Skip site navigation (1)Skip section navigation (2)
Date:      Sun, 22 Jun 2003 15:36:39 -0700 (PDT)
From:      Thomas McIntyre <temac@yahoo.com>
To:        mailing-lists@johanpaul.com
Cc:        freebsd-newbies@freebsd.org
Subject:   Re: Setup of a software RAID-1 to an existing system?
Message-ID:  <20030622223639.80405.qmail@web14204.mail.yahoo.com>

next in thread | raw e-mail | index | archive | help
Johan,

The canonical answer is to repost to freebsd-questions, which enjoys
a larger readership.  But I'll try -- your question is interesting
b/c I'm in the same boat, except w/ CURRENT.  As you said, breezing
through the handbook will show a lot of detail, but perhaps it does
not directly address mirroring a live fs.

Aside from the handwaving, you might check http://www.vinumvm.org/. 
There seems to be a relevant (if a little dated) article:

   
http://www.freebsd.org/doc/en_US.ISO8859-1/articles/vinum/index.html

It may be possible to mirror partitions, even if half of it is live. 
Were this not the case, it's prob possible to boot the install cdrom
and play some tricks with dd or dump to sync the disks.  Perhaps they
could then be mounted, vinum set up, and then booted into.  

It would be fantastic if the freebsd installer had the ability to run
raid 1 right out the chute.  Doubtless, there's a number of us w/
legacy servers having two disks but no hardware raid.

Good luck.  Share your notes (at least to newbies) once you get it
working!

Regards,
Tom McIntyre

-----Original Message-----
From: Johan Paul [mailto:mailing-lists@johanpaul.com]
Sent: Sunday, June 22, 2003 12:19 PM
To: freebsd-newbies@freebsd.org
Subject: Setup of a software RAID-1 to an existing system?


Hi all!

I am pretty new to FreeBSD but thought it might be a nice idea to 
migrate from a Linux server to a FreeBSD one.

My question is regarding software RAID-1 for this FreeBSD box. I have

two IDE equally sized hard drives and I installed FreeBSD 4.8 on the 
other one. Now the question is: can I make a RAID-1 array of these
two 
disks while FreeBSD is installed on the other one (using vinum or 
other...)? Or how do I get RAID-1 to work on these two disks?

I've read some of the vinum documentation but it is unclear to me if
it 
is possible to set up a RAID-1 on a running disk system - and if my 
assumptions are correct, that it is impossible, it is unclear to me
how 
to set up this RAID-1?


Regards,

Johan Paul


__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20030622223639.80405.qmail>