Date: Tue, 30 Nov 99 18:35:03 +0100 From: David Wetzel <dave@turbocat.de> To: ISDN-List <freebsd-isdn@FreeBSD.ORG> Cc: garyj@muc.de Subject: Fritz! on NetBSD? Message-ID: <199911301735.SAA00472@cat.turbocat.de>
next in thread | raw e-mail | index | archive | help
Hi Folks,
I build a kernel for a new box:
(....)
options AVM_A1_PCI # AVM Fritz!Card (PCI Version)
isic* at pci?
##################
# ISDN user land devices, drivers and pseudo-devices.
# All these are needed, but you may adjust the count of the
# pseudo-devices.
#
pseudo-device "i4b"
# userland driver to do ISDN tracing
pseudo-device "i4btrc" 2
# userland driver to control the whole thing
pseudo-device "i4bctl"
# userland driver for access to raw B channel
pseudo-device "i4brbch" 4
# userland driver for telephony
pseudo-device "i4btel" 2
# network driver for IP over raw HDLC ISDN
options IPR_VJ # compile support for VJ compression
pseudo-device "i4bipr" 2
# synchronous PPP over ISDN
pseudo-device i4bisppp 2
this happens, when I boot:
orange# dmesg
NetBSD 1.4.1 (OVERKILL) #1: Tue Nov 30 17:01:06 PST 1999
root@orange:/usr/src/sys/arch/i386/compile/OVERKILL
cpu0: family 6 model 7 step 3
cpu0: Intel Pentium III (686-class)
real mem = 133758976
avail mem = 122376192
using 1658 buffers containing 6791168 bytes of memory
mainbus0 (root)
pci0 at mainbus0 bus 0: configuration mode 1
pci0: i/o enabled, memory enabled
pchb0 at pci0 dev 0 function 0
pchb0: Intel 82443BX Host Bridge/Controller (rev. 0x03)
Intel 82443BX AGP Interface (PCI bridge, revision 0x03) at pci0 dev 1
function 0 not configured
pcib0 at pci0 dev 7 function 0
pcib0: Intel 82371AB PCI-to-ISA Bridge (PIIX4) (rev. 0x02)
Intel 82371AB IDE controller (PIIX4) (IDE mass storage, interface 0x80,
revision 0x01) at pci0 dev 7 function 1 not configured
Intel 82371AB USB Host Controller (PIIX4) (USB serial bus, revision 0x01) at
pci0 dev 7 function 2 not configured
Intel 82371AB Power Management Controller (PIIX4) (miscellaneous bridge,
revision 0x02) at pci0 dev 7 function 3 not configured
isic0 at pci0 dev 8 function 0: Fritz!Card
isic0: ISAC 2085 Version A1/A2 or 2086/2186 Version 1.1 (IOM-2)
isic0: interrupting at irq 11
de0 at pci0 dev 9 function 0
de0: interrupting at irq 10
de0: 21143 [10-100Mb/s] pass 4.1 (invalid EESPROM checksum)
de0: address 00:40:c7:99:66:42
ncr0 at pci0 dev 10 function 0: ncr 53c895 fast40 wide scsi
ncr0: interrupting at irq 5
ncr0: minsync=10, maxsync=137, maxoffs=31, 128 dwords burst, large dma fifo
ncr0: single-ended, open drain IRQ driver, using on-chip SRAM
ncr0: restart (scsi reset).
scsibus0 at ncr0: 16 targets, 8 luns per target
sd0 at scsibus0 targ 0 lun 0: <IBM, DDRS-34560D, DC1B> SCSI2 0/direct fixed
sd0(ncr0:0:0): WIDE SCSI (16 bit) enabled
sd0(ncr0:0:0): 40.0 MB/s (50 ns, offset 15)
sd0: 4357MB, 8387 cyl, 5 head, 212 sec, 512 bytes/sect x 8925000 sectors
isa0 at pcib0
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo
npx0 at isa0 port 0xf0-0xff: using exception 16
pc0 at isa0 port 0x60-0x6f irq 1: color
pc0: console
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB, 80 cyl, 2 head, 18 sec
biomask 60 netmask c60 ttymask c62
i4b: ISDN call control device attached
i4btrc: 2 ISDN trace device(s) attached
i4bctl: ISDN system control port attached
i4brbch: 4 raw B channel access device(s) attached
i4btel: 2 ISDN telephony interface device(s) attached
i4bipr: 2 IP over raw HDLC ISDN device(s) attached (VJ header compression)
i4bisppp: 2 ISDN SyncPPP device(s) attached
de0: enabling 10baseT port
boot device: sd0
root on sd0a dumps on sd0b
Looks good, but:
orange# isdnd
orange# Nov 30 17:31:23 orange isdnd[224]: ERR main: cannot open /dev/i4b:
Operation not supported by device
To compile the kernel, I Did this (fingers crossed):
orange# cc -g -O2 -Wall -Wmissing-prototypes -Wstrict-prototypes
-Wpointer-arith -Wno-main -I. -I../../../../arch -I../../../.. -nostdinc
-DSHMMAXPGS="0x400" -DFIFO -DNMBCLUSTERS="0x800" -DAVM_A1_PCI -DIPR_VJ
-DMAXUSERS=64 -D_KERNEL -Di386 -c ../../../../i4b/layer1/i4b_avm_fritz_pci.c
../../../../i4b/layer1/i4b_avm_fritz_pci.c: In function `avma1pp_hscx_intr':
../../../../i4b/layer1/i4b_avm_fritz_pci.c:1203: warning: implicit
declaration of function `isic_hscx_fifo'
../../../../i4b/layer1/i4b_avm_fritz_pci.c: At top level:
../../../../i4b/layer1/i4b_avm_fritz_pci.c:1655: warning: no previous
prototype for `isic_hscx_fifo'
../../../../i4b/layer1/i4b_avm_fritz_pci.c:144: warning: `avma1pp_fifo'
declared `static' but never defined
Has somebody else found this problem?
---
_ _
_(_)(_)_ David Wetzel, Turbocat's Development,
(_) __ (_) Buchhorster Strasse, D-16567 Muehlenbeck/Berlin, FRG,
_/ \_ Fax +49 33056 82835 NeXTmail dave@turbocat.de
(______) http://www.turbocat.de/
DEVELOPMENT * CONSULTING * ADMINISTRATION
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-isdn" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199911301735.SAA00472>