Date: Mon, 27 Oct 2003 15:35:37 -0500 From: Clint Gilders <techservices@onlinehobbyist.com> To: freebsd-stable@freebsd.org Subject: Boot of Dell 1750 fails with multiple SCSI drives installed Message-ID: <3F9D8199.1030306@onlinehobbyist.com>
next in thread | raw e-mail | index | archive | help
Hi All We have a brand new Dell Power Edge 1750 with an LSILogic 1030 Ultra 4 SCSI Adapter and 2 x 73 GB harddrives. I did not do the install because I am about 1000 miles form our co-location facility, but here is the information I have on the problems seen by the tech doing the install. With the two factory installed drives attached the system will not boot from the install CD. If the second drive is disconnected the system can be installed, but again will not boot if the second drive is connected. The system is running 4.9-RC with an SMP kernel. 4.8 gave the same results. This is what's logged with one or two drives: Oct 27 10:30:26 king7 /kernel: mpt0: <LSILogic 1030 Ultra4 Adapter> port 0xcc00-0xccff mem 0xfcd20000-0xfcd2ffff,0xfcd30000-0xfcd3ffff irq 7 at device 5.0 on pci4 Oct 27 10:30:26 king7 /kernel: mpt1: <LSILogic 1030 Ultra4 Adapter> port 0xc800-0xc8ff mem 0xfcd00000-0xfcd0ffff,0xfcd10000-0xfcd1ffff irq 13 at device 5.1 on pci4 Oct 27 10:30:26 king7 /kernel: Waiting 15 seconds for SCSI devices to settle Oct 27 10:30:26 king7 /kernel: pass1 at mpt0 bus 0 target 6 lun 0 Oct 27 10:30:26 king7 /kernel: pass1: <PE/PV 1x3 SCSI BP 1.1> Fixed Processor SCSI-2 device Oct 27 10:30:26 king7 /kernel: pass1: 3.300MB/s transfers Oct 27 10:30:26 king7 /kernel: da0 at mpt0 bus 0 target 0 lun 0 Oct 27 10:30:26 king7 /kernel: da0: <IBM IC35L073UCDY10-0 S27F> Fixed Direct Access SCSI-3 device Oct 27 10:30:26 king7 /kernel: da0: 320.000MB/s transfers (160.000MHz, offset 127, 16bit), Tagged Queueing Enabled Oct 27 10:30:26 king7 /kernel: da0: 70007MB (143374650 512 byte sectors: 255H 63S/T 8924C) Oct 27 10:30:26 king7 /kernel: Mounting root from ufs:/dev/da0s1a When there are two drives the machine hangs at this point and prints the following error message to the console: MPT0: time out on request sequence: sequence = 0xFD Anyone else have this problem with FreeBSD? Is there a workaround? Need more info? Thanks -- Clint Gilders <techservices@onlinehobbyist.com> Director of Technology Services OnlineHobbyist.com, Inc.
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?3F9D8199.1030306>