Skip site navigation (1)Skip section navigation (2)
Date:      Thu, 25 Sep 2003 18:32:54 +0200 (CEST)
From:      (Philipp Westphal) <wasa@dark-waves.de>
To:        freebsd-current@freebsd.org
Subject:   panic ffs_blkfree
Message-ID:  <XFMail.20030925183254.wasa@dark-waves.de>

next in thread | raw e-mail | index | archive | help

[-- Attachment #1 --]

----------------------------------
E-Mail: (Philipp Westphal) <wasa@dark-waves.de>
Date: 25-Sep-2003
Time: 18:13:52

This message was sent by XFMail
----------------------------------

hallo, eveyone.

my current (i cvsuped and build today) works fine, as long as
acces to my second hd is low.
if not:

------
dev=/dev/ad1s1e, block=1, fs=\Archiv\2
panic=ffs_blkfree: freeing free block
Debugger("panic")
Stopped at Debugger x0x4d xchgl %ebx, in Debugger.0
db>
-----

someone knows about that?

oh, hardware:


\dev\ad1 is a mxtor 120GB S-AtA drive conected to an 
Silicon Image Sil3112(a) SAtA. %~/

ad0 is an IBM 13Gb (UDMA 66) Disk (working fine!!, no probs) at 
an NForce 2.

