Date: Thu, 2 Jan 1997 00:36:18 -0600 From: Michael Lay <n5ptn@bga.com> To: questions@freebsd.org Subject: IDE Problem? Message-ID: <2.2.16.19970102003538.268f3d60@bga.com>
next in thread | raw e-mail | index | archive | help
Is the note about IDE support being alpha quality apply only to the CDROM's or all IDE devices? I have obtained the Walnut Creek 2.1.5 August 1996 CDROM set and am having problems trying to install it. I am on an all IDE system though. System is: ??? Motherboard w/PCI and VLB (UMC I think, but it doesn't say anywhere!) 32MEG Ram Conner 400Meg HD Seagate ST-1090A HD (75Meg) NEC (Oak) IDE CD-ROM SMC Ultra/16 Ethernet combo card 1.44M diskette 1.2M diskette SVGA Card w/1Meg Ram I start the install by booting from a boot floppy. I get through the config utility to the point where it starts to actually do work. It appears to make it through the newfs commands and fails when it goes to write the kernal to /STAND. Exact symptom varies a little, but centers around a message indicating that there is no kernal to write to the disk. At first I thought it was just because the CD-ROM is IDE. Then I went back and made a DOS partition and tried to install from that. This way, I get the same basic problem. Interestingly, I found different failures depending on which IDE drive the DOS partition was on and where in relation to the BSD partition (On the Conner drive) the DOS partition was (before or after the BSD partition). I am beginning to wonder if I missed an instruction to change CD's or if I just got a bad set of CD's??? If you have any ideas, I would like to know what to try next. If you would like me to test something in this configuration, I would be happy to give it a try. Michael Lay N5PTN Pflugerville, Texas
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?2.2.16.19970102003538.268f3d60>