Date: Thu, 24 Jul 2003 20:51:12 +0300 From: richard@uclinux.net To: freebsd-sparc64@freebsd.org Subject: Re: installing 5.1 on sunblade 100 Message-ID: <r02000000-1026-6AB10C7CBDFF11D793CF00039387ACB6@[10.0.1.200]>
next in thread | raw e-mail | index | archive | help
> On Thu, Jul 24, 2003 at 06:44:13PM +0300, richard@uclinux.net wrote: > > Good eveing (o; > > > > Hope there are some Sparc users out there (o; > > > > > > All my friends convinced me to try FreeBSD 5.1 on my Sunblade 100... > > > > After I could manage to finally boot from CDROM it just hangs after > > trying to mount rootfs "ufs:/dev/md0"... > > > > Last messages: > > > > Mounting root from ufs:/dev/md0 > > Invalid time in real time clock. > > Check and reset the date immediately! > > > > > > btw: what happened to "loader-tftp.gz" and the other files > > for booting over tftp? > > Just to check: are you booting from serial console? System > console isn't really supported (AFAIK). I was able to install > -CURRENT on my Blade 100 (as have many others) several months ago > using the serial console. > > Regards, Just the same (o; Booting [/boot/kernel/kernel]... nothing to autoload yet. jumping to kernel entry at 0xc0040000. Copyright (c) 1992-2003 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 5.1-RELEASE #0: Thu Jun 5 11:39:19 GMT 2003 root@sparkle.attlabs.net:/usr/obj/usr/src/sys/GENERIC Preloaded elf kernel "/boot/kernel/kernel" at 0xc0828000. Preloaded mfs_root "/boot/mfsroot" at 0xc0828190. Timecounter "tick" frequency 502000000 Hz real memory = 775069696 (739 MB) avail memory = 743071744 (708 MB) cpu0: Sun Microsystems UltraSparc-IIe Processor (502.00 MHz CPU) md0: Preloaded image </boot/mfsroot> 4194304 bytes at 0xc0424ca0 nexus0: <OpenFirmware Nexus device> pcib0: <U2P UPA-PCI bridge> on nexus0 pcib0: Sabre (US-IIe) compatible, impl 0, version 0, ign 0x7c0, bus A DVMA map: 0xc0000000 to 0xc3ffffff pci0: <PCI bus> on pcib0 pci0: <old, non-VGA display device> at device 3.0 (no driver attached) pcib1: <PCI-PCI bridge> at device 5.0 on pci0 pci1: <PCI bus> on pcib1 isab0: <PCI-ISA bridge> at device 7.0 on pci0 isa0: <ISA bus> on isab0 pci0: <multimedia, audio> at device 8.0 (no driver attached) ebus0: revision 0x01 ebus0: <idprom>: incomplete ebus0: <PCI-EBus3 bridge> mem 0xf1000000-0xf17fffff,0xf0000000-0xf0ffffff at device 12.0 on pci0 ebus0: <flashprom> addr 0-0xfffff (no driver attached) eeprom0: <EBus EEPROM/clock> addr 0x100000000-0x100001fff on ebus0 eeprom0: model mk48t59 eeprom0: hostid 8308434c gem0: <Sun ERI 10/100 Ethernet Adaptor> mem 0x400000-0x41ffff irq 6 at device 12.1 on pci0 miibus0: <MII bus> on gem0 ukphy0: <Generic IEEE 802.3u media interface> on miibus0 ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto gem0: Ethernet address: 00:03:ba:08:43:4c, 2KB RX fifo, 2KB TX fifo fwohci0: vendor=108e, dev=1102 fwohci0: <1394 Open Host Controller Interface> mem 0x422000-0x4227ff,0x420000-0x4207ff irq 28 at device 12.2 on pci0 stray vector interrupt 2014 fwohci0: OHCI version 1.0 (ROM=0) fwohci0: No. of Isochronous channel is 4. fwohci0: EUI64 00:03:ba:ff:fe:08:43:4c fwohci0: Phy 1394a available S400, 2 ports. fwohci0: Link S400, max_rec 2048 bytes. firewire0: <IEEE1394(FireWire) bus> on fwohci0 if_fwe0: <Ethernet over FireWire> on firewire0 if_fwe0: Fake Ethernet address: 02:03:ba:08:43:4c sbp0: <SBP2/SCSI over firewire> on firewire0 fwohci0: Initiate bus reset pci0: <serial bus, USB> at device 12.3 (no driver attached) atapci0: <AcerLabs Aladdin UDMA66 controller> port 0xa20-0xa2f,0xa08-0xa0b,0xa10-0xa17,0xa18-0xa1b,0xa00-0xa07 irq 12 at device 13.0 on pci0 ata2: at 0xa00 on atapci0 ata3: at 0xa10 on atapci0 pci0: <display, VGA> at device 19.0 (no driver attached) Timecounters tick every 10.000 msec fwohci0: BUS reset fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me) firewire0: bus manager 0 (me) ad0: 117246MB <Maxtor 6Y120L0> [238216/16/63] at ata2-master UDMA66 acd0: CDROM <LTN485S> at ata2-slave PIO4 Mounting root from ufs:/dev/md0 Invalid time in real time clock. Check and reset the date immediately! best regards rick
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?r02000000-1026-6AB10C7CBDFF11D793CF00039387ACB6>