Date: Sat, 9 Apr 2022 13:00:47 +0200 From: Ronald Klop <ronald-lists@klop.ws> To: bob prohaska <fbsd@www.zefox.net>, freebsd-arm@freebsd.org Subject: Re: RPI4 panic on boot with -current Message-ID: <818eec37-222f-0ce8-be38-3f38e7205b55@klop.ws> In-Reply-To: <20220409015321.GA52002@www.zefox.net> References: <20220409015321.GA52002@www.zefox.net>
next in thread | previous in thread | raw e-mail | index | archive | help
On 4/9/22 03:53, bob prohaska wrote: > Might this be related to "RPi4B's got a PMIC replacement,..." reported 4/3 ? > > A Pi4 (mechanical disk only, no microsd) trying to boot a fresh build of > -current reports: > > Resetting system ... > > U-Boot 2020.10 (Mar 04 2021 - 04:32:31 +0000) > > DRAM: 7.9 GiB > RPI 4 Model B (0xd03114) > MMC: mmc@7e300000: 1, emmc2@7e340000: 0 > Loading Environment from FAT... sdhci_set_clock: Timeout to wait cmd & data inhibit > sdhci_set_clock: Timeout to wait cmd & data inhibit > sdhci_set_clock: Timeout to wait cmd & data inhibit > sdhci_send_command: MMC: 1 busy timeout increasing to: 200 ms. > sdhci_send_command: MMC: 1 busy timeout increasing to: 400 ms. > sdhci_send_command: MMC: 1 busy timeout increasing to: 800 ms. > sdhci_send_command: MMC: 1 busy timeout increasing to: 1600 ms. > sdhci_send_command: MMC: 1 busy timeout increasing to: 3200 ms. > sdhci_send_command: MMC: 1 busy timeout. > In: serial > Out: vidconsole > Err: vidconsole > Net: eth0: ethernet@7d580000 > PCIe BRCM: link up, 5.0 Gbps x1 (SSC) > starting USB... > Bus xhci_pci: Register 5000420 NbrPorts 5 > Starting the controller > USB XHCI 1.00 > scanning bus xhci_pci for devices... 6 USB Device(s) found > scanning usb for storage devices... 1 Storage Device(s) found > Hit any key to stop autoboot: 0 > Card did not respond to voltage select! > sdhci_set_clock: Timeout to wait cmd & data inhibit > sdhci_set_clock: Timeout to wait cmd & data inhibit > sdhci_set_clock: Timeout to wait cmd & data inhibit > sdhci_send_command: MMC: 1 busy timeout. > > Device 0: Vendor: SABRENT Rev: 0204 Prod: > Type: Hard Disk > Capacity: 953869.7 MB = 931.5 GB (1953525168 x 512) > ... is now current device > Scanning usb 0:1... > Found EFI removable media binary efi/boot/bootaa64.efi > libfdt fdt_check_header(): FDT_ERR_BADMAGIC > sdhci_set_clock: Timeout to wait cmd & data inhibit > sdhci_set_clock: Timeout to wait cmd & data inhibit > sdhci_set_clock: Timeout to wait cmd & data inhibit > sdhci_send_command: MMC: 1 busy timeout. > Scanning disk mmc@7e300000.blk... > Disk mmc@7e300000.blk not ready > Card did not respond to voltage select! > Scanning disk emmc2@7e340000.blk... > Disk emmc2@7e340000.blk not ready > Scanning disk usb_mass_storage.lun0... > ** Unrecognized filesystem type ** > Found 3 disks > No EFI system partition > BootOrder not defined > EFI boot manager: Cannot load any image > 1259292 bytes read in 5 ms (240.2 MiB/s) > libfdt fdt_check_header(): FDT_ERR_BADMAGIC > Booting /efi\boot\bootaa64.efi > > [whitespace