Date: Wed, 8 Mar 2000 20:45:34 +0100 From: "Morten Seeberg" <morten@seeberg.dk> To: <current@freebsd.org> Subject: RC3: APM on IBM Thinkpad 600E (2645,5A0) Message-ID: <000f01bf8936$e0be2420$deff58c1@sos>
next in thread | raw e-mail | index | archive | help
Hi, I just installed RC3, and I have the same problem as on RC2, when I run
"zzz" my machine turns off the monitor, stops the disk, etc etc. Actually is
does everything itīs supposed to, except go to stand-by mode (give the beep
and turn off).
So when i press any key, the machine wakes up again?? Is this a know
problem?
All I did was to add apm_enable="YES" to rc.conf and remove the diskable in
the KERNEL line, my dmesg looks like this:
Copyright (c) 1992-2000 The FreeBSD Project.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 4.0-20000307-CURRENT #2: Wed Mar 8 20:07:09 CET 2000
root@:/usr/src/sys/compile/SOS
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium II/Pentium II Xeon/Celeron (363.96-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x66a Stepping = 10
Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,
PAT,PSE36,MMX,FXSR>
real memory = 200278016 (195584K bytes)
avail memory = 190607360 (186140K bytes)
Preloaded elf kernel "kernel" at 0xc0367000.
Pentium Pro MTRR support enabled
md0: Malloc disk
npx0: <math processor> on motherboard
npx0: INT 16 interface
apm0: <APM BIOS> on motherboard
apm: found APM BIOS v1.2, connected at v1.2
pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <NeoMagic MagicMedia 256AV SVGA controller> at 0.0 irq 11
pcic-pci0: <TI PCI-1251 PCI-CardBus Bridge> mem 0x50102000-0x50102fff irq 11
at device 2.0 on pci0
pcic-pci1: <TI PCI-1251 PCI-CardBus Bridge> mem 0x50101000-0x50101fff irq 11
at device 2.1 on pci0
csa0: <Crystal Semiconductor CS4610/4611 Audio accelerator> mem
0x50000000-0x500fffff,0x50100000-0x50100fff irq 11 at device 6.0 on pci0
pcm0: <CS461x PCM Audio> on csa0
pcm0: ac97 codec reports dac not ready
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xfcf0-0xfcff at device 7.1 on
pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pci0: <Intel 82371AB/EB (PIIX4) USB controller> at 7.2 irq 11
chip1: <Intel 82371AB Power management controller> port 0xefa0-0xefaf at
device 7.3 on pci0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <keyboard controller (i8042)> at port 0x60-0x6f on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model MouseMan+, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x200>
pcic: management irq 10
pcic0: <Intel i82365> at port 0x3e0 iomem 0xd0000 irq 10 on isa0
pccard0: <PC Card bus -- kludge version> on pcic0
pccard1: <PC Card bus -- kludge version> on pcic0
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: cannot reserve I/O port range
pccard: card inserted, slot 1
ata1-slave: ata_command: timeout waiting for intr
ata1-slave: identify failed
ad0: 6149MB <HITACHI_DK228A-65B> [13328/15/63] at ata0-master using UDMA33
acd0: DVD-ROM <TOSHIBA DVD-ROM SD-C2102> at ata1-master using PIO4
Mounting root from ufs:/dev/ad0s3a
ep0: <3Com Etherlink III 3C589> at port 0x240-0x24f irq 3 slot 1 on pccard1
ep0: Ethernet address 00:a0:24:60:02:36
ep0: supplying EUI64: 00:a0:24:ff:fe:60:02:36
ep0: unload
stray irq 3
pccard: card disabled, slot 1
resumed from suspended mode (slept 00:00:10)
pccard: card inserted, slot 1
ata0: resetting devices .. done
ata1: resetting devices .. done
ep0: <3Com Etherlink III 3C589> at port 0x240-0x24f irq 3 slot 1 on pccard1
ep0: Ethernet address 00:a0:24:60:02:36
ep0: starting DAD for fe80:0009::02a0:24ff:fe60:0236
ep0: DAD complete for fe80:0009::02a0:24ff:fe60:0236 - no duplicates found
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
/\/\orten $eeberg, Systems Consultant @
Merkantildata - Enterprise Solutions
#echo 'System Administrators suck :)' > /dev/console
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-current" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?000f01bf8936$e0be2420$deff58c1>