Skip site navigation (1)Skip section navigation (2)
Date:      Sat, 5 Jun 2004 19:40:20 -0700 (PDT)
From:      Nate Lawson <nate@root.org>
To:        j.e.drews@att.net
Cc:        current@freebsd.org
Subject:   Re: ACPI Error: AE_NO_HARDWARE_RESPONSE
Message-ID:  <20040605193808.F62622@root.org>
In-Reply-To: <060620040144.20206.40C2770F0006CF6900004EEE21603759649C990A9D0BD20AD206@att.net>
References:  <060620040144.20206.40C2770F0006CF6900004EEE21603759649C990A9D0BD20AD206@att.net>

next in thread | previous in thread | raw e-mail | index | archive | help
On Sun, 6 Jun 2004 j.e.drews@att.net wrote:
>  I have followed your instructions and the output of dmesg is here:
>
> http://www.silbsd.org/bugreports/acpi.dmesg.txt
>
>  I installed the debug inof in loader.conf and I loaded the acpi.ko with the load command.
>
> partial output of dmesg:
>
> 	The Regents of the University of California. All rights reserved.
> FreeBSD 5.2-CURRENT #0: Sat Jun  5 00:29:09 CDT 2004
>     root@notebook.silbsd.org:/usr/obj/usr/src/sys/NOTEBOOK
> Preloaded elf kernel "/boot/kernel/kernel" at 0xc0a61000.
> Preloaded kld "/acpi.ko" at 0xc0a61244.
                 ^^^^^^^

This indicates you didn't copy acpi.ko to / and maybe copied acpi.kld.
Thus there is no debugging output.  If it was acpi.ko, it would be labeled
"elf module" as below:

> Preloaded elf module "/boot/kernel/acpi.ko" at 0xc0a6127c.
                         ^^^^^^^^^^^^^^^^^^^

Since the kld was not the kernel module, your kernel went and loaded the
original acpi.ko from /boot/kernel, which doesn't have debugging enabled.

Please check against the instructions I list again below:

-Nate

> > This is harmless but you can help solve it by recompiling your acpi
> > module:
> >
> > cd /sys/modules/acpi/acpi && make ACPI_DEBUG=1 && cp acpi.ko /
> >
> > Then enable debugging prints by adding this to /boot/loader.conf:
> >
> > debug.acpi.layer="ACPI_POWER"
> > debug.acpi.level="ACPI_LV_OBJECTS ACPI_LV_ALL_EXCEPTIONS"
> >
> > Then reboot, load /acpi.ko at the loader prompt, and send me your full
> > dmesg, including all debug prints and errors.
>



Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20040605193808.F62622>