Date: Sun, 25 Nov 2001 07:27:07 +0800 From: Najib Ninaba <najib_ninaba@yahoo.com> To: Warner Losh <imp@harmony.village.org> Cc: Brooks Davis <brooks@one-eyed-alien.net>, freebsd-mobile@freebsd.org Subject: Re: pccard kernel config for OmniBook 500 Message-ID: <20011125072707.A1482@srikandi.spriggan.int> In-Reply-To: <200111222013.fAMKDi718295@harmony.village.org>; from imp@harmony.village.org on Thu, Nov 22, 2001 at 01:13:44PM -0700 References: <20011122183533.A2909@srikandi.spriggan.int> <20011119224721.A1348@srikandi.spriggan.int> <20011119104634.B12037@Odin.AC.HMC.Edu> <20011122183533.A2909@srikandi.spriggan.int> <200111222013.fAMKDi718295@harmony.village.org>
next in thread | previous in thread | raw e-mail | index | archive | help
--NMuMz9nt05w80d4+ Content-Type: multipart/mixed; boundary="XsQoSWH+UP9D9v3l" Content-Disposition: inline --XsQoSWH+UP9D9v3l Content-Type: text/plain; charset=us-ascii Content-Disposition: inline Content-Transfer-Encoding: quoted-printable Hello, After checking through the mailing-list for some clues, I just realised that the my kernel did not actually have any irq assigned to the pcic devices. Most of the dmesgs posted here have an irq after in their dmesg pcic line but not in mine. Could that be the problem of my notebook freezing whenever I plug in my card? The lines pci_cfgintr_linked and pci_cfgintr were also missing in my dmesg. Attached is my dmesg. Regards, Najib Ninaba On Thu, Nov 22, 2001 at 01:13:44PM -0700, Warner Losh wrote: > : I've tried the below-mentioned line without any success. It boots up > : normally but still freezes at the point when I plug in my aironet 350 > : card or ibm modem card. Any other leads? >=20 > Try -stable, if you aren't already, otherwise no. If I had acess to > one of these beasts, then maybe I could figure out the problem... >=20 > Warner >=20 > To Unsubscribe: send mail to majordomo@FreeBSD.org > with "unsubscribe freebsd-mobile" in the body of the message --=20 Najib Ninaba=20 "Life's unfair - but having the root password helps!" -- PGP fingerprint B338 7EC2 B737 3BAA 03B1 38C7 0832 B6CF 160F 496E -- To verify the signature, get my PGP public key at http://www.keyserver.net/en/ KeyID:0x160F496E --XsQoSWH+UP9D9v3l Content-Type: text/plain; charset=us-ascii Content-Disposition: attachment; filename="dmesg.out" Copyright (c) 1992-2001 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 4.4-STABLE #4: Tue Nov 20 05:50:14 SGT 2001 najib@srikandi.spriggan.int:/usr/obj/usr/src/sys/SRIKANDI Timecounter "i8254" frequency 1193182 Hz CPU: Pentium III/Pentium III Xeon/Celeron (746.76-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0x68a Stepping = 10 Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE> real memory = 268369920 (262080K bytes) config> di sn0 config> di lnc0 config> di ie0 config> di fe0 config> di ed0 config> di cs0 config> di bt0 config> di aic0 config> di aha0 config> di adv0 config> q avail memory = 256069632 (250068K bytes) Preloaded elf kernel "kernel" at 0xc04f2000. Preloaded userconfig_script "/boot/kernel.conf" at 0xc04f209c. Preloaded elf module "snd_maestro3.ko" at 0xc04f20ec. Preloaded elf module "snd_pcm.ko" at 0xc04f2190. Pentium Pro MTRR support enabled md0: Malloc disk Using $PIR table, 9 entries at 0xc00fdf30 apm0: <APM BIOS> on motherboard apm: found APM BIOS v1.2, connected at v1.2 npx0: <math processor> on motherboard npx0: INT 16 interface pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard pci0: <PCI bus> on pcib0 pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on pci0 pci1: <PCI bus> on pcib1 pci1: <ATI Mobility-1 graphics accelerator> at 0.0 irq 10 isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0 isa0: <ISA bus> on isab0 atapci0: <Intel PIIX4 ATA33 controller> port 0x1000-0x100f at device 7.