trimmed] > > Consoles: EFI console > Reading loader env vars from /efi/freebsd/loader.env > Setting currdev to disk0p1: > FreeBSD/arm64 EFI loader, Revision 1.1 > (Thu Mar 4 07:32:03 UTC 2021 root@releng1.nyi.freebsd.org) > > Command line arguments: loader.efi > Image base: 0x39cfc000 > EFI version: 2.80 > EFI Firmware: Das U-Boot (rev 8224.4096) > Console: comconsole (0) > Load Path: /efi\boot\bootaa64.efi > Load Device: /VenHw(e61d73b9-a384-4acc-aeab-82e828f3628b)/UsbClass(0x0,0x0,0x9,0x0,0x3)/UsbClass(0x152d,0x1561,0x0,0x0,0x0)/HD(1,0x01,0,0x81f,0x18fa8) > Trying ESP: /VenHw(e61d73b9-a384-4acc-aeab-82e828f3628b)/UsbClass(0x0,0x0,0x9,0x0,0x3)/UsbClass(0x152d,0x1561,0x0,0x0,0x0)/HD(1,0x01,0,0x81f,0x18fa8) > Setting currdev to disk0p1: > Trying: /VenHw(e61d73b9-a384-4acc-aeab-82e828f3628b)/UsbClass(0x0,0x0,0x9,0x0,0x3)/UsbClass(0x152d,0x1561,0x0,0x0,0x0)/HD(2,0x01,0,0x197c7,0x746ed5e9) > Setting currdev to disk0p2: > / > Loading /boot/defaults/loader.conf > Loading /boot/defaults/loader.conf > Loading /boot/device.hints > Loading /boot/loader.conf > Loading /boot/loader.conf.local > Loading kernel... > /boot/kernel/kernel text=0x2a8 text=0x851220 text=0x24be84 data=0x1b9ba8 data=0x0+0x34f000 syms=[0x8+0x134028+0x8+0x15b5e1] > Loading configured modules... > /boot/kernel/filemon.ko text=0x1867 text=0x2558 data=0x510+0x20 syms=[0x8+0xd08+0x8+0x7c9] > /boot/kernel/umodem.ko text=0x2100 text=0x13a0 data=0x6d8+0x10 syms=[0x8+0xf18+0x8+0xb5c] > loading required module 'ucom' > /boot/kernel/ucom.ko text=0x2590 text=0x2f00 data=0x8e0+0x858 syms=[0x8+0x1290+0x8+0xbd5] > /boot/entropy size=0x1000 > /etc/hostid size=0x25 > > Hit [Enter] to boot immediately, or any other key for command prompt. > Booting [/boot/kernel/kernel]... > Using DTB provided by EFI at 0x7ef0000. > EFI framebuffer information: > addr, size 0x3e22c000, 0x8ca000 > dimensions 1920 x 1200 > stride 1920 > masks 0x00ff0000, 0x0000ff00, 0x000000ff, 0xff000000 > ---<<BOOT>>--- > GDB: debug ports: uart > GDB: current port: uart > KDB: debugger backends: ddb gdb > KDB: current backend: ddb > WARNING: Cannot find freebsd,dts-version property, cannot check DTB compliance > Copyright (c) 1992-2022 The FreeBSD Project. > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 > The Regents of the University of California. All rights reserved. > FreeBSD is a registered trademark of The FreeBSD Foundation. > FreeBSD 14.0-CURRENT #40 main-aa597d4049-dirty: Fri Apr 8 11:44:42 PDT 2022 > bob@nemesis.zefox.com:/usr/obj/usr/src/arm64.aarch64/sys/GENERIC arm64 > FreeBSD clang version 13.0.0 (git@github.com:llvm/llvm-project.git llvmorg-13.0.0-0-gd7b669b3a303) > WARNING: WITNESS option enabled, expect reduced performance. > VT(efifb): resolution 1920x1200 > module firmware already present! > real memory = 8441835520 (8050 MB) > avail memory = 8206352384 (7826 MB) > Starting CPU 1 (1) > Starting CPU 2 (2) > Starting CPU 3 (3) > FreeBSD/SMP: Multiprocessor System Detected: 4 CPUs > random: unblocking device. > random: entropy device external interface > Fatal data abort: > x0: ffffa0003b25dad0 > x1: 8 > x2: ffff00000088db8d (do_execve.fexecv_proc_title + 7674) > x3: 78a > x4: 0 > x5: 69 > x6: 40a7152f > x7: f2db3c10 > x8: ffffa0003b25dad0 > x9: 200000000 > x10: ffffa00000000000 > x11: 3b25dad0 > x12: 725f696665006966 > x13: 100000102ff0001 > x14: ffff000000b07300 (lock_class_mtx_sleep + 0) > x15: 0 > x16: 8 > x17: f4b3707d > x18: ffff000000fa79b0 (initstack + 39b0) > x19: ffffa000008db380 > x20: ffff000000ab4810 (efirt_moddata + 0) > x21: ffff000000911163 (console_pausestr + 13a59) > x22: ffff000000c6d000 (db_watch_table + b88) > x23: ffff000000ba1000 (compiler_version + 20) > x24: ffff000000dfb000 (gdb_tx_u + aa0) > x25: 0 > x26: ffff0000008a1723 (do_execve.fexecv_proc_title + 1b20a) > x27: 3100000 > x28: ffff000000dfb000 (gdb_tx_u + aa0) > x29: ffff000000fa79c0 (initstack + 39c0) > sp: ffff000000fa79b0 > lr: ffff000000157ac4 (efirt_modevents + 78) > elr: ffff000000157ad0 (efirt_modevents + 84) > spsr: 200000c5 > far: ffffa0003b25dad0 > esr: 96000007 > panic: vm_fault failed: ffff000000157ad0 error 1 > cpuid = 0 > time = 1 > KDB: stack backtrace: > db_trace_self() at db_trace_self > db_trace_self_wrapper() at db_trace_self_wrapper+0x30 > vpanic() at vpanic+0x174 > panic() at panic+0x44 > data_abort() at data_abort+0x2f0 > handle_el1h_sync() at handle_el1h_sync+0x10 > --- exception, esr 0x96000007 > efirt_modevents() at efirt_modevents+0x84 > module_register_init() at module_register_init+0xc4 > mi_startup() at mi_startup+0x130 > virtdone() at virtdone+0x7c > KDB: enter: panic > [ thread pid 0 tid 100000 ] > Stopped at kdb_enter+0x44: undefined f902011f > db> bt > Tracing pid 0 tid 100000 td 0xffff000000dfc0e0 > db_trace_self() at db_trace_self > db_stack_trace() at db_stack_trace+0x11c > db_command() at db_command+0x368 > db_command_loop() at db_command_loop+0x54 > db_trap() at db_trap+0xf8 > kdb_trap() at kdb_trap+0x1cc > handle_el1h_sync() at handle_el1h_sync+0x10 > --- exception, esr 0xf2000000 > kdb_enter() at kdb_enter+0x44 > vpanic() at vpanic+0x1b0 > panic() at panic+0x44 > data_abort() at data_abort+0x2f0 > handle_el1h_sync() at handle_el1h_sync+0x10 > --- exception, esr 0x96000007 > efirt_modevents() at efirt_modevents+0x84 > module_register_init() at module_register_init+0xc4 > mi_startup() at mi_startup+0x130 > virtdone() at virtdone+0x7c > db> > > followed by > > db> reboot > cpu_reset failed > > After power cycle the machine rebooted to > FreeBSD 14.0-CURRENT #34 main-79c4c4be96-dirty: Tue Apr 5 09:26:19 PDT 2022 > without obvious problems. "Dirty" is in reference to /usr/src/tests, I've > refrained from tampering with the sources. > > Thanks for reading, > > bob prohaska > > Is this similar to this? https://lists.freebsd.org/archives/dev-commits-src-all/2022-April/009765.html Regards, Ronald.
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?818eec37-222f-0ce8-be38-3f38e7205b55>