Date: Sun, 19 Jul 1998 23:25:06 -0700 From: "robert t tan" <rotan@cs.pdx.edu> To: "scsi" <scsi@FreeBSD.ORG> Cc: <rotan@cs.pdx.edu> Subject: AHA-2940UW Message-ID: <199807200625.XAA26761@rigel.cs.pdx.edu>
next in thread | raw e-mail | index | archive | help
Hi, Need help with the following, please: This is my configuration: Terminated, 2G Western Digital Wide SCSI hard drive ( 16 bit), Terminated 12/20 Plexter CDROM ( 8 bit ) SCSI. AHA-2940UW SCSI host adapter Micron Millenia board. Besided the controller card there is just the video card. Sync and Disconnect are both disabled for all the devices in the SCSI chain ( hard drive, CDROM, and controller ). Mother Board BIOS: Phoenix v4.04 Host adapter BIOS: v1.32 PNP is disabled. Partitions: Primary active DOS partition: 250M win95 Rest: Unused. I have a problem when booting FreeBSD with the install floppy: /RELEASE2.2.6/updates/boot.flp, see below for boot dmesg output By the way WIN95 runs fine, and had FreeBSD runing when I used a buslogic controler on a regular SCSI drive ( 2G ) Have tried the following: - Disconnecting the CDROM. - Taking out the controller and booting untill "No Operating System", then rebooting again. - Moving the controller to different PCI slots. - Sync, and disconnect enabled. - Searching around for this problem on the net. Below: >> Mouse IRQ12: enabled Interrupt Routing: A: disabled, B: disabled, C: IRQ15, D: IRQ11 MB0: disabled, MB1: disabled chip2 <Intel 83371FB IDE interface> rev 1 int a irq 11 on pci0:17:0 mapreg[10] type = 1 addr = 0000fc00 size = 0100 mapreg[14] type = 0 addr = f0dff000 size = 1000 reg16: ioaddr = 0xfc00 size 0x100 ahc0: reading SEEPROM ... done internal 50 cable is present internal 68 cable is present brdctl == 0x2c external cable not present eprom is present brdctl == 0xcc low byte termination disabled, high byte termination enabled ahc0: aic7880 Wide Channel, SCSI Id = 7, 116 SCBs ahc0: Downloading Sequencer program ... ahc: 373 instructions downloaded Done ahc0: Probing channel A ahc0: Waiting for scsi devices to settle achc0: board is not responding (ahc0:0:0): SCB 0x0 - timed out while idle, LASTPHASE == 0x01 SCSISIGI == 0x0 SEQADDR = 0x166 SCSISEQ = 0x12 SSTAT0 = 0x4 SSTAT1 = 0x8 (ahc0:0:0) Queueing an abort SCB ahc:0 board is not responding cmd fail (ahc0:0:0) SCB 0x1 timed out while recovery in progress (ahc0:0:0) "Unknown unknown ????" type 13 fixed SCSI 0 uk0(ahc0:0:0): Unknown ahc0: board is not responding ..... << Thanks, robert t tan To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-scsi" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199807200625.XAA26761>