Date: Tue, 2 Dec 2003 14:20:43 -0800 (PST) From: Davis Doherty <doherty@math.washington.edu> To: freebsd-questions@freebsd.org Subject: pcm, cbb problems in 5.1 w/Thinkpad Message-ID: <Pine.LNX.4.58.0312021409010.1680@zeno1.math.washington.edu>
next in thread | raw e-mail | index | archive | help
aI've been trying to get FreeBSD 5.1 running on an inherited Thinkpad 600 (my first foray into both laptops and the 5.x tree), and I have stumbled a little bit in properly configuring the kernel. I have not found any solutions in the archives for these, so any suggestions would be heartily appreciated (especially ones that work). First off, I included the line device pcm in my kernel, compiled, and installed. The result (as reported by dmesg) was as follows: pcm1: <CS423x> on isa0 device_probe_and_attach: pcm1 attach returned 6 unknown: <PNP0e03> can't assign resources (port) unknown: <PNP0e03> can't assign resources (port) unknown: <PNP0680> can't assign resources (port) unknown: <PNP0680> can't assign resources (port) I then tried putting the following lines in device.hints (though this file is one of the aspects of 5.1 I'm still unfamiliar with): hint.pcm.0.at="isa" hint.pcm.0.irq="5" hint.pcm.0.drq="1" hint.pcm.0.flags="0x0" The result was the same. A less important issue (since I don't currently use any PCMCIA cards) is with cbb0: cbb0: <TI1250 PCI-CardBus Bridge> mem 0x20301000-0x20301fff at device 2.0 on pci 0 cardbus0: <CardBus bus> on cbb0 pccard0: <16-bit PCCard bus> on cbb0 cbb: Unable to map IRQ... device_probe_and_attach: cbb0 attach returned 12 cbb0: <TI1250 PCI-CardBus Bridge> mem 0x20300000-0x20300fff at device 2.1 on pci 0 cardbus1: <CardBus bus> on cbb0 pccard1: <16-bit PCCard bus> on cbb0 cbb: Unable to map IRQ... device_probe_and_attach: cbb0 attach returned 12 Similar output occurs for cardbus1, cardbus2, and cardbus3. -Davis Doherty
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?Pine.LNX.4.58.0312021409010.1680>