Date: Wed, 9 Feb 2000 18:26:23 -0800 From: Gunnar H Reichert-Weygold <gunnar@paganlibrary.com> To: freebsd-questions@FreeBSD.ORG Subject: Re: Sound Card - I give up! Message-ID: <00020918274902.00340@gunnar.my.domain> In-Reply-To: <00020819323300.00329@gunnar.my.domain> References: <00020819323300.00329@gunnar.my.domain>
next in thread | previous in thread | raw e-mail | index | archive | help
To all those who answered: THANK YOU!!! I set Pnp to OFF and it recognized immediately. Yes, I set the kernl to device pcm0 and left off the rest of the line. KDE sounds wonderful! Gunnar On Tue, 08 Feb 2000, Gunnar H Reichert-Weygold wrote: > I have a PCI PnP Awe64. > The kernel inlcudes: > > controller pnp0 # PnP support for ISA > device pcm0 at isa? port ? tty irq 10 drq 1 flags 0x0 > > The ouput from dmesg follows: > > Copyright (c) 1992-1999 FreeBSD Inc. > Copyright (c) 1982, 1986, 1989, 1991, 1993 > The Regents of the University of California. All rights reserved. > FreeBSD 3.4-RELEASE #0: Thu Feb 3 08:16:35 PST 2000 > root@gunnar.my.domain:/usr/src/sys/compile/FREEBIE > Timecounter "i8254" frequency 1193182 Hz > CPU: Pentium II/Xeon/Celeron (334.09-MHz 686-class CPU) > Origin = "GenuineIntel" Id = 0x651 Stepping = 1 > Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR> > real memory = 67108864 (65536K bytes) > avail memory = 61808640 (60360K bytes) > Preloaded elf kernel "kernel" at 0xc0349000. > Pentium Pro MTRR support enabled > Probing for devices on PCI bus 0: > chip0: <Intel 82443BX host to PCI bridge> rev 0x02 on pci0.0.0 > chip1: <Intel 82443BX host to AGP bridge> rev 0x02 on pci0.1.0 > chip2: <Intel 82371AB PCI to ISA bridge> rev 0x02 on pci0.7.0 > ide_pci0: <Intel PIIX4 Bus-master IDE controller> rev 0x01 on pci0.7.1 > uhci0: <Intel 82371AB/EB USB Host Controller> rev 0x01 int d irq 11 on pci0.7.2 > chip3: <Intel 82371AB Power management controller> rev 0x02 on pci0.7.3 > ncr0: <ncr 53c815 fast10 scsi> rev 0x04 int a irq 10 on pci0.15.0 > Probing for devices on PCI bus 1: > vga0: <ATI model 4c42 graphics accelerator> rev 0xdc int a irq 255 on pci1.0.0 > Probing for PnP devices: > CSN 1 Vendor ID: CTL009d [0x9d008c0e] Serial 0x00029c18 Comp ID: PNPb02f [0x2fb0d041] > This is a SB16 PnP, but LDN 0 is disabled > Probing for devices on the ISA bus: > sc0 on isa > sc0: VGA color <16 virtual consoles, flags=0x0> > ed0 not found at 0x280 > fe0 not found at 0x300 > atkbdc0 at 0x60-0x6f on motherboard > atkbd0 irq 1 on isa > psm0 irq 12 on isa > psm0: model ThinkingMouse, device ID 0 > sio0 at 0x3f8-0x3ff irq 4 flags 0x10 on isa > sio0: type 16550A > sio1 at 0x2f8-0x2ff irq 3 on isa > sio1: type 16550A > pcm0 not found > fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa > fdc0: FIFO enabled, 8 bytes threshold > fd0: 1.44MB 3.5in > wdc0 at 0x1f0-0x1f7 irq 14 on isa > wdc0: unit 0 (wd0): <ST34321A> > wd0: 4103MB (8404830 sectors), 8894 cyls, 15 heads, 63 S/T, 512 B/S > wdc0: unit 1 (wd1): <ST313032A> > wd1: 12419MB (25434228 sectors), 25232 cyls, 16 heads, 63 S/T, 512 B/S > wdc1 at 0x170-0x177 irq 15 on isa > wdc1: unit 0 (atapi): <CD-ROM 48X/AKU/U23>, removable, intr, dma, iordis > acd0: drive speed 0 - 8250KB/sec, 128KB cache > acd0: supported read types: CD-DA > acd0: Audio: play, 255 volume levels > acd0: Mechanism: ejectable tray > acd0: Medium: CD-ROM 120mm data disc loaded, unlocked > wdc1: unit 1 (atapi): <CRW6206A/1.2A>, removable, dma, iordy > acd1: drive speed 1034KB/sec, 384KB cache > acd1: supported read types: CD-R, CD-RW, CD-DA, packet track > acd1: supported write types: CD-R, CD-RW, test write > acd1: Audio: play, 128 volume levels > acd1: Mechanism: ejectable tray > acd1: Medium: CD-RW blank medium, unlocked, lock protected > ppc0 at 0x378 irq 7 flags 0x40 on isa > ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode > ppb0: IEEE1284 device found /NIBBLE > Probing for PnP devices on ppbus0: > ppbus0: <Hewlett-Packard HP LaserJet 6L/0101.01> PRINTER HP ENHANCED PCL5,PJL > lpt0: <generic printer> on ppbus 0 > lpt0: Interrupt-driven port > ppi0: <generic parallel i/o> on ppbus 0 > plip0: <PLIP network interface> on ppbus 0 > ie0: unknown board_id: f000 > ie0 not found at 0x300 > ep0 not found at 0x300 > ex0 not found > le0 not found at 0x300 > lnc0 not found at 0x280 > cs0 not found at 0x300 > ze0 not found at 0x300 > zp0 not found at 0x300 > vga0 at 0x3b0-0x3df maddr 0xa0000 msize 131072 on isa > npx0 on motherboard > npx0: INT 16 interface > joy0 at 0x201 on isa > joy0: joystick > usb0: <Intel 82371AB/EB USB Host Controller> > uhub0 at usb0 > uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 > uhub0: 2 ports with 2 removable, self powered > ugen0 > ugen0: Vision VC6452V002 Camera, rev 1.00/1.00, addr 2 > ugen1 > ugen1: Color FlatbedScanner 5, rev 1.00/1.21, addr 3 > Waiting 15 seconds for SCSI devices to settle > sa0 at ncr0 bus 0 target 4 lun 0 > sa0: <CONNER CTT8000-S 1.22> Removable Sequential Access SCSI-2 device > sa0: 6.944MB/s transfers (6.944MHz, offset 8) > changing root device to wd1s1a > > > Since I've grayed too much hair on this one, what are your > personal recommendations for a new sound card that you know works? > > > -- > I used to be self-actualized, now I'm just confused. > > Gunnar H Reichert-Weygold > The Pagan Library > http://www.paganlibrary.com > > > To Unsubscribe: send mail to majordomo@FreeBSD.org > with "unsubscribe freebsd-questions" in the body of the message -- I used to be self-actualized, now I'm just confused. Gunnar H Reichert-Weygold The Pagan Library http://www.paganlibrary.com To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?00020918274902.00340>