Date: Fri, 18 May 2001 17:54:56 -0700 From: Kris Kennaway <kris@obsecurity.org> To: Bill/Carolyn Pechter <pechter@shell.monmouth.com> Cc: stable@FreeBSD.ORG, bp@FreeBSD.org Subject: Re: MFS Changes? Message-ID: <20010518175456.C95262@xor.obsecurity.org> In-Reply-To: <20010518204453.A26901@shell.monmouth.com>; from pechter@shell.monmouth.com on Fri, May 18, 2001 at 08:44:53PM -0400 References: <20010518204453.A26901@shell.monmouth.com>
next in thread | previous in thread | raw e-mail | index | archive | help
--69pVuxX8awAiJ7fD Content-Type: text/plain; charset=us-ascii Content-Disposition: inline Content-Transfer-Encoding: quoted-printable This could be related to Boris' commits last night. Kris On Fri, May 18, 2001 at 08:44:53PM -0400, Bill/Carolyn Pechter wrote: > Folks,=20 >=20 > My Friday test auto-build of 4.x-STABLE has just run into the following > errors at the console when using an MFS /tmp filesystem which worked > fine with last week's build: >=20 > Has MFS changed significantly in -STABLE? I build the world and the > kernel at the same time and see no errors in the build. >=20 > mfs_badop[vop_createvobject] > mfs_badop[vop_createvobject] =3D 0 > mfs_badop[vop_getvobject] > mfs_badop[vop_getvobject] =3D 22 >=20 > Any comments/info? > Here's some of the dmesg output. >=20 > Copyright (c) 1992-2001 The FreeBSD Project. > Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 > The Regents of the University of California. All rights reserved. > FreeBSD 4.3-STABLE #0: Fri May 18 13:04:26 EDT 2001 > root@i4got.pechter.dyndns.org:/usr/src/sys/compile/I4GOT > Timecounter "i8254" frequency 1193182 Hz > CPU: AMD-K6(tm) 3D processor (451.02-MHz 586-class CPU) > Origin =3D "AuthenticAMD" Id =3D 0x58c Stepping =3D 12 > Features=3D0x8021bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,PGE,MMX> > AMD Features=3D0x80000800<SYSCALL,3DNow!> > real memory =3D 134152192 (131008K bytes) > avail memory =3D 126173184 (123216K bytes) > Preloaded elf kernel "kernel" at 0xc044e000. > ccd0-3: Concatenated disk drivers > K6-family MTRR support enabled (2 registers) > md0: Malloc disk > apm0: <APM BIOS> on motherboard > apm: found APM BIOS v1.2, connected at v1.2 > npx0: <math processor> on motherboard > npx0: INT 16 interface > pcib0: <Host to PCI bridge> on motherboard > pci0: <PCI bus> on pcib0 > pcib1: <VIA 82C598MVP (Apollo MVP3) PCI-PCI (AGP) bridge> at device 1.0 o= n pci0 > pci1: <PCI bus> on pcib1 > pci1: <S3 Trio3D/2X graphics accelerator> at 0.0 > isab0: <VIA 82C586 PCI-ISA bridge> at device 7.0 on pci0 > isa0: <ISA bus> on isab0 > atapci0: <VIA 82C586 ATA33 controller> at device 7.1 on pci0 > atapci0: Busmastering DMA not supported > uhci0: <VIA 83C572 USB controller> port 0xe000-0xe01f irq 11 at device 7.= 2 on pci0 > usb0: <VIA 83C572 USB controller> on uhci0 > usb0: USB revision 1.0 > uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 > uhub0: 2 ports with 2 removable, self powered > pcib2: <PCI to PCI bridge (vendor=3D1106 device=3D3040)> at device 7.3 on= pci0 > sym0: <875> port 0xe800-0xe8ff mem 0xee002000-0xee002fff,0xee000000-0xee0= 000ff irq 15 at device 9.0 on pci0 > sym0: Symbios NVRAM, ID 7, Fast-20, SE, parity checking > sym0: open drain IRQ line driver, using on-chip SRAM > sym0: using LOAD/STORE-based firmware. > sym1: <815> port 0xec00-0xecff mem 0xee001000-0xee0010ff irq 5 at device = 10.0 on pci0 > sym1: Symbios NVRAM, ID 7, Fast-10, SE, parity checking > sym1: open drain IRQ line driver > sym1: using NCR-generic firmware. > vt0 on isa0 > vt0: unkown s3, 80 col, color, 