Date: Thu, 06 Sep 2001 23:26:03 -0400 From: "Richard S. Conto" <rsc@merit.edu> To: Warner Losh <imp@harmony.village.org> Cc: Allen Landsidel <all@biosys.net>, stable@freebsd.org, rsc@merit.edu Subject: Re: latest pcic changes Message-ID: <20010907032603.7B9E15DD93@segue.merit.edu> In-Reply-To: Your message of "Thu, 06 Sep 2001 15:32:40 -0600." <200109062132.f86LWfh56504@harmony.village.org> References: <200109062132.f86LWfh56504@harmony.village.org>
next in thread | previous in thread | raw e-mail | index | archive | help
I've seen the similar behavior on a Dell Inspiron 3000, although no
spontaneous reboots after 45 minutes. (I was able to cvsup and makeworld
this morning, a process that went from 10:3 EDT to 16:45 EDT. The kernel
finished building this evening after I got it home.)
dmesg follows:
Copyright (c) 1992-2001 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.4-RC #0: Thu Sep 6 21:00:37 EDT 2001
root@x25.home:/usr/src/sys/compile/INSPIRION3K
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium/P55C (quarter-micron) (200.46-MHz 586-class CPU)
Origin = "GenuineIntel" Id = 0x581 Stepping = 1
Features=0x8001bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,MMX>
real memory = 150994944 (147456K bytes)
avail memory = 142471168 (139132K bytes)
Preloaded elf kernel "kernel" at 0xc043b000.
Intel Pentium detected, installing workaround for F00F bug
netsmb_dev: loaded
md0: Malloc disk
Using $PIR table, 3 entries at 0xc00fdf90
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
isab0: <Intel 82371AB PCI to ISA bridge> at device 1.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel PIIX4 ATA33 controller> port 0xfcf0-0xfcff at device 1.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
uhci0: <Intel 82371AB/EB (PIIX4) USB controller> at device 1.2 on pci0
uhci0: Could not map ports
device_probe_and_attach: uhci0 attach returned 6
chip1: <Intel 82371AB Power management controller> port 0x2180-0x218f at device 1.3 on pci0
pci0: <NeoMagic MagicGraph 128XD SVGA controller> at 2.0
pci_cfgintr_unique: hard-routed to irq 11
pci_cfgintr: ROUTE_INTERRUPT failed.
pcic0: <TI PCI-1131 PCI-CardBus Bridge> at device 4.0 on pci0
pcic0: PCI Memory allocated: 0x44000000
pci_cfgintr_unique: hard-routed to irq 11
pci_cfgintr: ROUTE_INTERRUPT failed.
pcic0: No PCI interrupt routed, trying ISA.
pcic0: Polling mode
pcic0: TI113X PCI Config Reg: [speaker enable][CSC serial isa irq]
pccard0: <PC Card bus (classic)> on pcic0
pci_cfgintr_linked: linked (61) to hard-routed irq 11
pci_cfgintr: 0:4 INTB routed to irq 11
pcic1: <TI PCI-1131 PCI-CardBus Bridge> irq 11 at device 4.1 on pci0
pcic1: PCI Memory allocated: 0x44001000
pcic1: TI113X PCI Config Reg: [speaker enable][CSC serial isa irq]
pccard1: <PC Card bus (classic)> on pcic1
orm0: <Option ROM> at iomem 0xc0000-0xcbfff on isa0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: parallel port not found.
IPv6 packet filtering initialized, default to accept, logging limited to 100 packets/entry
IP packet filtering initialized, divert disabled, rule-based forwarding enabled, default to accept, logging limited to 100 packets/entry by default
ad0: 6194MB <IBM-DBCA-206480> [13424/15/63] at ata0-master UDMA33
acd0: CDROM <TOSHIBA CD-ROM XM-1702BC> at ata1-master using PIO4
Mounting root from ufs:/dev/ad0s2a
pccard: card inserted, slot 0
pccard: card inserted, slot 1
ep0: <3Com Etherlink III 3C589> at port 0x240-0x24f irq 3 slot 0 on pccard0
ep0: Ethernet address 00:60:08:b1:4d:1c
sio2 at port 0x2f8-0x2ff irq 11 slot 1 on pccard1
sio2: type 16550A
sio2: unable to activate interrupt in fast mode - using normal mode
xfs: cdev: 128, syscall: 210
Richard S. Conto <rsc@merit.edu>
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-stable" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?20010907032603.7B9E15DD93>