Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 15 Oct 2003 13:19:46 +0200
From:      Jean-Paul Chapalain <Jean-Paul.Chapalain@gicm.fr>
To:        freebsd-mobile@freebsd.org
Subject:   if_wi 104 bit WEP rx problem
Message-ID:  <3F8D2D52.4060200@gicm.fr>

next in thread | raw e-mail | index | archive | help
> Hi,
> 
> at my university they recently switched to 104 bit wep key encryption
> (whatever this shall be good for; i'd prefer ipsec...).
> 
> I have an orinoco card that should have a firmware supporting 104 bit
> wep keys (me followed the link on fenner's homepage).
> 
> info:
> 
> FreeBSD 5.0-CURRENT #0: Mon Mar 24 22:43:31 UTC 2003
> 
> wi0: <WaveLAN/IEEE> at port 0x100-0x13f irq 9 function 0 config 1 on pccard1
> wi0: 802.11 address: 00:xx:xx:my:_m:ac
> wi0: using Lucent Technologies, WaveLAN/IEEE
> wi0: Lucent Firmware: Station (8.10.1)
> wi0: supported rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
> 
> It is still running fine with 40 bit keys but with 104 bit keys I seem
> to have a problem. sending seems to work fine but receiving gives errors:
> (hope I got the correct traces:)
> 
>  kernel: wi_newstate: INIT -> INIT
>  kernel: wi_newstate: INIT -> INIT
>  kernel: wi_newstate: INIT -> INIT
>  kernel: wi_newstate: INIT -> INIT
>  kernel: wi_newstate: INIT -> INIT
>  kernel: wi_info_intr: LINK_STAT 0x1
>  kernel: wi_newstate: INIT -> RUN
> 
>  kernel: TODS 00:xx:xx:my:_m:ac->33:33:ff:my:_m:ac(00:xx:xx:49:xy:xz) data WEP
>  kernel: 0841 0000 0002 2d49 2324 0002 2d0f d274 3333 ff0f d274 0000 0000 0000 0000
>  kernel: status 0x0 rx_tstamp1 0 rx_tstamp0 0x0 rx_silence 0
>  kernel: rx_signal 0 rx_rate 0 rx_flow 0
>  kernel: tx_rtry 0 tx_rate 0 tx_ctl 0xc dat_len 72
>  kernel: ehdr dst 33:33:ff:my:_m:ac src 00:xx:xx:my:_m:ac type 0xdd86
> 
>  kernel: FRDS 00:xx:xx:my:_m:ac->01:60:1d:00:01:00(00:xx:xx:49:xy:xz) data WEP +166
>  kernel: 0842 0000 0160 1d00 0100 0002 2d49 2324 0002 2d0f d274 5048 0527 19a8 251a
>  kernel: status 0x2 rx_tstamp1 12007 rx_tstamp0 0x4 rx_silence 128
>  kernel: rx_signal 166 rx_rate 20 rx_flow 144
>  kernel: tx_rtry 0 tx_rate 0 tx_ctl 0x0 dat_len 60
>  kernel: ehdr dst ab:1d:86:23:b0:7b src 34:12:b3:43:65:27 type 0x3c00
>  kernel: wi_rx_intr: fid ca error status 2
> 
>  kernel: TODS 00:xx:xx:my:_m:ac->ff:ff:ff:ff:ff:ff(00:xx:xx:49:xy:xz) data WEP
>  kernel: 0841 0000 0002 2d49 2324 0002 2d0f d274 ffff ffff ffff 1000 0000 0000 0000
>  kernel: status 0x0 rx_tstamp1 0 rx_tstamp0 0x0 rx_silence 0
>  kernel: rx_signal 0 rx_rate 0 rx_flow 0
>  kernel: tx_rtry 0 tx_rate 0 tx_ctl 0xc dat_len 336
>  kernel: ehdr dst ff:ff:ff:ff:ff:ff src 00:xx:xx:my:_m:ac type 0x8
>  ....
> 
> What I can see the status is either 0x1 or 0x2 with 104 bits but
> is 0x2000 with 40 bits.
> 
>  From what I understand WEP decryption is done in card itself ? So
> is this a firmware problem ?
> 
> Any ideas on how to better debug this ?
> 
> Thanks in advance.
> 
> -- 
> Bjoern A. Zeeb				bzeeb at Zabbadoz dot NeT
> 56 69 73 69 74				http://www.zabbadoz.net/

Have you find a solution ?

