From owner-freebsd-questions@FreeBSD.ORG Mon May 3 19:06:35 2004 Return-Path: Delivered-To: freebsd-questions@freebsd.org Received: from mx1.FreeBSD.org (mx1.freebsd.org [216.136.204.125]) by hub.freebsd.org (Postfix) with ESMTP id CB4CB16A4CE; Mon, 3 May 2004 19:06:35 -0700 (PDT) Received: from wonkity.com (wonkity.com [65.173.111.5]) by mx1.FreeBSD.org (Postfix) with ESMTP id 4D6F643D53; Mon, 3 May 2004 19:06:35 -0700 (PDT) (envelope-from wblock@wonkity.com) Received: from wonkity.com (localhost [127.0.0.1]) by wonkity.com (8.12.11/8.12.11) with ESMTP id i4426YFY043692; Mon, 3 May 2004 20:06:34 -0600 (MDT) (envelope-from wblock@wonkity.com) Received: from localhost (wblock@localhost) by wonkity.com (8.12.11/8.12.11/Submit) with ESMTP id i4426Y3l043689; Mon, 3 May 2004 20:06:34 -0600 (MDT) (envelope-from wblock@wonkity.com) Date: Mon, 3 May 2004 20:06:34 -0600 (MDT) From: Warren Block To: Florian In-Reply-To: Message-ID: <20040503200109.B43674@wonkity.com> References: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII X-Virus-Scanned: clamd / ClamAV version devel-20040424, clamav-milter version 0.70k cc: freebsd-questions@freebsd.org cc: freebsd-newbies@freebsd.org Subject: Re: SATA X-BeenThere: freebsd-questions@freebsd.org X-Mailman-Version: 2.1.1 Precedence: list List-Id: User questions List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , X-List-Received-Date: Tue, 04 May 2004 02:06:35 -0000 On Tue, 4 May 2004, Florian wrote: > On advice, I downloaded FreeBSD 4.10 RC2 (because 5.2.1 would not work) > but can't install it because the installer does not find my HDD which is a > 120gb Seagate drive on an on-board Silicon Image SiI 3112 SATARaid > Controller. > Is SATA support not yet implemented in RC2 but in the 4.9? Or is SATA only > supported in 5.x? > What can I do? I just finished upgrading a system to a new motherboard with SATA. To do that, I loaded a normal parallel IDE drive, installed to it, and then used dump to move the install over to the SATA drive. Editing /etc/fstab to use ad4 instead of ad0 was the next step, and then finally setting the BIOS to boot from the SATA drive. -Warren Block * Rapid City, South Dakota USA