Date: Mon, 9 Jan 1995 17:12:54 +0000 () From: Jeff Carr <jcarr@freedom.wit.com> To: questions@FreeBSD.org Subject: problems installing 2.0 Message-ID: <199501091712.RAA02678@freedom.wit.com>
next in thread | raw e-mail | index | archive | help
We are using Freebsd 2.0 to run our site www.wit.com. We have purchased another machine to take some of the load of our single machine, it is a 486/66 with an Adaptec 2842VL scsi card and a 3com 3C509 Etherlink III ethernet card. While trying to install 2.0 with the newest boot_144 floppy, I get the following: wt0 not found at 0x300 mcd0: timeout getting status mcd0: not found at 0x300 mcd1: timeount getting status mcd1 not found at 0x340 ie0 not found at 0x360 1 3C5x9 board(s) on ISA found at 0x300 ep0 at 0x300-0x30f irq 10 on isa ep0: aui/bnc[*BNC*] address 00:20:af:15:e4:9b is0 not found at 0x200 le0 not probed due to I/O address conflict with ep0 at 0x300 ze0 not probed due to I/O address conflict with ep0 at 0x300 npx0 on motherboard changing root device to fd0c Fatal trap 9: general protection fault while in kernal mode instruction pointer = 0x8:0xf015fda0 code segment = base 0x0, limit 0xffffff, type 0x1b = DPL 0, pres 1, def32 1, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = 0 () inturrupt mask = panic: general protection fault hit reset please any ideas? I'll make an attempt to get different hardware if that is the problem. I'd be forever in debt if someone could help me out on this. jcarr@wit.com
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199501091712.RAA02678>