Date: Thu, 24 Aug 95 12:09:02 JST From: purna@cs.shizuoka.ac.jp To: hackers@freebsd.org Subject: Help installing IDE CD-ROM driver Message-ID: <9508240309.AA01210@jaguar.cs.shizuoka.ac.jp>
next in thread | raw e-mail | index | archive | help
Hi, there! I'm new at this mailing list. I'm sorry if this question is a FAQ. I just tried installing IDE CD-ROM driver (I got from ftp://ftp.freebsd.org/pub/ FreeBSD/incoming/wcd11.tgz) into FreeBSD 2.0.5ALPHA but with no success. >From the "dmesg", see below, I could see that at least the kernel recognized the CD-ROM drive. But, it showed that the controller (atapi1.0) were not ready so that I could not access the drive. ... wdc0 at 0x1f0-0x1f7 irq 14 on isa wdc0: unit 0(wd0) : <WDC AC31600H> wd0: 1549 MB (3173184 sectors), 3148 cyls, 16 heads, 63 S/T, 512 B/S wdc0: unit 1(wd1) : <WDC AC31200F> wd1: 1222 MB (2503872 sectors), 2484 cyls, 16 heads, 63 S/T, 512 B/S wdc1 at 0x170-0x177 irq 15 on isa ==> wdc1: unit 0 (atapi) : <CD-ROM CDR-C3 G>, removable, intr ==> atapi1.0: controller not ready ... By the way, the following are about my system: - Gateway P5-120XL with: - WD31600 HD set as a master in the primary IDE controller - WD31200 HD set as a slave in the primary IDE controller - Sanyo 3-Disk CD-ROM (3-CD Changer) drive set as a master in the secondary IDE controller - The CD-ROM drive works well with Linux although I can use only the bottom slot. Does anybody know the solution ? Please help. Thanks a lot in advance. Regards, Yusuf Wilajati Purna Dept. of Comp. Sci. Grad. School of Elec. Sci. & Tech. Shizuoka University, JAPAN (purna@cs.shizuoka.ac.jp)
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?9508240309.AA01210>