Date: Tue, 28 Aug 2001 14:45:48 -0600 From: "Mike Roest" <bsd-lists@blahz.ab.ca> To: "'John Carri'" <JGCARRI@paccd.cc.ca.us>, <freebsd-questions@FreeBSD.ORG> Subject: RE: Realtek 8139 wants same irq as VGA - fixes? Message-ID: <000001c13002$6b23ca20$d6444018@zeus> In-Reply-To: <3B8BEBD8.DAE531F2@paccd.cc.ca.us>
next in thread | previous in thread | raw e-mail | index | archive | help
You can try downloading ftp://210.192.0.122/lancard/drivers/8139/rset8139.exe this. And booting up off a DOS boot floppy, to try to set the card to a IRQ. The other option would be to move the NIC to another slot as that may cause it to grab a different IRQ. --Mike -----Original Message----- From: owner-freebsd-questions@FreeBSD.ORG [mailto:owner-freebsd-questions@FreeBSD.ORG] On Behalf Of John Carri Sent: Tuesday, August 28, 2001 1:07 PM To: freebsd-questions@FreeBSD.ORG; jgcarri@paccd.cc.ca.us Subject: Realtek 8139 wants same irq as VGA - fixes? Hi, I'm a FreeBSD newbie trying to get a small ethernet network going. I have FreeBSD 4.2 running on a 200MHz Pentium (Sony Vaio). I first installed a 3Com 3c509b card, and even after installing and configuring it correctly experienced up to 95% packet loss and 60-second response times to a ping from the other end of a single crossover cable (!). I replaced the 3c509b with an off-brand PCI ethernet card that uses the Realtek 8139 chipset. Installation went smoothly, dmesg reports no errors, and I now have 0% packet loss and sub millisecond ping response times. All good news so far. The problem is that the Realtek card grabbed irq 10, and the VGA adapter wants the same irq, according to dmesg. As a result I can only run in command line mode, attempts to run xinit result in a handful of errors and failure. I thought that two devices on a PCI bus could share irqs, but evidently the Realkek card and my VGA don't agree (xinit worked fine before I installed the NIC). Is there a way to tell the Realtek card to use a different irq, or a way to tell FreeBSD 4.2 to assign it a different irq? Can the Realtek card have PlugNPlay turned off and be configured to a specific irq with some kind of DOS configure utility, like the 3c509, and if so, where can I find this utility? So far I have failed to find it on the Web. TIA, -John Carri To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?000001c13002$6b23ca20$d6444018>