Date: Fri, 9 May 1997 15:51:46 +0200 From: Shaun Courtney <shaun@emma.eng.uct.ac.za> To: questions@freebsd.org Subject: Compaq Armada 1130T and 2.2.1 installation problems. Message-ID: <19970509155146.40249@emma.eng.uct.ac.za>
next in thread | raw e-mail | index | archive | help
Hi
I'm trying to install FreeBSD 2.2.1-R on a Compaq Armada 1130T (120mhz Pentium
with active screen and 1GB hard disk.)
I've spit the disk so that it has about 500mb for Win95 :( and 500mb for FreeBSD
The problem I have is when the machine boots it loads the kernel okay,
(it does complains about memory != to bios memory ) and then goes into
the config section.
If I press enter (without config) it probes the hardware until it gets to apm0
and stops! (read hangs)
I did notice it said it could not fine an irq for the SVGA driver under the PCI
section...
Can you please help, as I have limited experience with laptops/ notebooks.
Thanks
Shaun
--
Department of Electrical Engineering and CERECAM
Unix System Administrator and Unix support
AD E4 BF C8 51 94 B2 06 36 24 6A C1 A3 3A 5D 01
http://www.eng.uct.ac.za
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?19970509155146.40249>