Date: Thu, 12 Nov 1998 23:04:41 +0100 From: npe@bfc.dk To: freebsd-smp@FreeBSD.ORG Subject: Panic while booting SMP on a Compaq Proliant 1600 Dual P2 - 350 Message-ID: <412566BA.007919FB.00@bfc.dk>
next in thread | raw e-mail | index | archive | help
When booting GENERIC-SMP kernel my system panics with the following :
---------------------------------------------
....
avail memory = 258138112 (252088K bytes)
panic assign_apic_irq: inconsistent table
mp_lock = 00000001; cpuid = 0; lapic.id = 01000000
Debugger("Panic")
Stopped at _Debugger+0x35: movb $0,_in_Debugger.98
....
------------cut---------------------------------
Help !
Regards,
Nicolai Petri
WM-Data BFC - Denmark
--------------------------------------------------
DMESG :
Copyright (c) 1992-1998 FreeBSD Inc.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 3.0-RELEASE #0: Sat Oct 17 17:45:06 GMT 1998
jkh@kickme.freebsd.org:/usr/src/sys/compile/GENERIC
Timecounter "i8254" frequency 1193182 Hz cost 3031 ns
Timecounter "TSC" frequency 349436359 Hz cost 140 ns
CPU: Pentium II (quarter-micron) (349.44-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x651 Stepping=1
Features=0x183fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA
,CMOV,PAT,PSE36,MMX,<b24>>
real memory = 16777216 (16384K bytes)
avail memory = 13918208 (13592K bytes)
eisa0: <CPQ689 (System Board)>
Probing for devices on the EISA bus
Probing for devices on PCI bus 0:
chip0: <Intel 82443BX host to PCI bridge (AGP disabled)> rev 0x02 on
pci0.0.0
vga0: <Cirrus Logic GD5446 SVGA controller> rev 0x45 on pci0.11.0
chip1: <PCI to PCI bridge (vendor=1011 device=0022)> rev 0x03 on pci0.13.0
chip2: <IBM 82351 PCI-PCI bridge> rev 0x07 on pci0.16.0
chip3: <Intel 82371AB PCI to ISA bridge> rev 0x02 on pci0.20.0
ide_pci0: <Intel PIIX4 Bus-master IDE controller> rev 0x01 on pci0.20.1
chip4: <Intel 82371AB USB host controller> rev 0x01 int d irq 0 on
pci0.20.2
chip5: <Intel 82371AB Power management controller> rev 0x02 on pci0.20.3
Probing for devices on PCI bus 1:
tl0: <Compaq Netelligent 10/100 Proliant> rev 0x10 int a irq 5 on pci1.7.0
tl0: Ethernet address: 00:80:5f:c7:e1:95
tl0: autoneg complete, link status good (half-duplex, 100Mbps)
ncr0: <ncr 53c875 fast20 wide scsi> rev 0x14 int a irq 9 on pci1.9.0
ncr1: <ncr 53c875 fast20 wide scsi> rev 0x14 int b irq 10 on pci1.9.1
chip6: <PCI to PCI bridge (vendor=1011 device=0024)> rev 0x03 on pci1.13.0
Probing for devices on PCI bus 2:
fxp0: <Intel EtherExpress Pro 10/100B Ethernet> rev 0x05 int a irq 11 on
pci2.4.0
fxp0: Ethernet address 00:08:c7:d2:1d:bf
fxp1: <Intel EtherExpress Pro 10/100B Ethernet> rev 0x05 int a irq 15 on
pci2.5.0
fxp1: Ethernet address 00:08:c7:d2:1d:c0
Probing for devices on PCI bus 3:
Probing for devices on the ISA bus:
sc0 at 0x60-0x6f irq 1 on motherboard
sc0: VGA color <16 virtual consoles, flags=0x0>
ed0 not found at 0x280
fe0 not found at 0x300
sio0 at 0x3f8-0x3ff irq 4 flags 0x10 on isa
sio0: type 16550A
sio1 at 0x2f8-0x2ff irq 3 on isa
sio1: type 16550A
lpt0 at 0x3bc-0x3c3 irq 7 on isa
lpt0: Interrupt-driven port
lp0: TCP/IP capable interface
psm0 not found at 0x60
fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
fdc0: FIFO enabled, 8 bytes threshold
fd0: 1.44MB 3.5in
wdc0 at 0x1f0-0x1f7 irq 14 on isa
wdc0: unit 0 (atapi): <Compaq CRD-8241B/1.17>, removable, accel, dma,
iordis
wcd0: 171/4125Kb/sec, 128Kb cache, audio play, 255 volume levels, ejectable
tray
wcd0: door open, unlocked, lock protected
