Date: Sat, 19 May 2012 17:57:26 -0400 From: "Thomas Mueller" <mueller230@insightbb.com> To: freebsd-stable@freebsd.org Cc: Marcelo Gondim <gondim@bsdinfo.com.br> Subject: Re: Make buildkernel fails on /usr/src/sys/dev/ata/atapi-cam.c Message-ID: <DF.78.14786.64718BF4@smtp01.insight.synacor.com>
next in thread | raw e-mail | index | archive | help
> My daily stable/9 build (& boot) was successful at r235604: > FreeBSD g1-227.catwhisker.org 9.0-STABLE FreeBSD 9.0-STABLE #162 235604M: Fri May 18 04:39:02 PDT 2012 > +root@g1-227.catwhisker.org:/usr/obj/usr/src/sys/CANARY i386 > Peace, > david > -- > David H. Wolfskill david@catwhisker.org So maybe I just need to csup again and try again, "make buildworld" followed by "make buildkernel"? Where do you find the number r235604 either in the built-and-installed system or the source tree? I looked in /usr/src/sys/conf/newvers.sh and some other files. > That's nice, but do you have 'device ata' in the configuration? It is > required, even with ATA_CAM. > Also, the thread states that atapicam is not needed with ATA_CAM. I > don't have atapicam it in my kernel and my SATA CD/DVD drive works > just fine. > -- > R. Kevin Oberman, Network Engineer I had both 'device ata' and 'device atapicam' in kernel configuration, in accordance with online FreeBSD Handbook: > 19.6.9 Using the ATAPI/CAM Driver > Contributed by Marc Fonvieille. > This driver allows ATAPI devices (CD-ROM, CD-RW, DVD drives etc...) to be accessed through the SCSI subsystem, and so allows the use of applications like sysutils/cdrdao or cdrecord(1). > To use this driver, you will need to add the following line to the /boot/loader.conf file: > atapicam_load="YES" > then, reboot your machine. > Note: If you prefer to statically compile the atapicam(4) support in your kernel, you will have to add this line to your kernel configuration file: > device atapicam > You also need the following lines in your kernel configuration file: > device ata > device scbus > device cd > device pass > which should already be present. Then rebuild, install your new kernel, and reboot your machine. But there was nothing about 'options ATA_CAM', which I included. Maybe you had atapicam kernel module which loaded in the absence of 'device atapicam' in kernel config? Now I see in /usr/src/sys/conf/NOTES, ATA_CAM deprecates all ata drivers including atapicam. So maybe I need to delete or put '# ' in front of 'device atapicam' in kernel config? But it worked building 9.0_STABLE #6 from 9.0_RELEASE. One other thing I could do would be to exclude module ulpt due to idiosyncrasies of HP printers and hplip. Reason for upgrading to STABLE was spontaneous reboots in 9.0_RELEASE, like maybe once in 48 hours, plus modern hardware needing the latest driver updates. Tom
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?DF.78.14786.64718BF4>