Date: Wed, 13 Feb 2002 10:08:28 +0100 From: Christoph Kukulies <kuku@gilberto.physik.RWTH-Aachen.DE> To: "M. Warner Losh" <imp@village.org> Cc: kuku@gilberto.physik.rwth-aachen.de, freebsd-mobile@FreeBSD.ORG Subject: Re: no PC-CARD slot Message-ID: <20020213100828.C22785@gil.physik.rwth-aachen.de> In-Reply-To: <20020213.005404.16315641.imp@village.org>; from imp@village.org on Wed, Feb 13, 2002 at 12:54:04AM -0800 References: <200202121705.g1CH5LV17193@gilberto.physik.RWTH-Aachen.DE> <20020212.153721.107142951.imp@village.org> <20020213083738.A22235@gil.physik.rwth-aachen.de> <20020213.005404.16315641.imp@village.org>
next in thread | previous in thread | raw e-mail | index | archive | help
On Wed, Feb 13, 2002 at 12:54:04AM -0800, M. Warner Losh wrote:
> In message: <20020213083738.A22235@gil.physik.rwth-aachen.de>
> Christoph Kukulies <kuku@gilberto.physik.RWTH-Aachen.DE> writes:
> : It's not there. It was there with 4.4 R. Maybe because there is no .hints
> : entry? In previous boots I saw wi0 as 0x240-0x27f irq 11.
>
> I'm not sure... Can you send a dmesg? It doesn't use .hints at all.
(not sure whether I did a group reply on previous post, thus again:)
Here's the actual dmesg:
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 5.0-CURRENT #1: Wed Feb 13 08:40:25 GMT 2002
root@:/usr/src/sys/i386/compile/KUKUBOOKNEW
Preloaded elf kernel "/boot/kernel/kernel" at 0xc0404000.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc04040a8.
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium III/Pentium III Xeon/Celeron (996.68-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x68a Stepping = 10
Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
real memory = 268345344 (262056K bytes)
avail memory = 256884736 (250864K bytes)
Pentium Pro MTRR support enabled
Using $PIR table, 10 entries at 0xc00fbc20
apm0: <APM BIOS> on motherboard
apm0: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: Other PM system enabled.
pcib0: <Intel 82815 (i815 GMCH) Host To Hub bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
pcib1: <PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <display, VGA> at device 0.0 (no driver attached)
pcib2: <PCI-PCI bridge> at device 30.0 on pci0
pci2: <PCI bus> on pcib2
pci2: <multimedia, audio> at device 3.0 (no driver attached)
pcib3: <PCI-PCI bridge> at device 6.0 on pci2
pci3: <PCI bus> on pcib3
fxp0: <Intel Pro 10/100B/100+ Ethernet> port 0xecc0-0xecff mem 0xf8e00000-0xf8efffff,0xf8fff000-0xf8ffffff irq 11 at device 4.0 on pci3
fxp0: Ethernet address 00:20:e0:69:17:62
inphy0: <i82555 10/100 media interface> on miibus0
inphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
pci3: <simple comms> at device 8.0 (no driver attached)
pcic0: <TI PCI-4451 PCI-CardBus Bridge> irq 11 at device 15.0 on pci2
pcic0: Could not grab register memory
device_probe_and_attach: pcic0 attach returned 12
pcic0: <TI PCI-4451 PCI-CardBus Bridge> irq 11 at device 15.1 on pci2
pcic0: Could not grab register memory
device_probe_and_attach: pcic0 attach returned 12
pci2: <serial bus, FireWire> at device 15.2 (no driver attached)
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH2 ATA100 controller> port 0xbfa0-0xbfaf at device 31.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> port 0xbce0-0xbcff irq 11 at device 31.2 on pci0
usb0: <Intel 82801BA/BAM (ICH2) USB controller USB-A> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
ata: ata0 already exists; skipping it
ata: ata1 already exists; skipping it
sc: sc0 already exists; skipping it
vga: vga0 already exists; skipping it
orm0: <Option ROMs> at iomem 0xcf800-0xcffff,0xcf000-0xcf7ff,0xce800-0xcefff,0xce000-0xce7ff,0xcd800-0xcdfff,0xcd000-0xcd7ff,0xc0000-0xccfff on isa0
fdc0: <enhanced floppy controller (i82077, NE72065 or clone)> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model 4D Mouse, device ID 6
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
pmtimer0 on isa0
pcic0: <Intel i82365SL-DF> at port 0x3e0 iomem 0xd0000 irq 10 on isa0
pcic0: management irq 10
pccard0: <PC Card bus (classic)> on pcic0
pccard1: <PC Card bus (classic)> on pcic0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/8 bytes threshold
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
ad0: 28615MB <IC25N030ATDA04-0> [58140/16/63] at ata0-master UDMA100
acd0: DVD-ROM <LG DVD-ROM DRN-8080B> at ata0-slave PIO4
Mounting root from ufs:/dev/ad0s2a
pccard: card inserted, slot 1
>
> Warner
>
> To Unsubscribe: send mail to majordomo@FreeBSD.org
> with "unsubscribe freebsd-mobile" in the body of the message
--
--Chris Christoph P. U. Kukulies kuku@gil.physik.rwth-aachen.de
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-mobile" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20020213100828.C22785>