Date: Fri, 20 Dec 2002 15:03:00 -0500 (EST) From: Garrett Wollman <wollman@lcs.mit.edu> To: alpha@FreeBSD.org Subject: Make of it what you will... Message-ID: <200212202003.gBKK30Jh082617@khavrinen.lcs.mit.edu>
next in thread | raw e-mail | index | archive | help
Yesterday I successfully installed 5.0-RC1 on a four-processor
AS4100. Overnight I tried a `make -j 8 -s buildworld', but it wasn't
even remotely close to completing after nine hours (probably due to
contention for giant, if what I saw in `top' is any indication). I
restarted the build without `-j' and things seem to be getting pretty
close to completion. Congratulations are due to everybody involved in
making this weird hardware behave reliably....
For the record, here's what this machine looks like:
Copyright (c) 1992-2002 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 5.0-RC1 #0: Sat Dec 7 07:38:26 GMT 2002
root@sema.baldwin.cx:/usr/obj/usr/src/sys/GENERIC
Preloaded elf kernel "/boot/kernel/kernel" at 0xfffffc000086a000.
AlphaServer 4100
AlphaServer 4100 5/466 4MB, 467MHz
8192 byte page size, 4 processors.
CPU: EV56 (21164A) major=7 minor=2 extensions=0x1<BWX>
OSF PAL rev: 0x4000200020117
real memory = 2145345536 (2045 MB)
avail memory = 2081038336 (1984 MB)
FreeBSD/SMP: Multiprocessor System Detected: 4 CPUs
Initializing GEOMetry subsystem
mcbus0: <MCBUS Backplane Bus>
pcib0: <MCPCIA PCI Adapter> at mcbus0 gid 7 mid 5
pcib0: Horse Revision 3, Left Handed Saddle Revision 3, CAP Revision 2
pci0: <PCI bus> on pcib0
sym0: <810> port 0x1ffee00-0x1ffeeff mem 0x7dffe00-0x7dffeff irq 4 at device 1.0 on pci0
sym0: No NVRAM, ID 7, Fast-10, SE, parity checking
sym0: interrupting at IRQ 0x10 intA (vec 0xb40)
pcib2: <PCI-PCI bridge> at device 2.0 on pci0
pci2: <PCI bus> on pcib2
isp0: <Qlogic ISP 1020/1040 PCI SCSI Adapter> port 0x1ffff00-0x1ffffff mem 0x7eef000-0x7eeffff irq 8 at device 0.0 on pci2
isp0: interrupting at IRQ 0x0 intA (vec 0xb80)
de0: <Digital 21140A Fast Ethernet> port 0x1ffef00-0x1ffef7f mem 0x7dfff00-0x7dfff7f irq 12 at device 3.0 on pci0
de0: interrupting at IRQ 0x4 intA (vec 0xbc0)
de0: DEC DE500-AA 21140A [10-100Mb/s] pass 2.0
de0: address 00:00:f8:05:bc:8b
pcib1: <MCPCIA PCI Adapter> at mcbus0 gid 7 mid 4
pcib1: Horse Revision 3, Left Handed Saddle Revision 3, CAP Revision 2
pci1: <PCI bus> on pcib1
eisab0: <PCI-EISA bridge> at device 1.0 on pci1
isa0: <ISA bus> on eisab0
pci1: <unknown> at device 3.0 (no driver attached)
mlx0: <Mylex version 2 RAID interface> port 0x1ffff00-0x1ffff7f mem 0x3fe7f00-0x3fe7f7f irq 16 at device 4.0 on pci1
mlx0: interrupting at IRQ 0x8 intA (vec 0xa00)
mlx0: DAC960P/PD, 3 channels, firmware 2.42-0-00, 8MB RAM
mlxd0: <Mylex System Drive> on mlx0
mlxd0: 20455MB (41891840 sectors) RAID 0 (offline)
mlxd1: <Mylex System Drive> on mlx0
mlxd1: 4091MB (8378368 sectors) RAID 7 (offline)
ata0 at port 0x3f6,0x1f0-0x1f7 irq 14 on isa0
ata0: interrupting at ISA irq 14
ata1 at port 0x376,0x170-0x177 irq 15 on isa0
ata1: interrupting at ISA irq 15
atkbdc0: <Keyboard controller (i8042)> at port 0x64,0x60 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
atkbd0: interrupting at ISA irq 1
fdc0: <Enhanced floppy controller (i82077, NE72065 or clone)> at port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on isa0
fdc0: interrupting at ISA irq 6
mcclock0: <MC146818A real time clock> at port 0x70-0x71 on isa0
ppc0: <Parallel port> at port 0x3bc-0x3c3 irq 7 on isa0
+ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
lpt0: <Printer> on ppbus0
lpt0: Polled port
ppi0: <Parallel I/O> on ppbus0
ppc0: interrupting at ISA irq 7
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x0>
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0: port may not be enabled
sio0 at port 0x3f8-0x3ff irq 4 on isa0
sio0: type 16550A, console
sio0: interrupting at ISA irq 4
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
sio1: interrupting at ISA irq 3
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounters tick every 0.833 msec
Timecounter "i8254" frequency 1193182 Hz
Waiting 15 seconds for SCSI devices to settle
de0: enabling 10baseT port
da1 at isp0 bus 0 target 2 lun 0
da1: <DEC RZ1CB-CA (C) DEC LYJ0> Fixed Direct Access SCSI-2 device
da1: 20.000MB/s transfers (10.000MHz, offset 12, 16bit), Tagged Queueing Enabled
da1: 4091MB (8380080 512 byte sectors: 255H 63S/T 521C)
da0 at isp0 bus 0 target 0 lun 0
da0: <IBM DNES-309170Y SA60> Fixed Direct Access SCSI-3 device
da0: 20.000MB/s transfers (10.000MHz, offset 12, 16bit), Tagged Queueing Enabled
da0: 8683MB (17783301 512 byte sectors: 255H 63S/T 1106C)
cd0 at sym0 bus 0 target 5 lun 0
cd0: <DEC RRD46 (C) DEC 0557> Removable CD-ROM SCSI-2 device
cd0: 10.000MB/s transfers (10.000MHz, offset 8)
cd0: Attempt to query device size failed: NOT READY, Medium not present
SMP: AP CPU #2 Launched!
SMP: AP CPU #3 Launched!
SMP: AP CPU #1 Launched!
Mounting root from ufs:/dev/da0a
calcru: negative time of 69761 usec for pid 54269 (install)
de0: abnormal interrupt: transmit underflow (raising TX threshold to 96|256)
de0: abnormal interrupt: transmit underflow (raising TX threshold to 128|512)
de0: abnormal interrupt: transmit underflow (raising TX threshold to 160|1024)
mlx0: command failed - rebuild successfully terminated
[There are no disks actually hooked up to the Mylex controller and
I'll delete it from the kernel when I build a custom config for this
machine.]
If anybody wants some used Memory Channel cards, I'd be happy to let
go of them....
-GAWollman
To Unsubscribe: send mail to majordomo@FreeBSD.org
with "unsubscribe freebsd-alpha" in the body of the message
Want to link to this message? Use this URL: <https://mail-archive.FreeBSD.org/cgi/mid.cgi?200212202003.gBKK30Jh082617>