        freebsd-net@freebsd.org, freebsd-sparc64@freebsd.org, freebsd-drivers@freebsd.org, freebsd-platforms@freebsd.org, freebsd-hardware@freebsd.org
Subject:   Problem: fpa(4) on sparc64 6.1-RELEASE
Message-ID:  <449834CA.2030005@chattingaway.com>

next in thread | raw e-mail | index | archive | help
I am getting a panic with a GENERIC with all non-available hardware 
drivers stripped out with "device fddi" and "device fpa" in the config.  
The only things I added to GENERIC after stripping out the unneeded 
things was the fddi, the sound, and the openfirmware.  The system boots 
fine with the fddi stuff commented out of the config.

Any suggestions?  Is anyone working on this?

Console log follows:
------------------------------------------------------------------------------------------------
screen not found.
Can't open input device.
Keyboard not present.  Using ttya for input and output.

SPARCengine(tm)Ultra(tm) AXi (UltraSPARC-IIi 300MHz), No Keyboard
OpenBoot 3.10.4 SME, 256 MB memory installed, Serial #10425242.
Ethernet address 8:0:20:9f:13:9a, Host ID: 809f139a.

Initializing Memory

ok boot
Boot device: disk:a  File and args:
 
 >> FreeBSD/sparc64 boot block
   Boot path:   /pci@1f,0/pci@1/scsi@1/disk@0,0:a
   Boot loader: /boot/loader
Consoles: Open Firmware console 

FreeBSD/sparc64 bootstrap loader, Revision 1.0
(root@s-dallas.cse.buffalo.edu, Sun May  7 07:03:17 UTC 2006)
bootpath="/pci@1f,0/pci@1/scsi@1/disk@0,0:a"
Loading /boot/defaults/loader.conf
/boot/kernel/kernel data=0x36b508+0x52e58 syms=[0x8+0x59a60+0x8+0x4af83]

Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [/boot/kernel/kernel] in 9 seconds... Booting 
[/boot/kernel/kernel] in 8 seconds...
Booting [/boot/kernel/kernel]...              
nothing to autoload yet.
jumping to kernel entry at 0xc0058000.
Copyright (c) 1992-2006 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 6.1-RELEASE #0: Tue Jun 20 02:01:14 CDT 2006
    root@ren.prodigy.net:/usr/obj/usr/src/sys/REN
Timecounter "tick" frequency 300008484 Hz quality 1000
real memory  = 268435456 (256 MB)
avail memory = 241123328 (229 MB)
cpu0: Sun Microsystems UltraSparc-IIi Processor (300.01 MHz CPU)
nexus0: <Open Firmware Nexus device>
pcib0: <U2P UPA-PCI bridge> on nexus0
pcib0: Sabre, impl 0, version 0, ign 0x7c0, bus A
pcib0: [FAST]
pcib0: [FAST]
pcib0: [GIANT-LOCKED]
pcib0: [GIANT-LOCKED]
pcib0 dvma: DVMA map: 0xc0000000 to 0xc3ffffff
pci0: <OFW PCI bus> on pcib0
pcib1: <APB PCI-PCI bridge> at device 1.1 on pci0
pci1: <OFW PCI bus> on pcib1
ebus0: <PCI-EBus2 bridge> mem 
0xf0000000-0xf0ffffff,0xf1000000-0xf17fffff at device 1.0 on pci1
auxio0: <Sun Auxiliary I/O> addr 
0x1400726000-0x1400726003,0x1400728000-0x1400728003,0x140072a000-0x140072a003,0x140072c000-0x140072c003,0x140072f000-0x140072f003 
on ebus0
ebus0: <power> addr 0x1400724000-0x1400724003 irq 37 (no driver attached)
ebus0: <SUNW,pll> addr 0x1400504000-0x1400504002 (no driver attached)
puc0: <Siemens SAB 82532 dual channel SCC> addr 
0x1400400000-0x140040007f irq 43 on ebus0
uart0: <SAB 82532 v3.2, channel A> on puc0
uart0: CTS oflow
uart0: console (38400,n,8,1)
uart1: <SAB 82532 v3.2, channel B> on puc0
uart1: CTS oflow
uart2: <16550 or compatible> addr 0x14003803f8-0x14003803ff irq 41 on ebus0
uart2: keyboard (1200,n,8,1)
uart2: keyboard not present
uart3: <16550 or compatible> addr 0x14003602f8-0x14003602ff irq 42 on ebus0
ebus0: <ecpp> addr 
0x1400340278-0x1400340287,0x140030015c-0x140030015d,0x1400700000-0x140070000f 
irq 34 (no driver attached)
ebus0: <fdthree> addr 
0x14003203f0-0x14003203f7,0x1400706000-0x140070600f,0x1400720000-0x1400720003 
irq 39 (no driver attached)
eeprom0: <EEPROM/clock> addr 0x1400000000-0x1400001fff on ebus0
eeprom0: model mk48t59
eeprom0: hostid 809f139a
ebus0: <flashprom> addr 0x1000000000-0x10000fffff (no driver attached)
ebus0: <beeper> addr 0x1400722000-0x1400722003 (no driver attached)
ebus0: <SUNW,rasctrl> addr 0x1400600000-0x1400600003 irq 40,37 (no 
driver attached)
hme0: <Sun HME 10/100 Ethernet> mem 0x40008000-0x4000ffff at device 1.1 
on pci1
miibus0: <MII bus> on hme0
nsphy0: <DP83840 10/100 media interface> on miibus0
nsphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
hme0: Ethernet address: 08:00:20:9f:13:9a
pcm0: <AudioPCI ES1373-B> port 0x800400-0x80043f at device 4.0 on pci1
pcm0: <TriTech TR28023 AC97 Codec>
pcm0: <Playback: DAC2 / Record: ADC>
pcib2: <APB PCI-PCI bridge> at device 1.0 on pci0
pci2: <OFW PCI bus> on pcib2
sym0: <875> port 0x400-0x4ff mem 0x1000-0x10ff,0x2000-0x2fff at device 
1.0 on pci2
sym0: No NVRAM, ID 7, Fast-20, SE, parity checking
sym0: [GIANT-LOCKED]
sym1: <875> port 0x800-0x8ff mem 0x3000-0x30ff,0x4000-0x4fff at device 
1.1 on pci2
sym1: No NVRAM, ID 7, Fast-20, SE, parity checking
sym1: [GIANT-LOCKED]
fpa0: <Digital DEFPA PCI FDDI Controller> port 0xc00-0xc7f mem 
0x5000-0x507f,0x10000-0x1ffff at device 2.0 on pci2
panic: trap: fast data access mmu miss
Uptime: 1s
Automatic reboot in 15 seconds - press a key on the console to abort
Rebooting...
Resetting ...




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?449834CA.2030005>