Date: Sat, 14 May 2011 19:13:44 -1000 From: bruce@hawaii-pacific.com To: freebsd-stable@freebsd.org Subject: Re: setting usb disc to da1 Message-ID: <4DCF6108.1060403@hawaii-pacific.com> In-Reply-To: <099343A5-890F-464D-89DF-593DB7C651FF@gsoft.com.au> References: <4DCC5358.4050705@chef-ingenieur.de> <34458417-0D7A-493E-8C52-F3095000D764@gsoft.com.au> <4DCE9A88.2030500@chef-ingenieur.de> <099343A5-890F-464D-89DF-593DB7C651FF@gsoft.com.au>
next in thread | previous in thread | raw e-mail | index | archive | help
Daniel O'Connor wrote: > On 15/05/2011, at 24:36, Thomas Krause wrote: > >> I'm not sure with /boot/devices.hint. Could you give me a hint, how to >> set >> >> # camcontrol devlist >> <AMCC 9500S-4LP DISK 2.08> at scbus0 target 0 lun 0 (da0,pass0) >> <Samsung G3 Station> at scbus1 target 0 lun 0 (pass1,da1) >> >> the Samsung G3 permanently to da1 (the AMCC must be da0). >> (This is a productive system and I don't want to do tests ...) >> > I think the following will work.. > > hint.scbus.0.at="twa0" > hint.da.0.at="scbus1" > > hint.scbus.1.at="umass-sim0" > hint.da.1.at="scbus0" > > Unfortunately I can't check the system I tested this on at the moment. > > I would strongly suggest you use glabel& UFS IDs (or GPT IDs if you used GPT when installing) in fstab rather than wiring device nodes. > > -- > Daniel O'Connor software and network engineer > for Genesis Software - http://www.gsoft.com.au > "The nice thing about standards is that there > are so many of them to choose from." > -- Andrew Tanenbaum > GPG Fingerprint - 5596 B766 97C0 0E94 4347 295E E593 DC20 7B3F CE8C > > > > > > > _______________________________________________ > freebsd-stable@freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-stable > To unsubscribe, send any mail to "freebsd-stable-unsubscribe@freebsd.org" > > I think I have an answer to your problem. "man glabel". Backup all data first! glabel label -v usr /dev/da1 newfs /dev/label/usr mount /dev/label/usr /usr [...] umount /usr glabel stop usr glabel unload I got that unload is unavailable but it everything worked for me. Check the man page. Hope this helps. Bruce
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?4DCF6108.1060403>