Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 9 Jan 2002 22:43:39 -0600
From:      Marius Strom <marius@marius.org>
To:        "M. Warner Losh" <imp@village.org>
Cc:        freebsd@samurai.deec.uc.pt, stable@FreeBSD.ORG, paulo@isr.uc.pt, mobile@FreeBSD.ORG
Subject:   Re: Can't boot FreeBSD on a Toshiba Laptop
Message-ID:  <20020110044338.GM64900@marius.org>
In-Reply-To: <20020109213535.GL64900@marius.org>
References:  <Pine.BSF.4.21.0201091439420.782-300000@samurai.deec.uc.pt> <20020109.115326.99747006.imp@village.org> <20020109213535.GL64900@marius.org>

next in thread | previous in thread | raw e-mail | index | archive | help
Yet another data point: Doesn't work with 4.5-RC1 either.  CC:ing'g
-mobile, and setting reply-to to mobile since -stable is in codefreeze.

On Wed, Jan 09, 2002 at 03:35:35PM -0600, Marius Strom wrote:
> Warner (et al),
> Unfortunately, still doesn't work.
> 
> Last few lines of boot:
> 
> pci2: <unknown card> (vendor=0x1179, dev=0x0804) at 6.0 irq 5
> isab0: <PCI to ISA bridge (vendor=8086 device=248c)> at device 31.0 on pci0
> isa0: <ISA bus> on isab0
> atapci0: <Generic PCI ATA controller> port 0x1860-0x186f,0x374-0x377,0x170-0x177,0x3f4-0x3f7,0x1f0-0x1f7 mem 0xd0000000-0xd00003ff at device 31.1 on pci0
> ata0: at 0x1f0 irq 14 on atapci0
> ata1: at 0x170 irq 15 on atapci0
> pci0: <unknown card> (vendor=0x8086, dev=0x2483) at 31.3 irq 10
> pci0: <unknown card> (vendor=0x8086, dev=0x2485) at 31.5 irq 10
> pci0: <unknown card> (vendor=0x8086, dev=0x2486) at 31.6 irq 10
> 
> 
> It hard locks at that point.  If I can provide any information obtainable
> from another OS on the machine (it boots linux, winxp) let me know (I can
> also dig in and find exactly what components are where).
> 
> Here's what I do know:
> 
> Video card in the system is a GeForce 2 Go (their mobile GeFoce).
> RealTek chipset is detected
> USB is detected
> pcic stuff (TI PCI-1420 PCI-CardBus Bridge) is detected.  Config Reg:
> [speaker enable][pwr save][FUNC pci int + CSC serial isa irq]
> 
> According to WinXP, the PCI device on IRQ10 is a Intel 82801CA/CAM SMBus
> Controller - 2483.  WinXP shows nothing on IRQ5.
> IRQ3 is the SMC IrCC Infrared port.  Anyway to make FreeBSD think of this
> as a serial interface to do debug kernels?
> IRQ9 is shared between the Realtek Card, Crystal WDM Audi card, GeForce2,
> USB controller, TI IEEE1394 controller, TI PCMCIA controller, Toshiba AMR
> Software Modem, and Toshiba SM Host Controller.
> 
> Again, if you need any more info, let me know and I'll see what I can dig
> up.  I know I'd be very interested in seeing FreeBSD supported on this
> laptop.
> 
> On Wed, Jan 09, 2002 at 11:53:26AM -0700, M. Warner Losh wrote:
> > OK.  This is a longshot (since you said that 4.3 also failed), but can
> > you try a 4.4 or newer kernel and in the boot loader say:
> > 	hw.pcic.intr_path=1
> > 	hw.pcic.irq=0
> > Warner
> > 
> > To Unsubscribe: send mail to majordomo@FreeBSD.org
> > with "unsubscribe freebsd-stable" in the body of the message
> 
> -- 
>                        /------------------------------------------------->
> Marius Strom           | Always carry a short length of fibre-optic cable.
> Professional Geek      | If you get lost, then you can drop it on the
> System/Network Admin   | ground, wait 10 minutes, and ask the backhoe
> http://www.marius.org/ | operator how to get back to civilization.
>                        \-------------| Alan Frame |---------------------->
> 
> To Unsubscribe: send mail to majordomo@FreeBSD.org
> with "unsubscribe freebsd-stable" in the body of the message

-- 
                       /------------------------------------------------->
Marius Strom           | Always carry a short length of fibre-optic cable.
Professional Geek      | If you get lost, then you can drop it on the
System/Network Admin   | ground, wait 10 minutes, and ask the backhoe
http://www.marius.org/ | operator how to get back to civilization.
                       \-------------| Alan Frame |---------------------->

To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20020110044338.GM64900>