Date: Sun, 7 Nov 1999 18:19:51 +0100 From: German Tischler <tanis@gaspode.franken.de> To: "D. Rock" <rock@dead-end.net> Cc: freebsd-current@FreeBSD.ORG Subject: Re: Dr Neuhaus niccy go not recognized Message-ID: <19991107181951.A11877@gaspode.franken.de> In-Reply-To: <38259463.FDEA7F45@dead-end.net>; from D. Rock on Sun, Nov 07, 1999 at 04:01:55PM %2B0100 References: <19991107130146.2B72E38E2@hcswork.hcs.de> <38259463.FDEA7F45@dead-end.net>
next in thread | previous in thread | raw e-mail | index | archive | help
On Sun, Nov 07, 1999 at 04:01:55PM +0100, D. Rock wrote: > Any hints when i4b will be converted to new-bus? The code is in stale > condition for almost 3 months now. > > To the original poster: > > I also have an ISDN PnP card (SedlBauer WinSpeed). In order to get it > run on -current, I did the following: There is already code for the SedlBauer (and I know it works because I have one.) Check out the url I mentioned on i4b-dev. > One note: The device doesn't get reset properly during reboot. I don't know > if this a general problem with the driver or just a result from my hacks. > If I reboot I have to manually turn off/on the machine. I have never seen this behaviour here, neither before nor after the conversion. You cannot expect the card to be reset, if you remove the reset code (which is normally in the attach routine). -- German Tischler, tanis@gaspode.franken.de To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-current" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?19991107181951.A11877>