Date: Wed, 15 Apr 1998 13:40:14 +1000 From: Kerry Morse <kerry.morse@metro.tas.com.au> To: freebsd-questions@FreeBSD.ORG Subject: A problem with an EXABYTE 8200 and an Adaptec 1542 controller.. Message-ID: <02B01380C828D1119ED70020AF641C5306853C@MTTMail.metro.tas.gov.au>
next in thread | raw e-mail | index | archive | help
I get the following message whenever I try and access the tape drive... no problems with the disk drives hanging off the same controller... Any help greatly appreciated Apr 15 13:33:40 proxy /kernel: aha0: DMA beyond end Of ISA: 0x35c0d10 Apr 15 13:33:40 proxy /kernel: st0: bad request, must be between 0 and 0 The first answer is yes I have the options BOUNCE_BUFFERS set in the kernel... (at least I'm very sure I have)... Apr 9 14:57:32 Proxy1 /kernel: Copyright (c) 1992-1998 FreeBSD Inc. Apr 9 14:57:32 Proxy1 /kernel: Copyright (c) 1982, 1986, 1989, 1991, 1993 Apr 9 14:57:32 Proxy1 /kernel: The Regents of the University of California. All rights reserved. Apr 9 14:57:32 Proxy1 /kernel: FreeBSD 3.0-980221-SNAP #0: Sat Feb 21 11:12:44 GMT 1998 Apr 9 14:57:32 Proxy1 /kernel: root@make.ican.net:/usr/src/sys/compile/GENERIC Apr 9 14:57:32 Proxy1 /kernel: Timecounter "i8254" frequency 1193182 Hz cost 3355 ns Apr 9 14:57:32 Proxy1 /kernel: Timecounter "TSC" frequency 89302956 Hz cost 373 ns Apr 9 14:57:32 Proxy1 /kernel: CPU: Pentium (89.30-MHz 586-class CPU) Apr 9 14:57:32 Proxy1 /kernel: Origin = "GenuineIntel" Id = 0x521 Stepping=1 Apr 9 14:57:32 Proxy1 /kernel: Features=0x1bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8> Apr 9 14:57:32 Proxy1 /kernel: real memory = 67108864 (65536K bytes) Apr 9 14:57:32 Proxy1 /kernel: avail memory = 62521344 (61056K bytes) Apr 15 13:22:01 proxy /kernel: Bad BIOS32 Service Directory! Apr 15 13:22:01 proxy /kernel: Probing for devices on PCI bus 0: Apr 15 13:22:01 proxy /kernel: chip0: <Intel 82434NX (Neptune) PCI cache memory controller> rev 0x10 on pci0.0.0 Apr 15 13:22:01 proxy /kernel: chip1: <Intel 82378ZB PCI to ISA bridge> rev 0x03 on pci0.2.0 Apr 15 13:22:01 proxy /kernel: wdc0: <CMD 640B IDE> rev 0x01 int a irq 14 on pci0.3.0 Apr 15 13:22:01 proxy /kernel: Probing for devices on the ISA bus: Apr 15 13:22:01 proxy /kernel: sc0 at 0x60-0x6f irq 1 on motherboard Apr 15 13:22:01 proxy /kernel: sc0: VGA color <16 virtual consoles, flags=0x0> Apr 15 13:22:01 proxy /kernel: ed0 at 0x300-0x31f irq 10 on isa Apr 15 13:22:01 proxy /kernel: ed0: address 00:00:e8:1b:be:25, type NE2000 (16 bit) Apr 15 13:22:01 proxy /kernel: sio0 at 0x3f8-0x3ff irq 4 flags 0x10 on isa Apr 15 13:22:01 proxy /kernel: sio0: type 16550A Apr 15 13:22:01 proxy /kernel: sio1 at 0x2f8-0x2ff irq 3 on isa Apr 15 13:22:01 proxy /kernel: sio1: type 16550A Apr 15 13:22:01 proxy /kernel: lpt0 at 0x378-0x37f irq 7 on isa Apr 15 13:22:01 proxy /kernel: lpt0: Interrupt-driven port Apr 15 13:22:01 proxy /kernel: lp0: TCP/IP capable interface Apr 15 13:22:01 proxy /kernel: psm0 not found at 0x60 Apr 15 13:22:01 proxy /kernel: fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa Apr 15 13:22:01 proxy /kernel: fdc0: FIFO enabled, 8 bytes threshold Apr 15 13:22:01 proxy /kernel: fd0: 1.44MB 3.5in Apr 15 13:22:02 proxy /kernel: aha0 at 0x130-0x133 irq 11 drq 5 on isa Apr 15 13:22:02 proxy /kernel: aha0: waiting for scsi devices to settle Apr 15 13:22:02 proxy /kernel: scbus0 at aha0 bus 0 Apr 15 13:22:02 proxy /kernel: sd0 at scbus0 target 0 lun 0 Apr 15 13:22:02 proxy /kernel: sd0: <SEAGATE ST31200N SUN1.05 8722> type 0 fixed SCSI 2 Apr 15 13:22:02 proxy /kernel: sd0: Direct-Access 1006MB (2061108 512 byte sectors) Apr 15 13:22:02 proxy /kernel: sd1 at scbus0 target 2 lun 0 Apr 15 13:22:02 proxy /kernel: sd1: <HITACHI DK326C-10 M0M0> type 0 fixed SCSI 2 Apr 15 13:22:02 proxy /kernel: sd1: Direct-Access 1004MB (2056292 512 byte sectors) Apr 15 13:22:02 proxy /kernel: sd2 at scbus0 target 3 lun 0 Apr 15 13:22:02 proxy /kernel: sd2: <SEAGATE ST11200N SUN1.05 8808> type 0 fixed SCSI 2 Apr 15 13:22:02 proxy /kernel: sd2: Direct-Access 1005MB (2059140 512 byte sectors) Apr 15 13:22:02 proxy /kernel: st0 at scbus0 target 6 lun 0 Apr 15 13:22:02 proxy /kernel: st0: <EXABYTE EXB-8200 263H> type 1 removable SCSI 1 Apr 15 13:22:02 proxy /kernel: st0: Sequential-Access density code 0x0, 1024-byte blocks, write-enabled Apr 15 13:22:02 proxy /kernel: sea0 not found Apr 15 13:22:02 proxy /kernel: 1 3C5x9 board(s) on ISA found at 0x210 Apr 15 13:22:02 proxy /kernel: ep0 at 0x210-0x21f irq 5 flags 0xa on isa Apr 15 13:22:02 proxy /kernel: ep0: aui/utp/bnc[*UTP*] address 00:20:af:6f:07:2d Apr 15 13:22:02 proxy /kernel: npx0 on motherboard Apr 15 13:22:02 proxy /kernel: npx0: INT 16 interface Apr 15 13:22:02 proxy /kernel: Intel Pentium F00F detected, installing workaround Apr 15 13:22:02 proxy /kernel: ccd0-3: Concatenated disk drivers Apr 15 13:22:03 proxy /kernel: IP packet filtering initialized, divert enabled, default to accept, logging limited to 100 packets/entry Apr 15 13:22:03 proxy /kernel: changing root device to sd0a Apr 15 13:33:40 proxy /kernel: aha0: DMA beyond end Of ISA: 0x35c0d10 Apr 15 13:33:40 proxy /kernel: st0: bad request, must be between 0 and 0 To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?02B01380C828D1119ED70020AF641C5306853C>