From owner-freebsd-questions Tue Sep 12 7:32: 7 2000 Delivered-To: freebsd-questions@freebsd.org Received: from sanson.reyes.somos.net (freyes.static.inch.com [216.223.199.224]) by hub.freebsd.org (Postfix) with ESMTP id 20C4C37B422 for ; Tue, 12 Sep 2000 07:31:53 -0700 (PDT) Received: from zoraida.reyes.somos.net (zoraida.reyes.somos.net [10.0.0.15]) by sanson.reyes.somos.net (8.9.3/8.9.3) with ESMTP id KAA30625; Tue, 12 Sep 2000 10:21:53 -0400 (EDT) (envelope-from fran@reyes.somos.net) Date: Tue, 12 Sep 2000 10:34:22 -0400 (EDT) From: Francisco Reyes To: Brad Guillory Cc: freebsd-questions@FreeBSD.ORG Subject: Re: sysinstall network config In-Reply-To: <20000912083815.A78977@baileylink.net> Message-ID: MIME-Version: 1.0 Content-Type: TEXT/PLAIN; charset=US-ASCII Sender: owner-freebsd-questions@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.ORG On Tue, 12 Sep 2000, Brad Guillory wrote: > on another note if you are still reading my ethernet card does not work. > I have a 3c589d, the ep0 driver reports "No irq!?". I have seen suggestions > to use the 3com utility to set the irq and base address which I have done > but no suggestions about what to set them to. On most ethernet cards you can let the card attempt to autoconfigure. If after you reboot FreeBSd doesn't see it then do the following: --When you get the prompt asking if you want to do kernel config choose visual. --Press enter on the network card entry. This takes you to the bottom part of the screen. Type in the correct IRQ and Address (move to the field, use backspace and then type in the right number). IF the only problem FreeBSD was having was not finding the card due to IRQ and address then the above should work. I have not used the card you mentioned or any pcmcia card (don't have freeBSD on a laptop) so I am only talking in "general" terms. Also I have a machine where I have to specify the IRQ/Address for the network card and every time I boot I have to "boot -c/ visual" to enter the right parameters... so if you get it to work once and the next time it is not recognized you may need to specify your parameters at boot time To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message