Date: Fri, 8 Jan 1999 17:45:58 +0200 From: "julia" <julia@fregat.dp.ua> To: <freebsd-questions@FreeBSD.ORG> Subject: I have some trouble with PCI Ethernet NE2000-like adapter Message-ID: <199901081548.RAA03116@fregat.dp.ua>
next in thread | raw e-mail | index | archive | help
Hello!
I have a PCI Ethernet card, which is (as noticed in its manual)
NE2000-compatible.
But it's not possible to specify its bus I/O address neither with jumpers
nor
with any setup program - there isn't EPROM on the card.
So, I described it as:
controller pci0
device ed0 at pci?
When system is booting, it founds this card, but as ed1, not ed0 ! Why?
No error messages generating neither during building system nor during
booting;
network interface ed1 works good.Can I make this card ed0 ? How should I
specify
it in the config file?
Sincerely yours, Mark.
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199901081548.RAA03116>