From owner-freebsd-current Sat May 19 7: 5:58 2001 Delivered-To: freebsd-current@freebsd.org Received: from isbalham.ist.co.uk (isbalham.ist.co.uk [192.31.26.1]) by hub.freebsd.org (Postfix) with ESMTP id 875CA37B422 for ; Sat, 19 May 2001 07:05:34 -0700 (PDT) (envelope-from rb@gid.co.uk) Received: (from uucp@localhost) by isbalham.ist.co.uk (8.11.1/8.11.1) with UUCP id f4JE5RE15847 for current@freebsd.org; Sat, 19 May 2001 15:05:27 +0100 (BST) (envelope-from rb@gid.co.uk) Received: from [194.32.164.2] (eccles [194.32.164.2]) by seagoon.gid.co.uk (8.9.3/8.9.3) with ESMTP id OAA11304 for ; Sat, 19 May 2001 14:53:58 +0100 (BST) (envelope-from rb@gid.co.uk) X-Sender: rb@194.32.164.1 Message-Id: Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Date: Sat, 19 May 2001 14:53:57 +0100 To: current@freebsd.org From: Bob Bishop Subject: panic: workitem_free: still on list Sender: owner-freebsd-current@FreeBSD.ORG Precedence: bulk List-ID: List-Archive: (Web Archive) List-Help: (List Instructions) List-Subscribe: List-Unsubscribe: X-Loop: FreeBSD.ORG Hi, This happened during a buildworld with a kernel built from: cvsup Fri May 18 04:06:02 BST 2001 On reboot, I got the manual fsck jive with the "bad superblock: values disagree ,,with,, first alternate", and had to re-enable softupdates on / Config is basically GENERIC + SMP. dmesg is appended. Abridged backtrace: panic() workitem_free() free_newdirblk() handle_written_inodeblock() softdep_disk_write_complete() bufdone() bufdonebio() dadone() camisr() ithread_loop() fork_exit() fork_trampoline() dmesg: FreeBSD 5.0-CURRENT #20: Wed May 16 00:24:36 BST 2001 rb@bludnok.gid.co.uk:/source/cleansrc/sys/compile/BLUDNOK_MP Timecounter "i8254" frequency 1193182 Hz CPU: Pentium II/Pentium II Xeon/Celeron (349.07-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0x651 Stepping = 1 Features=0x183fbff real memory = 134152192 (131008K bytes) config> enable ed0 config> port ed0 0x300 config> irq ed0 10 config> iomem ed0 0xd8000 config> flags ed0 0 config> disable cs0 config> disable fe0 config> disable ie0 config> disable lnc0 config> disable sn0 config> quit avail memory = 124653568 (121732K bytes) Programming 24 pins in IOAPIC #0 IOAPIC #0 intpin 2 -> irq 0 FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs cpu0 (BSP): apic id: 0, version: 0x00040011, at 0xfee00000 cpu1 (AP): apic id: 1, version: 0x00040011, at 0xfee00000 io0 (APIC): apic id: 2, version: 0x00170011, at 0xfec00000 Preloaded elf kernel "kernel" at 0xc05bb000. Preloaded userconfig_script "/boot/kernel.conf" at 0xc05bb09c. Pentium Pro MTRR support enabled WARNING: Driver mistake: destroy_dev on 154/0 Using $PIR table, 7 entries at 0xc00fda90 npx0: on motherboard npx0: INT 16 interface pcib0: at pcibus 0 on motherboard IOAPIC #0 intpin 16 -> irq 2 IOAPIC #0 intpin 19 -> irq 16 pci0: on pcib0 pcib1: at device 1.0 on pci0 pci1: on pcib1 isab0: at device 7.0 on pci0 isa0: on isab0 atapci0: port 0xf000-0xf00f at device 7.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 ata1: at 0x170 irq 15 on atapci0 uhci0: port 0xe000-0xe01f irq 11 at de vice 7.2 on pci0 usb0: on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered Timecounter "PIIX" frequency 3579545 Hz pci0: at 7.3 (no driver attached) ahc0: port 0xe400-0xe4ff mem 0xea000000-0xea00 0fff irq 2 at device 8.0 on pci0 aic7880: Wide Channel A, SCSI Id=7, 16/255 SCBs pci0: at 11.0 (no driver attached) atkbdc0: at port 0x60,0x64 on isa0 atkbd0: flags 0x1 irq 1 on atkbdc0 kbd0 at atkbd0 ed0 at port 0x300-0x31f iomem 0xd8000 irq 10 drq 0 on isa0 ed0: address 00:20:18:72:97:67, type NE2000 (16 bit) fdc0: at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 fdc0: FIFO enabled, 8 bytes threshold fd0: <1440-KB 3.5" drive> on fdc0 drive 0 pmtimer0 on isa0 ppc0: at port 0x378-0x37f irq 7 on isa0 ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode plip0: on ppbus0 lpt0: on ppbus0 lpt0: Interrupt-driven port ppi0: on ppbus0 sc0: at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 16550A sio1 at port 0x2f8-0x2ff irq 3 on isa0 sio1: type 16550A vga0: at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 unknown: can't assign resources unknown: can't assign resources unknown: can't assign resources unknown: can't assign resources unknown: can't assign resources APIC_IO: Testing 8254 interrupt delivery APIC_IO: routing 8254 via IOAPIC #0 intpin 2 ad0: 1222MB [2484/16/63] at ata0-master WDMA2 Waiting 15 seconds for SCSI devices to settle Mounting root from ufs:/dev/ad0s2a cd0 at ahc0 bus 0 target 6 lun 0 cd0: Removable CD-ROM SCSI-2 device cd0: 10.000MB/s transfers (10.000MHz, offset 8) cd0: Attempt to query device size failed: NOT READY, Medium not present da1 at ahc0 bus 0 target 5 lun 0 da1: Removable Direct Access SCSI-2 device da1: 3.300MB/s transfers da1: Attempt to query device size failed: NOT READY, Medium not present da0 at ahc0 bus 0 target 0 lun 0 da0: Fixed Direct Access SCSI-3 device da0: 40.000MB/s transfers (20.000MHz, offset 8, 16bit), Tagged Queueing Enabled da0: 8748MB (17916240 512 byte sectors: 255H 63S/T 1115C) SMP: AP CPU #1 Launched! -- Bob Bishop (0118) 977 4017 international code +44 118 rb@gid.co.uk fax (0118) 989 4254 To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-current" in the body of the message