Date: Mon, 9 Jan 1995 18:16:27 -0800 (PST) From: "Justin T. Gibbs" <gibbs@estienne.CS.Berkeley.EDU> To: jcarr@freedom.wit.com (Jeff Carr) Cc: questions@FreeBSD.org Subject: Re: problems installing 2.0 Message-ID: <199501100216.SAA08821@estienne.cs.berkeley.edu> In-Reply-To: <199501091712.RAA02678@freedom.wit.com> from "Jeff Carr" at Jan 9, 95 05:12:54 pm
next in thread | previous in thread | raw e-mail | index | archive | help
> > We are using Freebsd 2.0 to run our site www.wit.com. We have purchased > another machine to take some of the load of our single machine, it is > a 486/66 with an Adaptec 2842VL scsi card and a 3com 3C509 Etherlink III > ethernet card. > While trying to install 2.0 with the newest boot_144 floppy, I get > the following: > > wt0 not found at 0x300 > mcd0: timeout getting status > mcd0: not found at 0x300 > mcd1: timeount getting status > mcd1 not found at 0x340 > ie0 not found at 0x360 > 1 3C5x9 board(s) on ISA found at 0x300 > ep0 at 0x300-0x30f irq 10 on isa > ep0: aui/bnc[*BNC*] address 00:20:af:15:e4:9b > is0 not found at 0x200 > le0 not probed due to I/O address conflict with ep0 at 0x300 > ze0 not probed due to I/O address conflict with ep0 at 0x300 > npx0 on motherboard > changing root device to fd0c > > > Fatal trap 9: general protection fault while in kernal mode > instruction pointer = 0x8:0xf015fda0 > code segment = base 0x0, limit 0xffffff, type 0x1b > = DPL 0, pres 1, def32 1, gran 1 > processor eflags = interrupt enabled, resume, IOPL = 0 > current process = 0 () > inturrupt mask = > panic: general protection fault > hit reset please If I have the right floppy, this is in scsi_get_predef. This is the second report of problems with a 2842 (but it could be the 3c509). Can you try disabling (via the -c option at the boot prompt) any unnecessary devices and see how far that gets you? Can you also try the following floppy?: Freefall.cdrom.com:/incoming/294x_boot_144.flp.gz It won't look like it is there, but trust me and just do a blind get on it. > > any ideas? I'll make an attempt to get different hardware if that is > the problem. I'd be forever in debt if someone could help me out on this. > jcarr@wit.com Can you also give me the probe messages above where you show here? Thanks! -- Justin T. Gibbs ============================================== TCS Instructional Group - Programmer/Analyst 1 Cory | Po | Danube | Volga | Parker | Torus ==============================================
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199501100216.SAA08821>