Date: Fri, 18 May 2001 20:44:53 -0400 From: Bill/Carolyn Pechter <pechter@shell.monmouth.com> To: stable@freebsd.org Subject: MFS Changes? Message-ID: <20010518204453.A26901@shell.monmouth.com>
next in thread | raw e-mail | index | archive | help
Folks,
My Friday test auto-build of 4.x-STABLE has just run into the following
errors at the console when using an MFS /tmp filesystem which worked
fine with last week's build:
Has MFS changed significantly in -STABLE? I build the world and the
kernel at the same time and see no errors in the build.
mfs_badop[vop_createvobject]
mfs_badop[vop_createvobject] = 0
mfs_badop[vop_getvobject]
mfs_badop[vop_getvobject] = 22
Any comments/info?
Here's some of the dmesg output.
Copyright (c) 1992-2001 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.3-STABLE #0: Fri May 18 13:04:26 EDT 2001
root@i4got.pechter.dyndns.org:/usr/src/sys/compile/I4GOT
Timecounter "i8254" frequency 1193182 Hz
CPU: AMD-K6(tm) 3D processor (451.02-MHz 586-class CPU)
Origin = "AuthenticAMD" Id = 0x58c Stepping = 12
Features=0x8021bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,PGE,MMX>
AMD Features=0x80000800<SYSCALL,3DNow!>
real memory = 134152192 (131008K bytes)
avail memory = 126173184 (123216K bytes)
Preloaded elf kernel "kernel" at 0xc044e000.
ccd0-3: Concatenated disk drivers
K6-family MTRR support enabled (2 registers)
md0: Malloc disk
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <VIA 82C598MVP (Apollo MVP3) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <S3 Trio3D/2X graphics accelerator> at 0.0
isab0: <VIA 82C586 PCI-ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <VIA 82C586 ATA33 controller> at device 7.1 on pci0
atapci0: Busmastering DMA not supported
uhci0: <VIA 83C572 USB controller> port 0xe000-0xe01f irq 11 at device 7.2 on pci0
usb0: <VIA 83C572 USB controller> on uhci0
usb0: USB revision 1.0
uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
pcib2: <PCI to PCI bridge (vendor=1106 device=3040)> at device 7.3 on pci0
sym0: <875> port 0xe800-0xe8ff mem 0xee002000-0xee002fff,0xee000000-0xee0000ff irq 15 at device 9.0 on pci0
sym0: Symbios NVRAM, ID 7, Fast-20, SE, parity checking
sym0: open drain IRQ line driver, using on-chip SRAM
sym0: using LOAD/STORE-based firmware.
sym1: <815> port 0xec00-0xecff mem 0xee001000-0xee0010ff irq 5 at device 10.0 on pci0
sym1: Symbios NVRAM, ID 7, Fast-10, SE, parity checking
sym1: open drain IRQ line driver
sym1: using NCR-generic firmware.
vt0 on isa0
vt0: unkown s3, 80 col, color, 5 scr, mf2-kbd, [R3.20-b24]
vt0: driver is using old-style compatability shims
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
fd1: <1200-KB 5.25" drive> on fdc0 drive 1
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
ed0 at port 0x2a0-0x2bf iomem 0xd0000-0xd3fff irq 10 on isa0
ed0: address 00:00:c0:d6:a5:57, type WD8013EPC (16 bit)
joy0 at port 0x201 on isa0
ppc0: parallel port not found.
unknown: <PNP0000> can't assign resources
unknown: <PNP0303> can't assign resources
unknown: <PNP0f13> can't assign resources
unknown: <PNP0501> can't assign resources
unknown: <PNP0700> can't assign resources
sio1: <16550A-compatible COM port> at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
DUMMYNET initialized (010124)
IP packet filtering initialized, divert enabled, rule-based forwarding enabled, default to accept, logging limited to 100 packets/entry by default
BRIDGE 010131, have 12 interfaces
-- index 1 type 6 phy 0 addrl 6 addr 00.00.c0.d6.a5.57
IPsec: Initialized Security Association Processing.
IP Filter: v3.4.16 initialized. Default = pass all, Logging = enabled
Waiting 2 seconds for SCSI devices to settle
(noperiph:sym0:0:-1:-1): SCSI BUS reset delivered.
(noperiph:sym1:0:-1:-1): SCSI BUS reset delivered.
Mounting root from ufs:/dev/da1s2a
cd0 at sym1 bus 0 target 6 lun 0
cd0: <TEAC CD-ROM CD-516S 2.0H> Removable CD-ROM SCSI-2 device
cd0: 10.000MB/s transfers (10.000MHz, offset 8)
cd0: cd present [25186 x 2048 byte records]
da0 at sym0 bus 0 target 0 lun 0
da0: <SEAGATE SX910800N 8514> Fixed Direct Access SCSI-2 device
da0: 10.000MB/s transfers (10.000MHz, offset 15), Tagged Queueing Enabled
da0: 8669MB (17755614 512 byte sectors: 255H 63S/T 1105C)
da1 at sym0 bus 0 target 1 lun 0
da1: <SEAGATE SX910800N 8514> Fixed Direct Access SCSI-2 device
da1: 10.000MB/s transfers (10.000MHz, offset 15), Tagged Queueing Enabled
da1: 8669MB (17755614 512 byte sectors: 255H 63S/T 1105C)
mfs_badop[vop_createvobject]
mfs_badop[vop_createvobject] = 0
mfs_badop[vop_getvobject]
mfs_badop[vop_getvobject] = 22
mfs_badop[vop_getvobject]
mfs_badop[vop_getvobject] = 22
mfs_badop[vop_getvobject]
--Bill
+---------------------------------------------------------------------------+
| Bill and/or Carolyn Pechter | pechter@shell.monmouth.com |
| Bill Gates is a Persian cat and a monocle away from being a villain in |
| a James Bond movie -- Dennis Miller |
+---------------------------------------------------------------------------+
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010518204453.A26901>