Date: Sun, 11 Apr 2010 20:09:50 -0600 From: Brad Waite <brad@wcubed.net> To: freebsd-scsi@freebsd.org Subject: QLogic 2360 FC HBAs not playing well with others Message-ID: <4BC280EE.5090202@wcubed.net> References: 4BBF720A.3020300@wcubed.net
next in thread | raw e-mail | index | archive | help
> > Matthew Jacob wrote: > >> On 04/09/2010 11:29 AM, Brad Waite wrote: > >> I beseech you, oh great masters of SCSI and fibre channel, hear my > pleas > >> for help! > >> > >> My 2 QLE2360s don't appear to be waking up properly in a Dell R710 > >> running 7.2 AMD64. At the very least, they're not recognizing any of > >> the volumes on the Sun 2540 array in the fabric. Everything works just > >> fine under VMware ESXi 4.1, though. > >> > > > > Get newer firmware either by upgrading with RELENG_7 or snagging > > asm_2300.h from RELENG_7 and rebuilding. > > > > You don't have to load all of ispfw > > > > isp2300_LOAD=YES > > > > should get you just that onemodule > > > > the latest in the FreeBSD tree is 3.03.26 > > Woot. That helped. Built & installed RELENG_7, but I've got some > more wierdness. Woot. That helped. Built & installed RELENG_7, but I've got some more wierdness. First off I've got da0 - da15 showing similar to this: da0 at isp0 bus 0 target 0 lun 0 da0: <SUN LCSM100_F 0670> Fixed Direct Access SCSI-5 device da0: 200.000MB/s transfers da0: Command Queueing Enabled da0: 138989MB (284650656 512 byte sectors: 255H 63S/T 17718C) We've got a Sun Storagetek 2540 12-drive array with 4 volumes mapped to this host. It would appear that it's showing the 4 volumes AND each of the 12 drives. Is that normal? Next, I have about 20 of the following errors for each of da1, da2, da3, da4, da9, da10, da11 & da12. (da1:isp0:0:0:1): READ(6)/WRITE(6) not supported, increasing minimum_cmd_size to 10. (da1:isp0:0:0:1): READ(10). CDB: 28 0 0 0 0 0 0 0 1 0 (da1:isp0:0:0:1): CAM Status: SCSI Status Error (da1:isp0:0:0:1): SCSI Status: Check Condition (da1:isp0:0:0:1): ILLEGAL REQUEST asc:94,1 (da1:isp0:0:0:1): Vendor Specific ASC (da1:isp0:0:0:1): Unretryable error What's going on here? Is there any config I need to to for volume mapping and/or multipathing? I'm a complete newb when it comes to FC on FreeBSD, so forgive my ignorance. Thanks for the help, guys!
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?4BC280EE.5090202>