Date: Wed, 22 Nov 2000 21:14:43 -0600 From: Drew Sanford <drew@planetwe.com> To: "Jeffrey J. Mountin" <jeff-ml@mountin.net> Cc: stable@FreeBSD.ORG Subject: Re: 4.2 RELEASE - Install hangs during boot Message-ID: <3A1C8BA3.6080003@planetwe.com> References: <4.3.2.20001122201959.00cadd40@207.227.119.2>
next in thread | previous in thread | raw e-mail | index | archive | help
Assuming this works as you say it will, can I switch back to the ATA100 port and expect it to work after the install? Jeffrey J. Mountin wrote: > At 08:04 PM 11/22/00 -0600, Drew Sanford wrote: > >> I have a system (brand new, clean, never previously had anything >> installed on it) on which 4.2 hangs during the boot sequence when I >> try to install. The system is : >> >> Asus A7V MB >> Matrox G400 dual head >> IBM 45GB ATA100 Deskstar as primary master on the Promise ATA100 >> controler >> CD rom drive as primary slave on the Primary IDE port >> CPU: Duron 800 >> 256 MB PC133 ram >> SB Live >> Netgear FA310TX rev D2 >> >> The ATA100 controller is detected, the hang point is always with the >> last line as: >> >> plip0: <PLIP network interface> on ppbus0 > > > Right where the drives should show up. > >> I will continue to poke and prod and see if I can figure this out. If >> anyone has a solution, please let me know. > > > Try installing from the ATA-66 port. That I know works. > > > Jeff Mountin - jeff@mountin.net > Systems/Network Administrator > FreeBSD - the power to serve > > > > To Unsubscribe: send mail to majordomo@FreeBSD.org > with "unsubscribe freebsd-stable" in the body of the message -- Drew Sanford Systems Administrator drew@planetwe.com http://www.planetwe.com To Unsubscribe: send mail to majordomo@FreeBSD.org with "unsubscribe freebsd-stable" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?3A1C8BA3.6080003>