From owner-freebsd-smp Fri Aug 13 15:18:55 1999 Delivered-To: freebsd-smp@freebsd.org Received: from vip.consys.com (VIP.ConSys.COM [209.141.107.6]) by hub.freebsd.org (Postfix) with ESMTP id 5182614E8A for ; Fri, 13 Aug 1999 15:18:50 -0700 (PDT) (envelope-from rcarter@pinyon.org) Received: (from pinyon@localhost) by vip.consys.com (8.9.3/8.9.1) id PAA57570 for freebsd-smp@freebsd.org; Fri, 13 Aug 1999 15:19:05 -0700 (MST) Date: Fri, 13 Aug 1999 15:19:05 -0700 (MST) From: "Russell L. Carter" Message-Id: <199908132219.PAA57570@vip.consys.com> To: freebsd-smp@freebsd.org Subject: Odd swap stats in today's current Sender: owner-freebsd-smp@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.org Howdy, I updated an SMP box from a month old current today, and now it seems to think that it wants to swap to wd drives. I don't have any wd drives... Other than that it seems to be running fine, but I don't think it's tried to swap yet, that'll be happening soon enough :-) Maybe this is an off-by-one glitch? Cheers, Russell Here's swapinfo, there should be a da1s1b partition also: rcarter@mazatzal:/var/run [158] swapinfo Device 1K-blocks Used Avail Capacity Type /dev/da0s1b 524160 1900 522260 0% Interleaved /dev/wd0b 850457216 849934976 522240 100% Interleaved /dev/wd0a -128 -128 0 100% Interleaved /dev/wd0a 90483584 90483584 0 100% Interleaved Total 941464832 940420332 1044500 100% And here's the fstab: rcarter@mazatzal:/sys/i386/conf [172] cat /etc/fstab # Device Mountpoint FStype Options Dump Pass# /dev/da0s1b none swap sw 0 0 /dev/da1s1b none swap sw 0 0 /dev/da0s1a / ufs rw 1 1 /dev/da1s1e /u1 ufs rw 2 2 /dev/da1s1f /u2 ufs rw 2 2 /dev/da0s1f /usr ufs rw 2 2 /dev/da0s1e /var ufs rw 2 2 proc /proc procfs rw 0 0 rcarter@mazatzal:/sys/i386/conf [173] And the relevant pieces of the kernel config: controller isa0 controller pnp0 # PnP support for ISA controller eisa0 controller pci0 controller fdc0 at isa? port IO_FD1 irq 6 drq 2 disk fd0 at fdc0 drive 0 disk fd1 at fdc0 drive 1 #controller wdc0 at isa? port IO_WD1 irq 14 #disk wd0 at wdc0 drive 0 #disk wd1 at wdc0 drive 1 #controller wdc1 at isa? port IO_WD2 irq 15 #disk wd2 at wdc1 drive 0 #disk wd3 at wdc1 drive 1 # ATAPI devices on wdc? #device wcd0 #IDE CD-ROM #device wfd0 #IDE Floppy (e.g. LS-120) #device wst0 #IDE Tape (e.g. Travan) And the dmesg.boot: (no wd drives here, either) Copyright (c) 1992-1999 The FreeBSD Project. Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. FreeBSD 4.0-CURRENT #9: Wed Jul 14 19:33:48 MST 1999 rcarter@mazatzal.consys.com:/usr/src/sys/compile/CURRENT Timecounter "i8254" frequency 1193182 Hz CPU: Pentium II/Xeon/Celeron (686-class CPU) Origin = "GenuineIntel" Id = 0x652 Stepping = 2 Features=0x183fbff real memory = 536870912 (524288K bytes) avail memory = 519004160 (506840K bytes) Programming 24 pins in IOAPIC #0 FreeBSD/SMP: Multiprocessor motherboard cpu0 (BSP): apic id: 0, version: 0x00040011, at 0xfee00000 cpu1 (AP): apic id: 1, version: 0x00040011, at 0xfee00000 io0 (APIC): apic id: 2, version: 0x00170011, at 0xfec00000 Preloaded elf kernel "kernel" at 0xc02e7000. Pentium Pro MTRR support enabled, default memory type is uncacheable Probing for PnP devices: npx0: on motherboard npx0: INT 16 interface pcib0: on motherboard pci0: on pcib0 chip0: at device 0.0 on pci0 pcib1: at device 1.0 on pci0 pci1: on pcib1 isab0: at device 7.0 on pci0 chip1: at device 7.1 on pci0 chip2: at device 7.2 on pci0 chip3: at device 7.3 on pci0 pcib2: at device 16.0 on pci0 pci2: on pcib2 vx0: <3COM 3C590 Etherlink III PCI> irq 18 at device 6.0 on pci2 utp/aui/bnc[*utp*]: disable 'auto select' with DOS util! address 00:a0:24:c9:f9:63 fxp0: irq 19 at device 17.0 on pci0 fxp0: Ethernet address 00:e0:81:10:29:d1 ahc0: irq 16 at device 18.0 on pci0 ahc0: aic7895 Wide Channel A, SCSI Id=7, 16/255 SCBs ahc1: irq 16 at device 18.1 on pci0 ahc1: aic7895 Wide Channel B, SCSI Id=7, 16/255 SCBs isa0: on motherboard fdc0: at port 0x3f0-0x3f7 irq 6 drq 2 on isa0 fdc0: FIFO enabled, 8 bytes threshold fd0: <1440-KB 3.5" drive> at fdc0 drive 0 atkbdc0: at port 0x60-0x6f on isa0 atkbd0: irq 1 on atkbdc0 vga0: at port 0x3b0-0x3df iomem 0xa0000-0xbffff on isa0 sc0: on isa0 sc0: VGA <16 virtual consoles, flags=0x200> sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 16550A sio1: configured irq 3 not in bitmap of probed irqs 0 APIC_IO: Testing 8254 interrupt delivery APIC_IO: routing 8254 via pin 2 vx0 XXX: driver didn't set ifq_maxlen Waiting 15 seconds for SCSI devices to settle SMP: AP CPU #1 Launched! changing root device to da0s1a da1 at ahc1 bus 0 target 6 lun 0 da1: Fixed Direct Access SCSI-2 device da1: 40.000MB/s transfers (20.000MHz, offset 8, 16bit), Tagged Queueing Enabled da1: 4357MB (8925000 512 byte sectors: 255H 63S/T 555C) da0 at ahc0 bus 0 target 3 lun 0 da0: Fixed Direct Access SCSI-2 device da0: 40.000MB/s transfers (20.000MHz, offset 8, 16bit), Tagged Queueing Enabled da0: 4357MB (8925000 512 byte sectors: 255H 63S/T 555C) [end...] To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-smp" in the body of the message