Date: Fri, 1 Jan 1999 15:42:20 +1100 From: "Leo Kliger" <leo@astea.com.au> To: "Kevin Sheehan" <kevin@planb.net.au> Cc: <freebsd-questions@FreeBSD.ORG> Subject: Re: ppp.conf script???? Message-ID: <199901010457.PAA19116@astea.com.au>
next in thread | raw e-mail | index | archive | help
thanks, not quite what i needed, but it did get me on the right track....... it was the b-channel profile selection and s register..... thanks again and have a good one.... Leo ---------- From: Kevin Sheehan <kevin@planb.net.au> To: 'Leo Kliger' <leo@astea.com.au> Subject: RE: ppp.conf script???? Date: Thursday, December 31, 1998 6:03 PM Leo, Assuming you only have the one RS232 interface on the TA (what sort of speed are you running your com port at?), then the bringing up of the second channel will be the TA (modem - whatever) responding to load. This should definitely be an option on the TA. Look for MPPP, Multilink, Bonding or similar. I have a 3com I can try and find the relevant command or S reg for if you like. Not sure if the spirit will be even close. You can bet that the charges for the second B channel will hurt if you don't stop them - or get a 2 channel XSPC or Xpress (from experience). There is also a bit of an Australian ISDN mailing list going at the moment, with people form Linux & FreeBSD camps. Let me know if you are interested and I'll try and dig out the address. Rgs Kevin. ---------- From: Leo Kliger Sent: Thursday, 31 December 1998 16:51 To: Jaye Mathisen Cc: freebsd-questions@FreeBSD.ORG Subject: Re: ppp.conf script???? yeah, i already did disable ip header compression....... no diff another thing on the subject....... we have only leased 64k but occasionally the system dials out again resulting in a 128k line...... however cute this may be it means we will attract charges we don't want....... any ideas on disabling this? either in freebsd or the spirit voyager...... i've already looked at the modems config software and manual..... i can't see anything obvious...... suggestions appreciated...... thanks Leo ---------- > From: Jaye Mathisen <mrcpu@internetcds.com> > To: Leo Kliger <leo@astea.com.au> > Subject: Re: ppp.conf script???? > Date: Thursday, December 31, 1998 2:58 PM > > > Probably nothing specifically wrong with FreeBSD, just the usual hassles > getting ISDN modems to talk... > > Also, we find that when dialling in to 3com gear, IP header compression > must be disabled... Might want to try it. > To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message ---------- To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-questions" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?199901010457.PAA19116>