5 scr, mf2-kbd, [R3.20-b24] > vt0: driver is using old-style compatability shims > atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 > atkbd0: <AT Keyboard> irq 1 on atkbdc0 > psm0: <PS/2 Mouse> irq 12 on atkbdc0 > psm0: model Generic PS/2 mouse, device ID 0 > vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 > fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 > fdc0: FIFO enabled, 8 bytes threshold > fd0: <1440-KB 3.5" drive> on fdc0 drive 0 > fd1: <1200-KB 5.25" drive> on fdc0 drive 1 > sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 > sio0: type 16550A > ed0 at port 0x2a0-0x2bf iomem 0xd0000-0xd3fff irq 10 on isa0 > ed0: address 00:00:c0:d6:a5:57, type WD8013EPC (16 bit)=20 > joy0 at port 0x201 on isa0 > ppc0: parallel port not found. > unknown: <PNP0000> can't assign resources > unknown: <PNP0303> can't assign resources > unknown: <PNP0f13> can't assign resources > unknown: <PNP0501> can't assign resources > unknown: <PNP0700> can't assign resources > sio1: <16550A-compatible COM port> at port 0x2f8-0x2ff irq 3 on isa0 > sio1: type 16550A > DUMMYNET initialized (010124) > IP packet filtering initialized, divert enabled, rule-based forwarding en= abled, default to accept, logging limited to 100 packets/entry by default > BRIDGE 010131, have 12 interfaces > -- index 1 type 6 phy 0 addrl 6 addr 00.00.c0.d6.a5.57 > IPsec: Initialized Security Association Processing. > IP Filter: v3.4.16 initialized. Default =3D pass all, Logging =3D enabled > Waiting 2 seconds for SCSI devices to settle > (noperiph:sym0:0:-1:-1): SCSI BUS reset delivered. > (noperiph:sym1:0:-1:-1): SCSI BUS reset delivered. > Mounting root from ufs:/dev/da1s2a > cd0 at sym1 bus 0 target 6 lun 0 > cd0: <TEAC CD-ROM CD-516S 2.0H> Removable CD-ROM SCSI-2 device=20 > cd0: 10.000MB/s transfers (10.000MHz, offset 8) > cd0: cd present [25186 x 2048 byte records] > da0 at sym0 bus 0 target 0 lun 0 > da0: <SEAGATE SX910800N 8514> Fixed Direct Access SCSI-2 device=20 > da0: 10.000MB/s transfers (10.000MHz, offset 15), Tagged Queueing Enabled > da0: 8669MB (17755614 512 byte sectors: 255H 63S/T 1105C) > da1 at sym0 bus 0 target 1 lun 0 > da1: <SEAGATE SX910800N 8514> Fixed Direct Access SCSI-2 device=20 > da1: 10.000MB/s transfers (10.000MHz, offset 15), Tagged Queueing Enabled > da1: 8669MB (17755614 512 byte sectors: 255H 63S/T 1105C) > mfs_badop[vop_createvobject] > mfs_badop[vop_createvobject] =3D 0 > mfs_badop[vop_getvobject] > mfs_badop[vop_getvobject] =3D 22 > mfs_badop[vop_getvobject] > mfs_badop[vop_getvobject] =3D 22 > mfs_badop[vop_getvobject] >=20 > --Bill > +------------------------------------------------------------------------= ---+ > | Bill and/or Carolyn Pechter | pechter@shell.monmouth.com = | > | Bill Gates is a Persian cat and a monocle away from being a villain i= n | > | a James Bond movie -- Dennis Miller = |=20 > +------------------------------------------------------------------------= ---+ >=20 > To Unsubscribe: send mail to majordomo@FreeBSD.org > with "unsubscribe freebsd-stable" in the body of the message --69pVuxX8awAiJ7fD Content-Type: application/pgp-signature Content-Disposition: inline -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.0.5 (FreeBSD) Comment: For info see http://www.gnupg.org iD8DBQE7BcReWry0BWjoQKURAkk4AJ9S9XEPEIBHtlj/iWBY7zfEaSZtmgCcD32p YrE5ipU9lu/fgXBKnvYQvRE= =finn -----END PGP SIGNATURE----- --69pVuxX8awAiJ7fD-- To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-stable" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010518175456.C95262>