Skip site navigation (1)Skip section navigation (2)
Date:      Wed, 11 Apr 2007 17:11:43 -0400
From:      Mike Tancsa <mike@sentex.net>
To:        "adam radford" <aradford@gmail.com>, "freebsd@bitfreak.org" <freebsd@bitfreak.org>
Cc:        current@freebsd.org
Subject:   Re: twa(4) update to support 9550SXU/9590SE controllers
Message-ID:  <200704112111.l3BLBUaD094648@lava.sentex.ca>
In-Reply-To: <b1bc6a000610111544i2018173fi8dd40a6557930b4@mail.gmail.com >
References:  <452D709E.10904@bitfreak.org> <b1bc6a000610111544i2018173fi8dd40a6557930b4@mail.gmail.com>

next in thread | previous in thread | raw e-mail | index | archive | help
At 06:44 PM 10/11/2006, adam radford wrote:
>'vkashyap' is no longer maintaining the 3ware 'twa' driver.
>
>'twa' driver in RELENG_6 and CURRENT both support 9550SXU and
>9590SE controllers at this time.  They both have the 0x1003 device ID.
>
>I will be sending an update in the near future to support the new series of
>9650SE controllers, remove bundled firmware (we have a FreeBSD specific
>userspace firmware update utility), and remove lots of non FreeBSD specific
>code.


Hi,
         We are just in the process of evaluating the new 9650se 
cards, and RELENG_6 does not actually recognize them.

none1@pci2:0:0: class=0x010400 card=0x100413c1 chip=0x100413c1 
rev=0x01 hdr=0x00
     vendor     = '3ware Inc.'
     class      = mass storage
     subclass   = RAID
     cap 01[40] = powerspec 2  supports D0 D1 D2 D3  current D0
     cap 05[50] = MSI supports 32 messages, 64 bit
     cap 10[70] = PCI-Express 1 legacy endpoint

Are there still plans to integrate support for the newer generation 
of cards into the FreeBSD src tree ?  Using the driver off the 
website, it seems to work OK but doing installs this way is bit of a pain


twa0: <3ware 9000 series Storage Controller> port 0x3000-0x30ff mem 
0x88000000-0x89ffffff,0x8a200000-0x8a200fff irq 16 at device 0.0 on pci2
twa0: [FAST]
twa0: INFO: (0x15: 0x1300): Controller details:: Model 9650SE-2LP, 2 
ports, Firmware FE9X 3.06.00.005, BIOS BE9X 3.06.00.002
da0 at twa0 bus 0 target 0 lun 0
da0: <AMCC 9650SE-2LP DISK 3.06> Fixed Direct Access SCSI-5 device
da0: 100.000MB/s transfers
da0: 76283MB (156227584 512 byte sectors: 255H 63S/T 9724C)

         ---Mike


>-Adam
>
>On 10/11/06, freebsd@bitfreak.org <freebsd@bitfreak.org> wrote:
>>I just noticed that, based on the commit logs, the twa(4) driver is
>>still the driver from the 9.3.0.1 release from 3ware.  That version
>>doesn't support the new 9550SXU and 9590SE controllers, the later being
>>3ware's new PCI Express card.  Is anyone currently planning/testing an
>>update to the 9.3.0.7 release?  I tried emailing the only address listed
>>(vkashyap) in the logs and source, but it bounced.  So I'm not sure who
>>contact.  Should this wait until after the 6.2 release?
>>_______________________________________________
>>freebsd-current@freebsd.org mailing list
>>http://lists.freebsd.org/mailman/listinfo/freebsd-current
>>To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"
>_______________________________________________
>freebsd-current@freebsd.org mailing list
>http://lists.freebsd.org/mailman/listinfo/freebsd-current
>To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"




Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200704112111.l3BLBUaD094648>