Date: Fri, 14 Apr 1995 20:49:26 -0700 From: "Justin T. Gibbs" <gibbs@estienne.CS.Berkeley.EDU> To: Bob Dunaway <bob@rdsw.com> Cc: freebsd-questions@FreeBSD.org Subject: Re: Archive DAT SCSI problem Message-ID: <199504150349.UAA01031@estienne.cs.berkeley.edu> In-Reply-To: Your message of "Fri, 14 Apr 1995 22:17:55 CDT." <199504150317.WAA18596@rdsw.com>
next in thread | previous in thread | raw e-mail | index | archive | help
>> The dmesg output came from the -current aic7xxx driver? Just to make sure, >> can you try the 4/12 SNAP snapshot disks out (incase you didn't grab all >> of the required files). If this is the -current code, it looks like a >> syncronous negotiation problem. We should never allow negotiation above >> 15. >> >> > >> >Thanks >> >bob@rdsw.com >> >The dmesg output came from the 950322-SNAP as released. I had seen the same >results with the new aic7000 driver and sequencer. Mark Hittenger suggested >that I might need a tape loaded in the drive during boot. Although I had >tried that several days ago, I tried it again with the new driver and it >booted just fine. I was able to make a full backup. I had not tried the >complete 950412-SNAP because I was concerned that the new sliver disk >partitioning was part of that release, but I read tonight that it is not, >so I may try it now. >Thanks >Bob Dunaway >bob@rdsw.com I will take a look at the syncronous negotiation code again now, but there were some patches in this area after the 322-SNAP. Can you give me dmesg output (in private mail) both with and without the tape installed? -- Justin T. Gibbs ============================================== TCS Instructional Group - Programmer/Analyst 1 Cory | Po | Danube | Volga | Parker | Torus ==============================================
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199504150349.UAA01031>