From owner-aic7xxx Wed Jul 12 1:54:38 2000 Delivered-To: aic7xxx@freebsd.org Received: from sparky.dba.dk (sparky.dba.dk [129.142.136.112]) by hub.freebsd.org (Postfix) with SMTP id 71A0937BA68 for ; Wed, 12 Jul 2000 01:54:32 -0700 (PDT) (envelope-from Steffen.Hansen@dba.dk) Received: from dbamail by sparky.dba.dk via smtpd (for hub.FreeBSD.ORG [204.216.27.18]) with SMTP; 12 Jul 2000 09:53:34 UT Received: by DBAMAIL with Internet Mail Service (5.5.2650.21) id <3WW7DSLS>; Wed, 12 Jul 2000 10:54:57 +0200 Message-ID: <8C481B317D91D31191E400600862AB1808DED2@DBAMAIL> From: Steffen Hansen To: "'aic7xxx@freebsd.org'" Subject: Problems with Adaptec 29160..... Date: Wed, 12 Jul 2000 10:54:56 +0200 MIME-Version: 1.0 X-Mailer: Internet Mail Service (5.5.2650.21) Content-Type: text/plain; charset="iso-8859-1" Content-Transfer-Encoding: quoted-printable Sender: owner-aic7xxx@FreeBSD.ORG Precedence: bulk X-Loop: FreeBSD.org Hi.... And btw. I'm new so bear with me.... I'm trying to install a new Linux RH6.2/Oracle=20 server with an Adaptec 29160 controller. So far there's only two IBM18.5Gig drives attached to the controller, but more will follow. The installation of RH6.2 causes no problems, but when RH6.2 boots the std. SMP kernel, the following messages appears when the Adaptec driver loads : ------------------------------------------------------------------------= ---- (scsi0) found at PCI = 0/16/0 (scsi0) Wide Channel, SCSI ID=3D7, 32/255 SCBs (scsi0) Downloaded sequencer code... 392 instructions downloaded scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.2.1/5.2.0 scsi : 1 host scsi : aborting command due to timeout : pid 0, scsi0, channel 0, id 0, = lun 0 In quiry 00 00 00 ff 00 (scsi0) BRKADRINT error (0xff): Illegal Host Access Illegal Sequencer address referenced Illegal Opcode in sequencer program Sequencer Ram Parity Error Data-Path Ram Parity Error Scratch Ram/SCB Array Ram Parity Error PCI Error detected CIOBUS Parity Error (scsi0) SEQADDR=3D0x1ff Kernel panic: aic7xxx: unrecoverable BRKADRINT In interrupt handler - not syncing ------------------------------------------------------------------------= ---- This happens with the std. SMP kernel as well as with Kernel 2.4.0-test1/2 The driver version in the 2.2.14 kernel is 5.1.28 and 2.4.0 reports 5.2.1... It does NOT however die when using the linux-up kernel that comes with RH6.2..... I hope that you're able to help me... Kindest regards and tanx in advance.. Steffen Hansen Den Bl=E5 Avis A/S, Denmark To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe aic7xxx" in the body of the message