kerneloutput is attached

cu


[-- Attachment #2 --]
Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD 5.1-CURRENT #0: Thu Sep 25 14:37:18 CEST 2003
    root@blacky.local:/usr/obj/usr/src/sys/BLACKY
Preloaded elf kernel "/boot/kernel/kernel" at 0xc052b000.
Preloaded elf module "/boot/kernel/acpi.ko" at 0xc052b244.
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: AMD Athlon(tm) XP 2800+ (2088.08-MHz 686-class CPU)
  Origin = "AuthenticAMD"  Id = 0x6a0  Stepping = 0
  Features=0x383fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
  AMD Features=0xc0400000<AMIE,DSP,3DNow!>
real memory  = 1073676288 (1023 MB)
avail memory = 1037516800 (989 MB)
Pentium Pro MTRR support enabled
npx0: [FAST]
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <Nvidia AWRDACPI> on motherboard
pcibios: BIOS version 2.10
Using $PIR table, 13 entries at 0xc00fde90
acpi0: Power Button (fixed)
Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x4008-0x400b on acpi0
acpi_cpu0: <CPU> port 0x530-0x537 on acpi0
acpi_tz0: <thermal zone> port 0x530-0x537 on acpi0
acpi_button0: <Power Button> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
pcib0: slot 2 INTA is routed to irq 5
pcib0: slot 2 INTB is routed to irq 11
pcib0: slot 2 INTC is routed to irq 5
pcib0: slot 4 INTA is routed to irq 11
pcib0: slot 6 INTA is routed to irq 5
agp0: <NVIDIA nForce2 AGP Controller> mem 0xe0000000-0xe3ffffff at device 0.0 on pci0
pci0: <memory, RAM> at device 0.1 (no driver attached)
pci0: <memory, RAM> at device 0.2 (no driver attached)
pci0: <memory, RAM> at device 0.3 (no driver attached)
pci0: <memory, RAM> at device 0.4 (no driver attached)
pci0: <memory, RAM> at device 0.5 (no driver attached)
isab0: <PCI-ISA bridge> at device 1.0 on pci0
isa0: <ISA bus> on isab0
pci0: <serial bus, SMBus> at device 1.1 (no driver attached)
ohci0: <OHCI (generic) USB controller> mem 0xea003000-0xea003fff irq 5 at device 2.0 on pci0
usb0: OHCI version 1.0, legacy support
usb0: <OHCI (generic) USB controller> on ohci0
usb0: USB revision 1.0
uhub0: (0x10de) OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 3 ports with 3 removable, self powered
uhub0: device problem, disabling port 2
ohci1: <OHCI (generic) USB controller> mem 0xea004000-0xea004fff irq 11 at device 2.1 on pci0
usb1: OHCI version 1.0, legacy support
usb1: <OHCI (generic) USB controller> on ohci1
usb1: USB revision 1.0
uhub1: (0x10de) OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 3 ports with 3 removable, self powered
pci0: <serial bus, USB> at device 2.2 (no driver attached)
pci0: <network, ethernet> at device 4.0 (no driver attached)
pcm0: <Nvidia nForce2> port 0xb800-0xb87f,0xb400-0xb4ff mem 0xea001000-0xea001fff irq 5 at device 6.0 on pci0
pcm0: <C-Media Electronics CMI9739 AC97 Codec>
pcib1: <ACPI PCI-PCI bridge> at device 8.0 on pci0
pci1: <ACPI PCI bus> on pcib1
pcib1: slot 11 INTA is routed to irq 5
pcib1: slot 12 INTA is routed to irq 11
pcib1: slot 13 INTA is routed to irq 11
rl0: <RealTek 8139 10/100BaseTX> port 0x9000-0x90ff mem 0xe9081000-0xe90810ff irq 5 at device 11.0 on pci1
rl0: Ethernet address: 00:04:61:4b:22:60
miibus0: <MII bus> on rl0
rlphy0: <RealTek internal media interface> on miibus0
rlphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
atapci0: <SiI 3112 SATA150 controller> port 0xa400-0xa40f,0xa000-0xa003,0x9c00-0x9c07,0x9800-0x9803,0x9400-0x9407 mem 0xe9080000-0xe90801ff irq 11 at device 12.0 on pci1
atapci0: [MPSAFE]
ata2: at 0xe9080000 on atapci0
ata2: [MPSAFE]
ata3: at 0xe9080000 on atapci0
ata3: [MPSAFE]
fwohci0: <Lucent FW322/323> mem 0xe9082000-0xe9082fff irq 11 at device 13.0 on pci1
fwohci0: [MPSAFE]
fwohci0: OHCI version 1.0 (ROM=1)
fwohci0: No. of Isochronous channel is 8.
fwohci0: EUI64 00:04:61:00:00:04:51:81
fwohci0: Phy 1394a available S400, 3 ports.
fwohci0: Link S400, max_rec 2048 bytes.
firewire0: <IEEE1394(FireWire) bus> on fwohci0
if_fwe0: <Ethernet over FireWire> on firewire0
if_fwe0: Fake Ethernet address: 02:04:61:04:51:81
sbp0: <SBP2/SCSI over firewire> on firewire0
fwohci0: Initiate bus reset
fwohci0: BUS reset
fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode
firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me)
firewire0: bus manager 0 (me)
atapci1: <nVidia nForce2 UDMA133 controller> port 0xf000-0xf00f at device 9.0 on pci0
ata0: at 0x1f0 irq 14 on atapci1
ata0: [MPSAFE]
ata1: at 0x170 irq 15 on atapci1
ata1: [MPSAFE]
pcib2: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci2: <ACPI PCI bus> on pcib2
pcib2: slot 0 INTA is routed to irq 5
drm0: <Matrox G550 (AGP)> mem 0xe7000000-0xe77fffff,0xe6000000-0xe6003fff,0xe4000000-0xe5ffffff irq 5 at device 0.0 on pci2
info: [drm] AGP at 0xe0000000 64MB
info: [drm] Initialized mga 3.1.0 20021029 on minor 0
fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on acpi0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
sio0 port 0x3f8-0x3ff irq 4 on acpi0
sio0: type 16550A
sio1 port 0x2f8-0x2ff irq 3 on acpi0
sio1: type 16550A
ppc0 port 0x778-0x77b,0x378-0x37f irq 7 on acpi0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
ppbus0: <Parallel port bus> on ppc0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
orm0: <Option ROMs> at iomem 0xcc000-0xd07ff,0xc0000-0xc8fff on isa0
pmtimer0 on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounter "TSC" frequency 2088083331 Hz quality 800
Timecounters tick every 10.000 msec
acpi_cpu: throttling enabled, 2 steps (100% to 50.0%), currently 100.0%
GEOM: create disk ad0 dp=0xc63b9870
ad0: 12949MB <IBM-DJNA-371350> [26310/16/63] at ata0-master UDMA66
acd0: DVDROM <TOSHIBA DVD-ROM SD-M1712> at ata1-master PIO4
acd1: WARNING - SETFEATURES recovered from missing interrupt
acd1: CDRW <SONY CD-RW CRX220E1> at ata1-slave PIO4
GEOM: create disk ad1 dp=0xc63ce470
ad1: 117246MB <Maxtor 6Y120M0> [238216/16/63] at ata2-master UDMA133
Mounting root from ufs:/dev/ad0s1a
WARNING: / was not properly dismounted
WARNING: /home was not properly dismounted
WARNING: /tmp was not properly dismounted
WARNING: /usr was not properly dismounted
WARNING: /var was not properly dismounted
/var: mount pending error: blocks 576 files 1
WARNING: /Archiv/1 was not properly dismounted
WARNING: /Archiv/2 was not properly dismounted
WARNING: /Archiv/3 was not properly dismounted
lock order reversal
 1st 0xc66c4250 vm object (vm object) @ /usr/src/sys/vm/vm_object.c:433
 2nd 0xc082f110 system map (system map) @ /usr/src/sys/vm/vm_kern.c:328
Stack backtrace:
drm0: [MPSAFE]

Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?XFMail.20030925183254.wasa>