Date: Tue, 26 Jun 2007 09:40:56 -0400 From: "Jim Stapleton" <stapleton.41@gmail.com> To: "Artyom Viklenko" <artem@aws-net.org.ua>, freebsd-questions@freebsd.org Subject: Re: ppp/peers/* files Message-ID: <80f4f2b20706260640m396a87fbj49dc476e29d3c9de@mail.gmail.com> In-Reply-To: <20070626162827.X42212@alf.aws-net.org.ua> References: <80f4f2b20706230440n5abeceb6n6d94eef41f776265@mail.gmail.com> <467D1700.8050006@aws-net.org.ua> <80f4f2b20706231120u6b6f2659xa427b7a54f20b243@mail.gmail.com> <467E2BEC.80305@aws-net.org.ua> <80f4f2b20706260504m782e25a2odadaa91be4856e37@mail.gmail.com> <46810D3A.6030308@aws-net.org.ua> <80f4f2b20706260623y6b7514e3q64879b3877fc2ac2@mail.gmail.com> <20070626162827.X42212@alf.aws-net.org.ua>
next in thread | previous in thread | raw e-mail | index | archive | help
Hmm, would it be easier for me to setup a 127.0.0.2 loopback and my gateway, and alway point that to the proper gateway, to make things easier when I'm switching between VPN and no VPN? Thanks -Jim Stapleton On 6/26/07, Artyom Viklenko <artem@aws-net.org.ua> wrote: > On Tue, 26 Jun 2007, Jim Stapleton wrote: > > > What man/handbook pages/sections should I look at to get a clue. I'm > > so far from having one, I don't even know the direction... > > see handbook section about networking. > > simply speaking enter > > route add ip-of-vpn-server ip-of-your-lan-gateway > > > > then start MPD and check is all ok. > if yes, you can add this route to /etc/rc.conf using > static_routes variable. > > > > > > Thanks, > > -Jim Stapleton > > > > On 6/26/07, Artyom Viklenko <artem@aws-net.org.ua> wrote: > >> Jim Stapleton wrote: > >> > That partially worked. I could only ping 192.168.1.1 on my local setup > >> > (router). > >> > > >> > I used > >> > $ mpd pptp0 > >> > > >> > However, I couldn't access the work DNS either. The latter output of > >> > MPD looked like: > >> > ========== > >> > pptp0] IPCP: rec'd Configure Ack #4 link 0 (Ack-Sent) > >> > IPADDR <IP-ADDR-A> > >> > [pptp0] IPCP: state change Ack-Sent --> Opened > >> > [pptp0] IPCP: LayerUp > >> > <IP-ADDR-A> -> <IP-ADDR-B> > >> > [pptp0] IFACE: Up event > >> > [pptp0] setting interface ng0 MTU to 1396 bytes > >> > [pptp0] exec: /sbin/ifconfig ng0 <IP-ADDR-A> <IP-ADDR-B> netmask > >> > 0xffffffff -link0 > >> > [pptp0] exec: /sbin/route add <IP-ADDR-A> -iface lo0 > >> > [pptp0] exec: /sbin/route add 0.0.0.0 <IP-ADDR-B> > >> > [pptp0] exec: command returned 256 > >> > ========== > >> > > >> > > >> > I could ping <IP-ADDR-A> and <IP-ADDR-B> after running mpd, but I > >> > could not ping them before running it, or after shutting it down. Both > >> > are valid IP addresses on my works internal network. > >> > > >> > Aside from my nve0 and l0 devices, which look normal, ifconfig > >> > displays the following: > >> > > >> > ========== > >> > ng0: flags=88d1<UP,POINTOPOINT,RUNNING,NOARP,SIMPLEX,MULTICAST> mtu 1396 > >> > inet <IP-ADDR-A> --> <IP-ADDR-B> netmask 0xffffffff > >> > ========== > >> > > >> > I could not ping the DNS servers. > >> > > >> > Any suggestions? > >> > >> I think you need static route to your VPN server. > >> After setting up tullel your default route changes. > >> This can lead to incorrect routing. > >> > >> > >> -- > >> Sincerely yours, > >> Artyom Viklenko. > >> ------------------------------------------------------- > >> artem@aws-net.org.ua | http://www.aws-net.org.ua/~artem > >> FreeBSD: The Power to Serve - http://www.freebsd.org > >> > > _______________________________________________ > > freebsd-net@freebsd.org mailing list > > http://lists.freebsd.org/mailman/listinfo/freebsd-net > > To unsubscribe, send any mail to "freebsd-net-unsubscribe@freebsd.org" > > > > -- > Sincerely yours, > Artyom Viklenko. > ------------------------------------------------------- > artem@aws-net.org.ua | http://www.aws-net.org.ua/~artem > FreeBSD: The Power to Serve - http://www.freebsd.org >
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?80f4f2b20706260640m396a87fbj49dc476e29d3c9de>