wdc1 not found at 0x170
wt0 not found at 0x300
mcd0 not found at 0x300
matcdc0 not found at 0x230
scd0 not found at 0x230
ie0: unknown board_id: f000
ie0 not found at 0x300
ep0 not found at 0x300
ex0 not found
le0 not found at 0x300
lnc0 not found at 0x280
ze0 not found at 0x300
zp0 not found at 0x300
cs0 not found at 0x300
adv0 not found at 0x330
bt0 not found at 0x134
aha0 not found at 0x134
npx0 on motherboard
npx0: INT 16 interface
Waiting 15 seconds for SCSI devices to settle
changing root device to da0s1a
da0 at ncr1 bus 0 target 0 lun 0
da0: <COMPAQ HD00431731 3207> Fixed Direct Access SCSI2 device
da0: 40.0MB/s transfers (20.0MHz, offset 15, 16bit), Tagged Queueing
Enabled
da0: 4094MB (8386000 512 byte sectors: 255H 63S/T 522C)
===========================================================================
====
MPTable, version 2.0.15
---------------------------------------------------------------------------
----
MP Floating Pointer Structure:
location: BIOS
physical address: 0x000f4ff0
signature: '_MP_'
length: 16 bytes
version: 1.4
checksum: 0xcd
mode: Virtual Wire
---------------------------------------------------------------------------
----
MP Config Table Header:
physical address: 0x000fc400
signature: 'PCMP'
base table length: 436
version: 1.4
checksum: 0x6d
OEM ID: 'COMPAQ '
Product ID: 'PROLIANT '
OEM table pointer: 0x00000000
OEM table size: 0
entry count: 46
local APIC address: 0xfee00000
extended table length: 76
extended table checksum: 86
---------------------------------------------------------------------------
----
MP Config Base Table Entries:
--
Processors: APIC ID Version State Family Model Step
Flags
1 0x10 BSP, usable 6 5 1 0x183fbff
0 0x10 AP, usable 6 5 1 0x183fbff --
Bus: Bus ID Type
0 PCI
1 PCI
9 ISA --
I/O APICs: APIC ID Version State Address
8 0x11 usable 0xfec00000 --
I/O Ints: Type Polarity Trigger Bus ID IRQ APIC ID PIN#
INT active-lo level 1 9:A 8 23
INT active-lo level 1 9:B 8 22
INT active-lo level 1 7:A 8 30
INT active-lo level 1 13:A 8 18
INT active-lo level 1 13:C 8 18
INT active-lo level 1 13:B 8 26
INT active-lo level 1 13:D 8 26
INT active-lo level 1 11:A 8 17
INT active-lo level 1 11:C 8 17
INT active-lo level 1 11:B 8 25
INT active-lo level 1 11:D 8 25
INT active-lo level 1 10:A 8 16
INT active-lo level 1 10:C 8 16
INT active-lo level 1 10:B 8 24
INT active-lo level 1 10:D 8 24
INT active-lo level 0 18:A 8 21
INT active-lo level 0 18:C 8 21
INT active-lo level 0 18:B 8 29
INT active-lo level 0 18:D 8 29
INT active-lo level 0 16:A 8 20
INT active-lo level 0 16:C 8 20
INT active-lo level 0 16:B 8 28
INT active-lo level 0 16:D 8 28
INT active-lo level 0 15:A 8 19
INT active-lo level 0 15:C 8 19
INT active-lo level 0 15:B 8 27
INT active-lo level 0 15:D 8 27
INT active-hi edge 9 1 8 1
INT active-hi edge 9 0 8 2
INT active-hi edge 9 3 8 3
INT active-hi edge 9 4 8 4
INT active-hi edge 9 6 8 6
INT active-hi edge 9 7 8 7
INT active-hi edge 9 8 8 8
INT active-hi edge 9 12 8 12
INT active-lo edge 9 13 8 13
INT active-hi edge 9 14 8 14
--
Local Ints: Type Polarity Trigger Bus ID IRQ APIC ID PIN#
ExtINT conforms conforms 9 0 255
0
NMI conforms conforms 9 0 255 1
---------------------------------------------------------------------------
----
MP Config Extended Table Entries:
Extended Table HOSED!
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-smp" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?412566BA.007919FB.00>