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 uhci0: <Intel 82371AB/EB (PIIX4) USB controller> port 0x1040-0x105f irq 5 at device 7.2 on pci0 usb0: <Intel 82371AB/EB (PIIX4) USB controller> on uhci0 usb0: USB revision 1.0 uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1 uhub0: 2 ports with 2 removable, self powered uhub1: Hewlett Packard General Purpose USB Hub, class 9/0, rev 1.10/1.01, addr 2 uhub1: 3 ports with 3 removable, self powered ums0: Logitech USB Mouse, rev 1.10/6.20, addr 3, iclass 3/1 ums0: 3 buttons and Z dir. chip1: <Intel 82371AB Power management controller> port 0x2180-0x218f at device 7.3 on pci0 pcic0: <TI PCI-1410 PCI-CardBus Bridge> at device 10.0 on pci0 pcic0: PCI Memory allocated: 0x44000000 pcic0: Polling mode pcic0: TI12XX PCI Config Reg: [ring enable][speaker enable][pwr save][FUNC pci int + CSC serial isa irq] pccard0: <PC Card bus (classic)> on pcic0 xl0: <3Com 3c556 Fast Etherlink XL> port 0x1400-0x14ff mem 0xf4000000-0xf400007f,0xf4000400-0xf400047f irq 10 at device 11.0 on pci0 xl0: Ethernet address: 00:01:03:87:b2:5f miibus0: <MII bus> on xl0 ukphy0: <Generic IEEE 802.3u media interface> on miibus0 ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto pci0: <unknown card> (vendor=0x10b7, dev=0x1007) at 11.1 irq 10 pcm0: <ESS Technology Maestro3> port 0x1c00-0x1cff mem 0xf4002000-0xf4003fff irq 5 at device 13.0 on pci0 atapci1: <CMD 648 ATA66 controller> port 0x1010-0x101f,0x1140-0x1143,0x1148-0x114f,0x1120-0x1123,0x1128-0x112f irq 15 at device 17.0 on pci0 ata2: at 0x1128 on atapci1 eisa0: <EISA bus> on motherboard eisa0: unknown card @G_00ff (0x00ff00ff) at slot 1 orm0: <Option ROMs> at iomem 0xc0000-0xcffff,0xdc000-0xdffff on isa0 fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 fdc0: FIFO enabled, 8 bytes threshold fd0: <1440-KB 3.5" drive> on fdc0 drive 0 atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 kbd0 at atkbd0 psm0: <PS/2 Mouse> irq 12 on atkbdc0 psm0: model Generic PS/2 mouse, device ID 0 vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 sc0: <System console> at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 16550A sio1: configured irq 3 not in bitmap of probed irqs 0 ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0 ppc0: Generic chipset (ECP/PS2/NIBBLE) in COMPATIBLE mode ppc0: FIFO with 16/16/8 bytes threshold plip0: <PLIP network interface> on ppbus0 lpt0: <Printer> on ppbus0 lpt0: Interrupt-driven port ppi0: <Parallel I/O> on ppbus0 ad0: 28615MB <IC25N030ATDA04-0> [58140/16/63] at ata0-master UDMA33 acd0: CDROM <QSI CD-ROM SCR-242A> at ata2-master using PIO4 Mounting root from ufs:/dev/ad0s3a WARNING: / was not properly dismounted arp: 202.156.236.1 moved from 00:30:80:93:13:70 to 00:30:80:93:13:54 on xl0 --XsQoSWH+UP9D9v3l-- --NMuMz9nt05w80d4+ Content-Type: application/pgp-signature Content-Disposition: inline -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.0.6 (GNU/Linux) Comment: For info see http://www.gnupg.org iD8DBQE8ACzLCDK2zxYPSW4RAhuYAJ9tbg5/9j98bNTGwRTOVrOhbSc9AgCfXo/9 QqsKB96IJZc+cPKir1HeaqA= =FzgY -----END PGP SIGNATURE----- --NMuMz9nt05w80d4+-- To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-mobile" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20011125072707.A1482>