Date: Tue, 30 Oct 2012 12:12:07 -0400 From: Adam McDougall <mcdouga9@egr.msu.edu> To: freebsd-net@freebsd.org Subject: Re: bxe + if_lagg Message-ID: <508FFC57.6040302@egr.msu.edu> In-Reply-To: <508FF0F9.9020105@freebsd.org> References: <508FF0F9.9020105@freebsd.org>
next in thread | previous in thread | raw e-mail | index | archive | help
On 10/30/12 11:23, Tom Judge wrote: > -----BEGIN PGP SIGNED MESSAGE----- > Hash: SHA1 > > > > I am trying to get if_lagg working in an HP blade for failover between > the 2 in chassis cisco switches, but it would seem that the link state > is not being propagated up to the lagg device. > > Any hints/ideas? > > > > dmesg: > bxe1: <Broadcom NetXtreme II BCM57711E 10GbE (A0) BXE v:1.5.52 > bxe1: Ethernet address: 00:25:b3:a8:76:e4 > bxe1: ASIC (0x16500000); Rev (A0); Bus (PCIe x4, 5Gbps); Flags > (MSI-X); Queues (RSS:16); BD's (RX:510,TX:255); Firmware (5.2.13); > Bootcode (4.8.0) > > > > bxe1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 > mtu 1500 > options=1bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4> > ether 00:25:b3:a8:76:e4 > nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> > media: Ethernet autoselect (10Gbase-SR <full-duplex>) > status: active > > lagg0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 > mtu 1500 > options=1bb<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU,VLAN_HWCSUM,TSO4> > ether 00:25:b3:a8:76:e4 > nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL> > media: Ethernet autoselect > status: no carrier > laggproto failover > laggport: bxe1 flags=1<MASTER> Do you need two physical interfaces configured for failover mode to do any good?
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?508FFC57.6040302>