Date: Sat, 10 Jan 1998 16:38:03 -0600 From: x <nospamkjs@neosoft.com> To: questions@freebsd.org Cc: kjs@neosoft.com Subject: [Fwd: Help: pcic Generic PCMCIA Ethernet driver (was Help: 3Com 3C589d ...)] Message-ID: <34B7F84B.2781E494@neosoft.com>
next in thread | raw e-mail | index | archive | help
This is a multi-part message in MIME format.
--------------15FB7483794BDF32446B9B3D
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit
Perhaps someone here at freebsd.org can help me to configure
the pcic generic PCMCIA ethernet driver.
----Ken Sheldon
--------------15FB7483794BDF32446B9B3D
Content-Type: message/news
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
Path: uuneo.neosoft.com!not-for-mail
From: x <nospamkjs@neosoft.com>
Newsgroups: comp.unix.bsd.freebsd.misc
Subject: Help: pcic Generic PCMCIA Ethernet driver (was Help: 3Com 3C589d ...)
Date: Sat, 10 Jan 1998 15:42:13 -0600
Organization: NeoSoft, Inc.
Message-ID: <34B7EB35.41C67EA6@neosoft.com>
References: <34B15270.41C67EA6@neosoft.com> <Wfis.1$tl1.81742@news.mt.net>
NNTP-Posting-Host: sheldon.neosoft.com
Mime-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit
X-Mailer: Mozilla 3.01 (X11; I; FreeBSD 2.2.2-RELEASE i386)
CC: nate@trout.mt.sri.com
Xref: uuneo.neosoft.com comp.unix.bsd.freebsd.misc:57226
Nate Williams wrote:
> Then, when you boot the FreeBSD kernel, make
> sure you set the zp0 device to use them with the kernel config.
>
> This is all covered in the HARDWARE.HLP file provided on the boot disk.
>
I looked at HARDWARE.TXT; it states the latest revision (ie: rev d) of
the
3C589 card is not supported by if-zp.
* The D revision is supported in new PCMCIA generic code written for
FreeBSD, but there is little/no documentation written on how to set
it up yet.
So... Can anyone help me set up the pcic driver?
So far, I have configured the following:
controller crd0
device pcic0 at crd?
device pcic1 at crd?
During boot, I see the following messages:
PC-Card Intel 82365 (5 mem & 2 I/O windows)
pcic: controller irq3
Card inserted, slot 1
Card inserted, slot 0
(The 3C589d is inserted in slot 1)
Unfortunately, I cannot use ifconfig on pcic, pcic0, or pcic1. The
ifconfig utility reports:
ifconfig: interface pcic does not exist
What do I need to do to get the pcic driver running?
--------------15FB7483794BDF32446B9B3D--
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?34B7F84B.2781E494>