From owner-freebsd-stable Sun Oct 15 21:52:56 2000 Delivered-To: freebsd-stable@freebsd.org Received: from router.atom.ru (atomnet.rmt.ru [194.67.161.34]) by hub.freebsd.org (Postfix) with ESMTP id ECC0637B502 for ; Sun, 15 Oct 2000 21:52:51 -0700 (PDT) Received: (from laa@localhost) by router.atom.ru (8.9.3/8.9.3) id IAA67021; Mon, 16 Oct 2000 08:52:46 +0400 (MSD) Date: Mon, 16 Oct 2000 08:52:46 +0400 From: "Alexandr A. Listopad" To: "Kuriyama, Kent K Mr (CPF N651KK)" Cc: "Freebsd-Stable (E-mail)" Subject: Re: Screen saver error message seen on 4.1.1-STABLE Message-ID: <20001016085246.A66455@atom.ru> References: Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Disposition: inline In-Reply-To: ; from KuriyaKK@cpf.navy.mil on Sun, Oct 15, 2000 at 06:10:36PM -1000 Sender: owner-freebsd-stable@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.ORG On Sun, Oct 15, 2000 at 06:10:36PM -1000, Kuriyama, Kent K Mr (CPF N651KK) wrote: > On the CVSUP dated 10/10/00 I get the following error message: > > logo_saver: no suitable graphics mode > module_register_init: MOD_LOAD (logo_saver, c0d48a60, 0) error 19 > > My rc.conf contains the line: > > saver="logo" > > These error messages did not occur in earlier snapshots of 4.1.1-STABLE. > Shown below is the 'dmesg' output, I created a GENERIC kernel to remove any > "customizations" as a reason for the problem. Any help would be greatly > appreciated. Thanks. > > Kent Kuriyama > SPAWAR Sys Ctr San Diego D424, CINCPACFLT N671KK > kuriyakk@cpf.navy.mil, 808-471-4125 > > > -----Original Message----- > Copyright (c) 1992-2000 The FreeBSD Project. > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 > The Regents of the University of California. All rights reserved. > FreeBSD 4.1.1-STABLE #0: Sun Oct 15 17:29:14 HST 2000 [skip many lines of dmesg] > fdc0: at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 > fdc0: FIFO enabled, 8 bytes threshold > fd0: <1440-KB 3.5" drive> on fdc0 drive 0 > atkbdc0: at port 0x60,0x64 on isa0 > vga0: at port 0x3b0-0x3cf iomem 0xa0000-0xbffff on isa0 > sc0: at flags 0x100 on isa0 > sc0: VGA (mono) <16 virtual consoles, flags=0x300> ^^^ because of "mono" vga!! > sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 > sio0: type 16550A > sio1 at port 0x2f8-0x2ff irq 3 on isa0 > IP packet filtering initialized, divert disabled, rule-based forwarding > disabled, default to deny, logging disabled > logo_saver: no suitable graphics mode > module_register_init: MOD_LOAD (logo_saver, c0d48a60, 0) error 19 Seems to your monitor cable don't connected to vga adapter since boot. GoodLuck! -- Laa To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-stable" in the body of the message