I've the same problem with a Linux machine.
I've a redhat 7.3 (Kernel 2.4.22) on Satellite Pro 4600 Toshiba.

The wireless card is like PrismeII and i use orinoco_cs module.

[root@blabla root]# cardctl ident
Socket 0:
   product info: "TOSHIBA", "Wireless LAN Card", "Version 01.01", ""
   manfid: 0x0156, 0x0002
   function: 6 (network)

Whem we use 40 bits keys for WEP it-s fine but with 128 bits keys there 
is problems.

Some others informations :
--------------------------
[root@blabla root]# iwconfig eth1
Warning: Driver for device eth1 has been compiled with version 15
of Wireless Extension, while this program is using version 13.
Some things may be broken...

eth1      IEEE 802.11-DS  ESSID:"Hello"  Nickname:"custren"
           Mode:Managed  Frequency:2.442GHz  Access Point: 
00:07:85:B3:48:2F
           Bit Rate=2Mb/s   Tx-Power=15 dBm   Sensitivity:1/3
           Retry limit:4   RTS thr:off   Fragment thr:off
           Encryption key:1234-5678-9012-3456-7890-1234-56
           Power Management:off
           Link Quality:51/92  Signal level:-47 dBm  Noise level:-98 dBm
           Rx invalid nwid:0  Rx invalid crypt:97458  Rx invalid frag:83
           Tx excessive retries:0  Invalid misc:0   Missed beacon:0

[root@blabla root]# iwlist eth1 key
Warning: Driver for device eth1 has been compiled with version 15
of Wireless Extension, while this program is using version 13.
Some things may be broken...

eth1      2 key sizes : 40, 104bits
           4 keys available :
		[1]: 1234-5678-9012-3456-7890-1234-56 (104 bits)
		[2]: off
		[3]: off
		[4]: off
           Current Transmit Key: [1]

Config of AP1200 Cisco is ike this :
Using 2360 out of 32768 bytes
!
version 12.2
!
hostname ap-2
!
logging console informational
aaa new-model
!
!
aaa authentication login default group radius local
aaa authorization exec default group radius local
aaa accounting exec default start-stop group radius
aaa session-id common
!
bridge irb
!
!
interface Dot11Radio0
  no ip address
  no ip route-cache
  !
  encryption key 1 size 128bit 0 12345678901234567890123456 transmit-key
  encryption mode wep mandatory
  !
  ssid Hello
     max-associations 31
     authentication open
     accounting acct_methods
     infrastructure-ssid
  !
  speed basic-1.0 2.0 5.5 11.0
  rts threshold 2339
  rts retries 32
  power local 50
  packet retries 32
  channel 2442
  fragment-threshold 2338
  station-role root
  l2-filter bridge-group-acl
  no cdp enable
  infrastructure-client
  bridge-group 1
  bridge-group 1 subscriber-loop-control
  bridge-group 1 block-unknown-source
  no bridge-group 1 source-learning
  no bridge-group 1 unicast-flooding
  bridge-group 1 spanning-disabled
interface FastEthernet0
  ip address 10.154.91.11 255.255.255.0
  no ip route-cache
  speed 100
  full-duplex
  ntp broadcast client
  l2-filter bridge-group-acl
  no cdp enable
  bridge-group 1
  no bridge-group 1 source-learning
  bridge-group 1 spanning-disabled
!
interface BVI1
  ip address 10.154.91.11 255.255.255.0
  no ip route-cache
!
ip default-gateway 10.154.91.254
ip http server
ip http help-path
radius-server host 10.154.99.65 auth-port 1812 acct-port 1813 timeout 3 
key xxxxx
radius-server retransmit 3
radius-server authorization permit missing Service-Type
bridge 1 route ip


-- 
--  Jean-Paul Chapalain - GICM -  Reseaux et Systemes Distribues
--  32 rue Mirabeau - Le Relecq-Kerhuon - 29808 Brest Cedex 9, FRANCE
--  Tel +33298002873 - Fax +33298284005 - Jean-Paul.Chapalain@gicm.fr
--  Key Fingerprint: 192C 1CFE F24A 050D F280 A086 AF15 8631 3ABB 4C7D



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?3F8D2D52.4060200>